Best selling products

Get the job done in our vintage inspired Land Rover shop jacket, a timeless design built to last. This utilitarian staple is perfectly engineered f...

Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.

Castle Nut for Halfshaft, Output Shaft and Differential Pinion.Requires Cotter Pin AD-PS608101L and Flat Washer AD-571922.

Hand Brake Expander Dust Cover for Series 2a and 3; 1964on. Also happens to fit Land Rover 90's, 110's, Discovery 1's, and Range Rover Classics... ...

Radiator Hose Kit for Series 2 and 2A 1958-68 With Stainless Steel Hose Clamps. Not for use with Later Series 2a/3 Replacement Radiator; see EC-H...

Master Brake Cylinder CV-Type.For Series 2A 88" Short Wheel Base No-Servo Single-Line 1964-84.Also, the Clutch Master Cylinder for Series 2-2a, 195...

Brake Spring, Lower for 10" Shoes. For use on: Series 1 to 3, Front 80", 86", 88", and 107" with 10" Front Brakes up to June 1980. Series 1 to 3 Re...

Upper Brake Spring for 10" Shoes. For use on, Series 1 to 3, Front 80", 86", 88", and 107" with 10" Front Brakes up to June 1980. Series 1 to 3 Rea...

Prop Shaft Rubber Gator and Clamps. All Series trucks and Early Defenders. For a Pair of these, see AP-276484PR (linked below left) For the later D...

Wing Mirror Round 4 1/2" with Standard 6" Arm - PAIR.For Series 1 - 3

Bolt for Rear Propshaft both ends, and Front Propshaft to Differential.Series 1, 1948-58, Requires 8 for the Front and 1950-58 Requires 4 for the R...

Castrol Classic Oils Nostalgic Tin Mug for Coffee or Tea or...

Front Bumper Galvanized Series 2-3 With Bolt Kit

Carburetor Zenith 361V Replacement Series 2a-3 2.25L April 1967 to 1984.Note: To replace a Solex Carb on an earlier 2 or 2a, you are going to need ...

Service Kit for 300Tdi Oil, Air, Fuel Filters, Washers

Oil Seal, Front or Rear Output Shaft on Transfer Case of transmission, Series 1-3, 1948-1984.Fits every single Series truck. Keep it simple.

Exhaust Manifold for 2.25L 4 Cylinder Gas, Series 2a-3, 1961-1984. Can be used to replace Series 2, 2.25L Gooseneck Exhaust Manifold and Front P...

Distributor Cap for 2.25L 4 Cylinder 1967-74 up to Series 3 Engine Suffix C, 25D4 Distributor.Can be Used In Place of Earlier EE-600328 Screw-In Ty...

Thermostat O-Ring Series 1 1.6/2.0L, S 2a-3 2.25L 1963-84

Thermostat 74C degree for Series 2a-3. Fits Engine suffix D-on, (1963-84). This is the shouldered type that fits top thermostat outlet pipe EC-5271...

Trico Wiper Blade for Defender Front (1983on) or Rear (1989on), up to 2016. OEM.Supersedes WW-PRC4278, WW-PRC8559 and WW-DKC000110pmd.

Water Pump Assembly Series 2A to 3, 2.25L. Gas or Diesel Engine, 9-Hole Pump with the Gasket. Note: This Does Not Fit the 1958 to 61 Series 2 Engin...

Copper Washer/Seal for Swivel Housing Drain Plug. For Series 1-3, Discovery 1, Range Rover Classic, Land Rover 90/110 and Defenders up until 1994. ...

Set of 3 Replacement Rubber Pedal Pads, (Clutch, Brake, Accelerator/Gas/Diesel) Series 2, 2a, and 3; 1958-84.