Products

Lock Nut for Hub Axle Shaft Front or Rear.For Discovery 2, Range Rover P38, Freelander 2002-2004.

Lock Nut for Hub Bearing Front or Rear.For Series 1-3, Defender, Discovery 1 and RRC, from 1948 through to 1998.OEM Quality.Supersedes AD-217355, A...

Lock Nut for Rear Door Grab Handle Defender from 2002. OEM.

Lock Nut for Rear Main Shaft Series 1-3 1948-84

Lock Nut for Rocker Tappet Adjuster Screw. 200Tdi and 300Tdi, Defender, Discovery 1, RRC.

Lock Nut for Salisbury Differential Pinion 109/110/101

Lock Nut for Steering Tie Rod End Discovery 2 and Range Rover P38.

Lock Washer for Fairey Overdrive Series 1-3.

Lock Washer for Starting Dog on Crank Series 1-3 1948-84 For 3 Bearing Engines

Lock Washer for Timing Chain Damper.For Series 1 2.0L, and Series 2-3 2.25L and 2.6L Gas.Two Typically Required.Supersedes EP-278769.

Lock Washer Shake-Proof Int Tooth 7/16" for Series 1 Brake Hose & Series 2, 2a, 3 Clutch Hose.

Lock Washer Internal Tooth Zinc for 3/8" Brake Hoses 1954-1984. Also, for Defender 36-Spline Steering column.

Locker for Cam Thrust Plate Series 1 1.6/2.0 & S2a 2.6L

Locker for Differential Crown Wheel and Pinion Bolts

Locker for Gear Lever Reverse Gate Series 1-3 1948-79

Locker for Gearbox Layshaft Bearing Cap Series 1-2a 48-63

Locker for Stub Axle to Swivel Housing and Rear Brake Back Plate for every Series Truck.Supersedes AD-232416.

Locker Plate for Brake Shoe Anchor Bolts.For Series 1-3 86" and 88", or Early Defender 90, 110 and 130 to 1993 Rear Drum Brakes.

Locker Plate for Cam Shaft Bearings.For Series 1 1.6L and 2.0L, 1948-58.Typically 4 Required to Fix the Camshaft Bearings to the Cylinder Head.New ...

Locker Plate for Timing Chain Wheel to Camshaft. OEM.For Series 1-3, 1948-84

Locker Plate for Differential Seal Retainer 1948-67.For Series 1 to 2a, VIN Suffix 1 to G.3 Required to hold the Seal Retainer to the Diff.

Locker Plate for Engine Mounts.</p><p>Series 1 and  2, 2.0L and 2.25L 1958-61. Land Rover Genuine.

Locker Plate for Flywheel. For Series 1 1.6L and 2.0L, 3 are Required, 1948-58. For Series 2 to 3, 2.25L 3 Bearing and 2.6L, 3 are Required, 1958-8...

Locker Plate for Oil Feed Bolt to Distributor.For Series 1 1.6L and 2.0L, and Series 2a 2.6L 6 Cylinder.

Locker Plate for Spring U-Bolts .For Series 1, 1948-51 with the Early Narrow 2.5" Wide Leaf Springs, (Supersedes SS-217261); and Series 1 to 2a, 19...

Locker Plate for Steering Box on Defender and RRC

Locker Plate for Swivel Pin Series 1-2a 1948-1962 3/8" Studs 4 Required per Side, 8 per Axle. You are purchasing 1, not 10 as shown in the photo.

Locking Pin for Selector Shafts

Locking Tab for Exhaust Manifold 2.25L Gas (2 required) 

Lockut Nut for #10 Self Tapping Screws Various Uses. OEM. Note: You are purchasing 1, not 10 as shown in the photo.

LOF Clutch Pedal Assist Kit Spring and Bushings. Defender 1994on Replace the old clutch pedal spring kit to assist the pressing of the clutch pedal...

LOF Power Clutch Slave Cylinder for TD5 Defender and TD5 Discovery 2. Heavy Td5 clutch pedal? This is a Cost-Effective Slave Cylinder that reduces ...

Loknut Plastic Discovery 2 Rear Bumper and Various. OEM. Note: You are purchasing 1, not 10 as shown in the photo.

Steering Longitudinal Tube with Ends Series 2a and 3. For the Steering Box to the Steering Relay with Tie-Rod Ends. 1961-1984.

Low note horn for your 1998 and onward Defender. The older-style horns used a twin Lucar (spade) connector. This newer series use a plug-style conn...

Low Tension Lead and Insulator for Lucas 25D Distributor

Brake Spring, Lower for 10" Shoes. For use on: Series 1 to 3, Front 80", 86", 88", and 107" with 10" Front Brakes up to June 1980. Series 1 to 3 Re...

Lower Clamp Plate for Exhaust Brackets

Lower Dash Finisher for Left Hand Drive Defender.Supersedes BP-MTC6167.

Lower Dash Finisher for LHD Defender Land Rover Genuine.Supersedes BP-MTC6167.

Lower Dash Finisher for Right Hand Drive Defender. Supersedes BP-MTC6166.

Lower Shroud for Steering Column on Series 3. If you require the bracket that holds this in place, see BP-347647 (linked below).

Lower Speedometer Cable Defender NAS. Also fits Disco 1 and RRC with cable driven speedos. SPECIAL ORDER: Please note this item is special order an...

Lower Steering Column Shroud for Defender Note: Will Not Fit Puma fitted with Bluetooth and/or Dynamic Stability Control. Supersedes BP-MTC3500. 

Lower U-Joint for Steering Shaft. For Defender to VIN: VA133508, 1997, RRC to VIN: MA601606, and some Discovery 1's to VIN: HA002271. Requires 2x B...

Land Rover Genuine Oil Seal Diff Pinion Rover Axle. Fits Defender 94 on, D1, D2, RRC.

Key Blank Series 2a and 3 Ignition and Anti-Burst Door Locks.FS Type LR Genuine.Not for Earlier BE-395141 Key Cylinder requiring a flat on one-side...

Mud Flap Front Left Hand Black with White Heritage Logo. For Defender 90, 110, or 130. Land Rover Genuine. Includes mounting bracket.