Best selling products

Exhaust Manifold Stud Kit (3 Studs, locks, & brass nuts) 2.25L Gas 61-84 For Mounting Down Pipe to Manifold. (These are included in the Comple...

2.25L 4 Cylinder Ignition Lead Set- OEM Lucas Series 2a, 3, 1970-84.Shorter Ignition Coil to Distributor Wire, for Coil located on Right Hand side ...

Weber 34ICH Carburetor Kit. Includes Choke Cable, Gaskets. Direct Replacement for Zenith Carburetor from April 1967 to 1984. Made in Spain. To repl...

Tie-Rod End for Defender, Range Rover Classic, Discovery 1, Right Hand Thread.You'll need two of these.You should also consider one SC-SCLMPKIT per...

Standard Swivel Hub Oil Seal Rebuilder's KitFits Series 1 86/88, 107/109 1954-1975,Series 2 88/109 1958-1960,Series 2a 88/109 1961-1971,Series 3 88...

P-Clamp for Brake Lines.For Series 1-3 Single or Dual Line 3/16 and 1/4" Pipes.Supersedes BC-50640.

Whitworth Combination Wrench 8 Piece Set 1/8" to 9/16" w/Storage Case. Sizes: 1/8", 3/16", 1/4", 5/16", 3/8", 7/16", 1/2", 9/16" Manufactured from ...

Stainless Steel Rear Safari Door Bolt Kit For Series 2, 2a, 3 Rear Safari Door, (note - typically only 2 hinges), and Defender Rear Safari Door wit...

Bulb 12v for Stop/Tail LampFits Series, Defender, Discovery 1, Discovery 2, RRC, and RR P38

Brake Shoes Axle Set 10" Front or Rear. OEM, Mintex.Fits Series 1 80", 86", and 107" Front with 10" Brakes.Series 2-3 88" Front up to June 1980.Ser...

Wiper Arm LHD Defender 90/110 Hook-TypeUp to VIN: 1A622423 (2001).For the Wiper Blade, see WW-LR079891. You may require the Splined Adapter, WW-STC...

Two Pin Gas CapSeries 2a-3 with Seal OEM. 1963-78.Also used on some Defender 110's

Copper-Nickel Pipe, (will not rust), with Brass Fittings for use on;Series 2 and 2a, 1958 to 1971 with separate Brake/Clutch Reservoir Canister.1/...

Radiator Top Hose Series 2 and Early 2A. 1958-1968. Petrol and diesel.

Push-Button Starter Switch Series 1-2a, 1948-1966. Note: This Does Not include the Knob. Use your original, or see BE-605280 (linked below). Supers...

Clutch Release Bearing Series 1 to 2A, 1948-71Used for both 9" and 9-1/2" Clutch. 2.25L and 2.6L NADA.Also used on Front Output of LT230 for Defend...

9.5" Clutch Plate Optional 1964-71, Standard 1970-84 Late 2A, Series 3 Optional 9.5" Clutch used on NADA Gas/Dsl 88 and 109, 1964-71. Standard on D...

This is a rubberized end cap for the Defender's front bumper.Fits either side on the standard bumper starting in 1984 all the way through the end o...

Terrafirma All Terrain Rear Shocks PAIR with Bushings. Standard Travel Shocks. For Defender 90, 110 and 130, Discovery 1 and Range Rover Classic.

Spring Clip for Tools behind Front Seats Series 1-3.For tools, like the hand crank, with a diameter up to 5/8".You'll need a rivet for installation...

Lucas L841 Rubber Base for Side Marker Lamp.For Late Series 2a and Series 3 North American Standard.

Wire Grommet for Various Uses.Series 1-3. Red Rubber.1 3/8"OD, 1" panel-hole, 1/4" wire hole.

Wheel Cylinder Repair Kit Axle Set.For Series 1-3, 107/109" 1954on, 11" Front Wheel Cylinders 243743 and 243744.

Rebuild Kit for CB-Type Master Cylinder BB-520849.For Series 2 and Early 2A 88" Short Wheel Base.