Best selling products

Trim Ring for Manual Window Handle Defender Black

Collar for Front Axle Bearing on Half shaft Series 1-3 OEM 1948-84.

Rotor Oil Filter (Centrifuge) for Defender TD5 and Discovery 2 TD5.

Lamp Adapter Wiring Harness 2-Pin to Bullet Connectors. For fitting LED Lamps to Series and Early, (Pre-1995), Defender Wiring Harnesses. Small Plu...

Bearing for Half-Shaft Front 1954-1984 Series 1-3

Oil Filter for Series 1 2.0L Spreadbore Engine and Series 2a/3 6 Cylinder.Aftermarket.

Oil Seal for Speedometer Pinion in GearboxSeries 1-3

Rubber Seal for Gearbox Selector Detent Spring 48-84

Mirror Head 7" x 5" Each for Series 1 to 3.Fits the Standard Mirror Arm, (post type requiring a clamp to fit the mirror head), GM-DA2128.Typically ...

Gasket for the Inlet Manifold to the Exhaust Manifold.2.25L Gas Series 2-3 1958-84.

Locker Plate for Flywheel. For Series 1 1.6L and 2.0L, 3 are Required, 1948-58. For Series 2 to 3, 2.25L 3 Bearing and 2.6L, 3 are Required, 1958-8...

If your fuel cooler starts leaking on your Td5 Defender (or imported Discovery) this kit can be an economical fix may save you from replacing the e...

Rubber Pad between Radiator Grill and Chassis for Series 1-3, Package of 3.

Return Spring for Accelerator Pedal Control Rods. Series 2-3, 1958-84, Series 2 with the 2.0L Gas, Series 2a-3, 2.25L Gas and 2.6L Gas. Also used o...

Oil Pan Sump Drain Plug for 2.0L and 2.25L Engines. Series 1-3. 3/8" BSF Thread. Supersedes EP-3088. You May Require the Copper Seal, CS-243959 (li...

Our new shop mug. Use it in the kitchen or the shop.Ceramic, single walled. 12 oz. Handwash only.Check out our Coffee - Ground, AG-COFGRO or Whole ...

Grommet for Speedometer Cable at Fuel Pump, and Various Uses.For the Clip used to Hold the Speedometer Cable, see BP-240407.Also for Series 3 109 ...

O-Ring for Swivel Pin/Steering Levers.For Series 2a-3, 1964-84.

Brake and Clutch Pedal Return Spring Series 2/2a, 3-17/32".Note: you are purchasing 1, not 2 as shown on the photo. Typically 2 are required.

Ignition Condenser for Series 1-3, 1954-76.For the 2.0L, 2.25L 4 Cylinder, and the 2.6L 6 Cylinder.Lucas OEM.

Torsion Spring for Bell Crank on Zenith Carburetor 1968-84.

Cap for Coolant Expansion Tank TD5.For Defender and Discovery 2 with the TD5.

Gasket Pack for Thermostat Series 2a-3 2.25L 3-Bearing Engine from March 1963.From Engine Suffix D. Fits the Water Outlet Pipe EC-527109.For Should...

Fitting Kit for Zenith or Weber Carburetor Series 2a-3.

Power Steering Hose Reservoir to Pump 300Tdi Defender

Gasket Paper for Water Pump, For Series 2a-3, 1961-84. 9-Hole Water Pump, Gas or Diesel. This does not fit the Series 2, (1958-61), 8-Hole Water Pu...

Cylinder Block Freeze Plug KitFor Series 2a-3 2.25L Gas or Diesel and Defender 2.5L Gas or Naturally Aspirated Diesel.Note: for Series 3 1972on 2.2...

Frost Core Plug 1-7/8" Push-In Cup for 2.0L, 2.25L, and 2.5L Gas or Diesel (Side Plugs)Series 1 2.0L uses 4. Series 2-3 2.25L uses 3.

Cup Holder for Cubby Box.Fits most standard sized cubby boxes. Removable for cleaning.

Polyurethane Bushings Set for Panhard Rod, Black.For Defender up to VIN: 2A626645, (2002), Range Rover Classic and Discovery 1.Equivalent to SS-ANR...

Axle U-Bolt Rear with NutsFor Series 1-3 86/88, 107/109 to end of 2a, Rover Axle4 Required.

Bell Crank Rod Assembly Lever to Carburetor Series 2a-3 2.25L March 1963on and 2.6L.Final Connection to Solex, Zenith and Weber Carburetors.

Gasket for Oil Filter Housing to Block Series 3 2.25L Gas or Diesel, and 2.6L, 1971-85, (See note below). Defender 2.5TD and 200Tdi, 1986-94. Super...

Special Stud for Swivel Housing 7/16"BSF Series 2a-3 This Stud has a thicker non-threaded center. 4 Required for Top, February 1962-66. 2 required ...

O-Ring and Washer Seal Kit for TD5 Injectors 5x O-Rings (EF-ERR7004, Made in Italy), 5x Washers (EF-ERR6417, Made in Germany). Defender and Discove...

Stainless Steel Antiluce Pin Kit for TailgateFor Series and Defender.Shiny Pair.