Products

Cable for Heater Air Distribution Upper/Lower Control.For Defender from VIN: 1A616952, 2001 on.For Earlier see HS-BTR8736 (linked below).

Cable for Heater Air Distribution Upper/Lower Control.For Series 3 and Defender up to VIN: 1A616951, 2001.For the later cable, see HS-JFF000120 (li...

Cable for Tailgate Retention Defender 90/110/130 Reg/HiCap

Caliper Front LH Solid Rotors 90 1991on, 110 1986-93

Caliper Front RH Solid Rotors 90 1991on, 110 1986-93

Caliper Guide Pin Kit for Front (Axle Set) on D2, RR P38

Caliper Repair Kit Pistons/Seals Front 90 from 1990, 110 from 1986

Camshaft for Series 1-2a, 2.0L Diesel and Series 2a-3, 2.25L Diesel up to 1983,

Camshaft Bearing Front for 4 Cylinder Engines, 1958-98, OEM.For 2.0L Diesel, 2.25L Gas or Diesel, 2.5NA, 2.5TD, 200Tdi and 300Tdi.Un-Split Ring Sty...

Camshaft Bearing Rear 4 Cylinder Engines, 1958-98, OEM.<.p>For 2.0L Diesel, 2.25L Gas or Diesel, 2.5NA, 2.5TD, 200Tdi and 300Tdi.Un-Split Rin...

Camshaft Bearing Set 3.5/3.9/4.2L V8 90/110,D1,RRC,109V8

Camshaft bearing set 4-Cyinder, OEM, 1958-98. For 2.0L diesel, 2.25L gas or diesel, 2.5NA, 2.5TD, 200Tdi and 300Tdi. These should be reamed, (or li...

CamShaft for 2.25L 3-Bearing Gas Engines.For Series and Defender up to 1983.For the Later Camshaft for the 5-Bearing Engine see EP-ETC7128 (linked ...

Camshaft for 300Tdi Defender, Discovery 1, and Range Rover Classic. OEM. SPECIAL ORDER: Please note this item is special order and there will be a ...

Camshaft for Late Series 3 2.25L 5-Bearing Engines and Defender 2.25/2.5G, 2.5NA/TD, 200Tdi

110 2 Door Full Canvas Hood. SPECIAL ORDER: Please note this item is special order and there will be a substantial passage of time between ordering...

Cap for Clutch Release Pivot Pin for R380 TD5 & V8

Cap for Coolant Expansion Tank TD5.For Defender and Discovery 2 with the TD5.

Cap for Coolant Expansion Tank.Fits Defender 200Tdi and 300Tdi, Discovery 1 V8 and MPI, and Range Rover Classic V8.Note: For use on Tank EC-PCF1015...

Cap for Power Steering Reservoir, All Defenders. Anodized Aluminum / Includes Rubber Seal / Standard fitment.

Cap for Front Wiper Arm Defender 2002-2016.

Cap for Pivot on Clutch Release on Series 3

Cap for Radiator Overflow Expansion Bottle.<>p>Series 2a-3, 1967-84.

Cap for Valve Stem 2.5G, 2.5NA, 2.5TD, 200/300Tdi You are purchasing 1, not 10 as shown in the photo.

Capless T10 Bulb 12V 2W for Instrument Panel Defender OEM. Used in gauges and some speedometers.  For the Td5 speedo, you'd need LB-YAJ100370 inste...

Capping Bottom Corner for Seat Cushions OEM.For Series 2-3 and Defender Standard Seat Cushions.

Captive Nut Door Hinge to Bulkhead.For Defender from 1999.OEM. These are Metric 8mm Thread. For the earlier, up to 1998, UNF Captive Nuts, see DP-M...

Captive Nut Door Hinge to BulkheadFor Series 3 and Defender up to 1998, and earlier bulkheads repaired with New Door Posts.OEM. These are UNF Threa...

Captive Nut for Defender Seatbase, Sill Channel, and other uses. 6mm Nut.Supersedes FS-NK106081.

Captive Nut for Defender Air Intake, early Defender Rear Door Trim and Various Uses OEM5 Required for BP-BTR6188 Side Air Intake Grill.

Carburetor Linkage Ball Joint for Series 1 Solex 32PBI 1948-58Note: 1/4" BSF Male and 1/4" BSF Female ends.Requires BN-3819 1/4" BSF Nut for Lockin...

Carburetor Needle for Stromberg Carb B1FH (4104), Needle TypeFor all V8 Gas w/Stromberg Carbs 26D, 27D and 30D to 1624 97.RRC, 2 Required, For Engi...

Carburetor Zenith 361V Replacement Series 2a-3 2.25L April 1967 to 1984.Note: To replace a Solex Carb on an earlier 2 or 2a, you are going to need ...

Carpet Retainer Rear of Seatbox Series and Defender 4 or 5 Door Station Wagon. Center Piece. See TS-396541 for the Left or Right Hand Retainer.

Carpet Retainer Rear of Seatbox Series and Defender 4 or 5 Door Station Wagon. Fits Left or Right Hand Side. 2 Required. See TS-396542 for Center R...

Carpet Stud Black for RRC, 90/110 Door Panel Stud to '88

Casing for Water Pump 2.25L Gas or Diesel 9-Hole Series 2a-3, (1961-84).Land Rover Genuine New Old Stock. This is Only the Cast Casing.

Castle Nut for Front of Layshaft Series 2a 1964-71 3/4" UNF

Castle Nut for Halfshaft, Output Shaft and Differential Pinion.Requires Cotter Pin AD-PS608101L and Flat Washer AD-571922.

Castrol Baseball Cap Green with Embroidered Castrol Logo

Castrol Classic EP90 API GL4 Extreme Pressure Gear Oil 1Litre.Finally! The Right GL4 Gear Oil for your Landie!For Series 1 to 3, 1948-84, Gearbox, ...

Castrol Classic Oils Nostalgic Pouring Jug Half Pint

Castrol Classic Oils Nostalgic Pouring Jug Pint

Castrol Classic Oils Nostalgic Pouring Jug Quart

Castrol Classic Oils Nostalgic Tin Mug for Coffee or Tea or...

Castrol Classic Pump Oil Can with Fixed and Flexible Applicator Nozzles. 200ml.Pump action screw top cans, supplied with exchangeable fixed and fle...

Castrol Classic Pump Oil Can with Fixed and Flexible Applicator Nozzles. 500ml.Pump action screw top cans, supplied with exchangeable fixed and fle...

Castrol Classic Window Service Sticker Self-Adhesive.3" Diameter. Never forget to change your oil with this self-cling window sticker with Castrol ...