Products

Seat Belt Stalk Receiver Front Left Hand Seat.For Defender to VIN: VA138479 1997 MY. OEM.

Seat Belt Stalk Receiver Front Right Hand Seat.For Defender to VIN: VA138479 1997 MY. OEM.

Seat Box Corner Black Protectors Pair Series/Defender.These will fit a Series 2 or 3 but will require matching drilling to accommodate seat rail fi...

Seat Box Corner Black Steel Protectors PairFor Series or Defender.Yes...These are Steel, Not Plastic.

Seat Box End Repair Panel Aluminum Left HandSeries 2-3 and Defender

Seat Box End Repair Panel Aluminum Right HandSeries 2-3 and Defender

Seat Box Hasp for Locker Lid Series 2-3 1958-84 Short Hasp

Seat Box Repair Back Angle (Blank No Holes) for Defender and Series 2 to 3.

Seat Box Repair Rear Angle Piece With Holes for Series 2-3.

Seat Cushion for Rear Bench Seat 810mm Wide Black Vinyl For Seat Back Cushion, see TS-320647 For Full Seat with Cushions, see TS-320737

Seat for Gear Lever 1949-84 Series 1-3

Seat Frame for Adjustable Seat Rails. For Series 2a/3 and Early Military Defenders. Note: Special Order Item, ships to you in 2 to 3 weeks.

Seatbelt Anchor Bracket Chassis Mount Galvanized.For Series 3. Mounts on the chassis under the tub,

Seatbelt Anchor Bracket Rear Tub Galvanized.For Series 2a 88". Typically 2 or 4 are installed. Support Brackets for the seat belts mounted inside t...

Securon 3-Point Static Shoulder BeltFits Left or Right Hand. For Series 1-3.Note: This is a Shoulder Belt requiring the Upper Mount in Hard Tops, T...

Securon Seat Belt Front Outer or Center Lap or Rear Bench, Static.For Series or Defender.

Securon Seat Belt Kit 3-Point Reel, Buckle and Hardware.For Left or Right Hand. Series 2-3 or DefenderNote: This is a Shoulder Belt requiring the U...

Securon Seat Belt Kit Left or Right Hand 3-Position Reel, Buckle and Hardware.Fits Series 2 to 3 and early Defender.Seat Belt has a 3 Point Inertia...

Securon Seat Belt Lap Center or Rear Bench Seat, Retractable.For Series 1-3 or Defender.

Selector Shaft for 1st and 2nd Gears.For Series 3 Synchromesh Gearbox, (1971-1984).Superseded Part Number GT-FRC5897.

Selector Shaft for Reverse Gear 1948-71, Series 1-2a.Land Rover Genuine, New Old Stock.

Sender Unit for Rear Fuel Tank Defender 110 NAS 3.9L EFI V8 Land Rover Genuine.Last One... Can't get these anymore!Note: To Install, you may requir...

Water Temperature Sender/Transmitter on Inlet Manifold.For 3.5L V8 Range Rover Classic 1987-89.

Crank Position Sensor 4.0/4.6L V8 Automatic.For Discovery 2 1999-04, Range Rover P38 1999-02.If your engine suddenly stops as though someone just t...