New Parts Added weekly
We are in the process of adding our entire inventory. Thanks for your patience!
We are in the process of adding our entire inventory. Thanks for your patience!
Pilot Bushing for Flywheel and Transfer Output Shaft Series 1-3, 1948 through to end of TD5, Defender, Discovery 2 Supersedes 8566L, 234534.
Copper Washer Solid Drain Plug GB TrsfrCase Fuel Tank Diffs
Gearbox and Transfer Case Gasket Set - Series 1-3 1948-84
Oil Seal for Speedometer Pinion in Gearbox S1-3
Collar for Under Spring of 4WD Lever Series 1-3 You are Purchasing 1, not 5 as shown in the photo.
Transfer/Low Range Lever Grommet (Boot) Series 1-3 1953-84
Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.
Blanking Plug/Grommet for Bell HousingSeries 1, 2 and 2a to 1963
Mainshaft Bushing for 2nd Gear For Series 1-3 (This is 1 half of a two piece bushing, used with GT-FRC4077) For the original 1 Piece Bushing, see G...
View full detailsSet of 3 Replacement Rubber Grommets for Series 1 1953-58. Handbrake, Gear, and Transfer Lever. Note: Handbrake has a Round Hole for Round Shaft an...
View full detailsClevis Assembly with Screw and Spring 4WD Lever 1950-84
Circlip for Gear Lever Series 1-3 1949-84
Spring Clip for Transfer Gear Change Lever Series 1-3 1954-84
O-Ring Seal for Forward Gear Selector Shafts 1955-84
Shim Washer for Rear of Mainshaft 1948-84
O-Ring Seal for Reverse Gear Selector Shaft '55-84 (272597)
Rubber Gaitor for Overdrive Lever Series 1-3 Fairey/Global Rmr
Oil Seal, Front or Rear Output Shaft, Corteco (OEM) Series 1-3, 1948-84. Every. Single. Series.
Handbrake Lever Grommet (Boot) for Series 1, 1953-58.Note: Hole for Handbrake Lever is Round and Grommet is longer than later Series 2 to 3.
Knob for Transfer Lever (Red) Series 1-3 1953-84
Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84
Grommet for Bell Housing Clutch ShaftSeries 1-2a 1952-67 Up to Gearbox Suffix D April 1967. Can use BG-553262 as a lower cost alternative, (shaft h...
View full detailsGearbox Mounting Rubber with Nuts.Series 1 from 1954 to 1958 and Series 2/2a/3 from 1958 up through 1984.
Stud for Gearbox Brackets on Transfer Case Series 1-3 7/16" Whitworth and 7/16" BSF. Requires Nut BN-2096.