New Parts Added weekly
We are in the process of adding our entire inventory. Thanks for your patience!
We are in the process of adding our entire inventory. Thanks for your patience!
Pilot Bushing for Flywheel and Transfer Output Shaft Series 1-3, 1948 through to end of TD5, Defender, Discovery 2 Supersedes 8566L, 234534.
Set of 3 Replacement Rubber Grommets for Series 2a-3 1967-84. Handbrake, Gear, and Transfer Lever. Handbrake has Oval Hole. This set can work for e...
View full detailsCopper Washer Solid Drain Plug GB TrsfrCase Fuel Tank Diffs
Gearbox and Transfer Case Gasket Set - Series 1-3 1948-84
Gearbox and Transfer Case Gasket and Seal Kit For Series 2a 1961-71 Gasket Set with all Seals required for a full tear-down and rebuild. Includes F...
View full detailsOil Seal for Speedometer Pinion in Gearbox S1-3
Collar for Under Spring of 4WD Lever Series 1-3 You are Purchasing 1, not 5 as shown in the photo.
Transfer/Low Range Lever Grommet (Boot) Series 1-3 1953-84
Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.
Blanking Plug/Grommet for Bell HousingSeries 1, 2 and 2a to 1963
Set of 3 Replacement Rubber Grommets for Series 1 1953-58. Handbrake, Gear, and Transfer Lever. Note: Handbrake has a Round Hole for Round Shaft an...
View full detailsMainshaft Bushing for 2nd Gear For Series 1-3 (This is 1 half of a two piece bushing, used with GT-FRC4077) For the original 1 Piece Bushing, see G...
View full detailsClevis Assembly with Screw and Spring 4WD Lever 1950-84
Circlip for Gear Lever Series 1-3 1949-84
Spring Clip for Transfer Gear Change Lever Series 1-3 1954-84
O-Ring Seal for Forward Gear Selector Shafts 1955-84
Locating Pin for Main Gear Lever Series 2-3
Shim Washer for Rear of Mainshaft 1948-84
O-Ring Seal for Reverse Gear Selector Shaft '55-84 (272597)
Rubber Gaitor for Overdrive Lever Series 1-3 Fairey/Global Rmr
O-Ring Seal for Hi-Lo Transfer Selector Shaft S2-3 & other
Oil Seal, Front or Rear Output Shaft, Corteco (OEM) Series 1-3, 1948-84. Every. Single. Series.
Handbrake Grommet (Boot) Late Series 2a and Series 3, 1967-84.Hole is Oval Shaped for Handbrake Lever.Can work on Series 2 to 2A models, 1958-66, b...
View full detailsKnob for Transfer Lever (Red) Series 1-3 1953-84