New Parts Added weekly
We are in the process of adding our entire inventory. Thanks for your patience!
We are in the process of adding our entire inventory. Thanks for your patience!
Below you will find all our Series 1 interior parts including seats, seatbelts, interior trim, grab handles, door cards, and headliners. If it goes on inside a Series 1, this is where you'll find it.
Glue-On Finger Pull for Sliding Glass in Door Top For Series 2-3, 1958-84 You provide the glue...
Transfer/Low Range Lever Grommet (Boot) Series 1-3 1953-84
Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.
Battery Hold-Down J-Clamp Kit
Rubber Buffer for Seat Back, Door Check and Side Steps (54-84).
Set of 3 Replacement Rubber Grommets for Series 1 1953-58. Handbrake, Gear, and Transfer Lever. Note: Handbrake has a Round Hole for Round Shaft an...
View full detailsSeries 1 LHD Footwell Panels Repair Kit 1954-58 Pair
Handbrake Lever Grommet (Boot) for Series 1, 1953-58.Note: Hole for Handbrake Lever is Round and Grommet is longer than later Series 2 to 3.
Knob for Transfer Lever (Red) Series 1-3 1953-84
Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84
Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed EndPackage of 10
Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed EndFor a Package of 10, see RV-78248-10
Strap for Rear Seat Cushion Series Bench Seats
Stud for Seat Strap ss:348430 & Various Uses OEM Notes: Uses Bolt:FS-78120, Lock:FS-WM702001L, Nut:FS-RTC608. Strap pn TS-331974. Also used for...
View full detailsSeat Back for Rear Bench Seat 810mm Wide Black Vinyl For Seat Bottom Cushion, see TS-320674 For Full Seat with Cushions, see TS-320737
Seat Cushion for Rear Bench Seat 810mm Wide Black Vinyl For Seat Back Cushion, see TS-320647 For Full Seat with Cushions, see TS-320737
Spare Tire Clamp Retainer & Fastener Kit. For Series 1-3 88" and 109" Regular/Pick-Up Rear Tubs. In behind the front seats.
Exmoor Canvas Bulkhead Storage with Tool Roll - Sand
Exmoor Trim Side Panel Storage Bag in Sand Canvas. For Series or Defender Rear Side Panels. Fits LH or RH Side
Nut Plate for Roof 90/110 or Bench Seat Belts Series1-3
Turnbuckle for Seat Base Locker Lids Series1-3
Spring Clip for Tools behind Front Seats Series 1-3. You'll need two rivets for installation as well. RV-78248 x2
Blanking Plug Rubber for Tunnel Cover Series/Def & Var. Uses
Seat Belt Floor Nut Plate for Mounting Seat Belts Front or Rear