Products

Clutch Slave for Tdi on R380 Gearbox, OEM TRW. For Defender, Discovery 1, and Range Rover Classic 1992-94. Notes: 300Tdi to Gearbox Serial Number 5...

Clutch Slave Adapter for Defender 2007 onwards.For the Clutch Slave Cylinder and Throw-Out Bearing see CC-LR068979. For the Clutch Slave Cylinder C...

Clutch Slave Cylinder for Defender and Discovery 2.300Tdi from Gearbox 56A0669087K (1999)TD5 up to 2007OEM AP.

Clutch Slave Cylinder 300Tdi from Gbx 56A, TD5to07, TRW

Clutch Slave Cylinder for Defender and Discovery 2.300Tdi from Gearbox 56A0669087K (1999)TD5 up to 2007

Clutch Slave Cylinder Assembly Series 3 1971-1984. Also, for LT77 (Land Rover 90/100 and Defender from 1984 to 1993. Series 3 2.25L requires Hose C...

Clutch Slave Cylinder Repair Kit for either 266694 or 591231

Clutch Slave CylinderSeries 2 and 2A, 1958-71Mounts on the Right-Hand side of the transmission. For the later Series 3 Slave Cylinder, see CC-59123...

Clutch Slave CylinderFor Stage 1 V8, LR 90/110 V8 and Defender V8 NAS, with LT77, LT85, and R380 Gearbox.Supersedes CC-UKC8677 and CC-UKC8677L, (No...

Clutch Slave Cylinder OEM TRW Series 3 1971-84, (Slave is on the Left Hand side of the transmission), Land Rover 90/110 4 cylinder and Defender LT7...

Clutch Slave Cylinder Valve Dampener Defender Puma 2007on.For the Clutch Slave Cylinder and Throw-Out Bearing see CC-LR068979. For the Slave Contro...

Clutch Slave Push Rod for R380 Gearbox.For Defender 300Tdi or TD5 with Gearbox from SN 56A066908K.Discovery 2 with TD5 and R380 OEM.

Clutch Slave Repair Kit RRC 70-94, D1 89-94, 90/110, LT77

Rebuild Kit for Clutch or Brake Master Cylinder.For CV-Type 88" Master Cylinder 90569126, (Used as a Brake Master Cylinder on Series 2/2a 88" Singl...

Clutch or Brake Pedal Trunnion Pivot. For Series 2-3 and Defender. Supersedes BB-269784.

Clutch or Brake Pedal Trunnion Pivot. For Series 2-3 and Defender. Supersedes BB-269784. Land Rover Genuine.

Coil Pack Assembly for 4.0/4.6L V8 Gems Ignition. For Discovery 1, Range Rover P38, and Defender 90. For the Bosch Igntion Coil Pack, see EE-ERR604...

Coin Tray for Defender Upper Dash 1986-2006,Replacing the Ash Tray,

Collar for Front Axle Bearing on Half shaft Series 1-3 OEM 1948-84.

Collar for Semi-Float Rear Axle Halfshaft Bearing.For Series 1. 1948-58.

Collar for Under Spring of 4WD Lever Series 1-3.

Complete Front Floor Fastener Kit for the Defender.  Includes everthing needed to properly secure the floor as it was done at the factory.

Complete Exhaust System for Series 1 86/88" 2.0L 1954-58. This kit fits: Series 1, SWB 86" or 88" all Gas or Diesel models 1954 to 1958. The Tailpi...

Complete Floor Bolt Kit 4 Cylinder Series 2-2a 1958-70Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells...

Complete Floor Bolt Kit 4 Cylinder Series 3 1971-84Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells, (...

Complete Floor Bolt Kit for Series 1 1954-58 86/88/107/109"

Complete Front Wiper Arm/Blade Kit for Defender LHD 1983-01.Includes 2 Wiper Arms, 2 Sprung Blades, 2 Adapters for Wiper Arms, and a Hex Key for th...

Complete Front Wiper Arm/Blade Kit for Defender RHD 1983-01.Includes 2 Wiper Arms, 2 Sprung Blades, 2 Adapters for Wiper Arms, and a Hex Key for th...

Complete Engine Gasket Set for 4 Cyl 2.25L Gas with Copper Head Gasket.Fits Series 2-3, 1958-84. Has both 7 and 9 Bolt Water Pump Gaskets.For the l...

This kit includes everything you need to completely redo the handbrake (parking brake) system in your Land Rover Series 2A-3. 1964-1984. Kit includ...

Complete Service Kit Ducellier Ignition Some Series 3's.Includes; ES-RTC3184 Oil Filter, EF-606168 Fuel Filter (in-line), 4x EE-RTC3570 Spark Plugs...

Service Kit for Series 2A/3 - 1964 onwards with Lucas 25D distributor with fixed points Will not fit vehicles fitted with a Ducellier distributor...

Complete Service Kit Lucas Sliding Points Late Series 3.Includes; ES-RTC3184 Oil Filter, EF-606168 Fuel Filter (in-line), 4x EE-RTC3570 Spark Plugs...

Complete Set of Lights for Series 2, 2A or 3 and Early Defender to 1994.European Style, 73mm, 2-3/4" Lamps with bullet connector wiring, including ...

Series 2a and 3 Swivel King Pin, Bearing and Seal Kit. Full Axle Set.Does Both Swivels. Includes Top Pins, Bushings, Bottom Bearings, Thrust Washer...

Connecting Rod Big End Bearing Set .010 Thou Over.For 2.5L Naturally Aspirated Diesel, 2.5L Turbo Diesel, 200Tdi, and 300Tdi.OEM King.