Best selling products

Clutch Slave Adapter for Defender 2007 onwards.For the Clutch Slave Cylinder and Throw-Out Bearing see CC-LR068979. For the Clutch Slave Cylinder C...

This is the Clutch Release Mechanism, Slave Clyinder, and Throwout Bearing all in one.Fits the Puma Transmission from 2007 onwards.You may also req...

Crank Position Sensor 4.0/4.6L V8 Automatic.For Discovery 2 1999-04, Range Rover P38 1999-02.If your engine suddenly stops as though someone just t...

Exhaust Rocker Arm Bushing All Diesel Engines upto 1990 (Not Tdi).Fits Series 1 to 3, 2.0L and 2.25L Diesel, Defender 2.5L Naturally Aspirated and ...

Inlet Rocker Arm Bushing All Diesel Engines upto 1990 (Not Tdi). Fits Series 1 to 3, 2.0L and 2.25L Diesel, Defender 2.5L Naturally Aspirated and 2...

Control Rod for Governor on Series 2a 2.25L Engine Suffix J (1967on).New Old Stock.

Spacer Distance Piece for Layshaft 0.405".

Bushing for Oil Pump Idler Gear.For Series 2-3 1960-84.Note: Series 2, 1958-59 Engines Have a Different Idler Gear, see EP-237884.This Bushing is a...

Main Bearing Set .010 Under Size 2.25L Gas Series 2 1958-61 and Series 1-2, 2.0L Diesel.Note: These are NOS specific to the Series 2, 1958-61 2.25L...

Connecting Rod Assembly 2.25L Gas Series 2 1958-61Note: This is Specifically for the Series 2, 1958-61, Gas Engine. Serial Numbers 151XXXXXX.These ...

Glass for Rear Safari Door Heated, Tinted, High Brake Mount, Defender 2002on. This requires Rubber Seal SL-CVW500010 (linked below). For the Earlie...

Water Pump OEM Proflow.For 4.0L and 4.6L V8, Discovery 1, Discovery 2, 1995 Range Rover Classic, Range Rover P38, and Defender NAS V8.

Water Pump for 2.25L 5-Bearing Gas Engine.Fits Defender up to 1986 with out AC.For the earlier Series Water Pump, see EC-STC3758.

Gasket for Water Pump.Fits Defender 2.25L Gas, (5-Bearing Engine), 2.5L Naturally Aspirated Diesel, 2.5L Turbo Diesel, and 200Tdi.

Thermostat and Housing Range Rover P38 4.0L and 4.6L V8. 1995 to 2002.

Reverse Gear Shaft for Series 1-2a, 1948-71. For later Series 3 Gearbox Suffix A, see GT-591527; for Series 3 Suffix B onwards, see GT-FRC1813. SPE...

Reverse Gear Idler Shaft for Series 3 Suffix A Gearbox Only, 1971-72.For Earlier, see GT-561962 (SS: GT-06424). For Later Series 3 Suff B onwards s...

Reverse Shaft Series 3 Gearbox Suffix B Onwards. From September 1972. For the Earlier Series 3 Suffix A Gearbox, see GT-591527. SPECIAL ORDER: Plea...

Bracket for Rear Anti-Roll / Anti-Sway Bar - Single Bolt Type.For Defender 90 ROW up to 1998.For the Later Defender 90 Bracket with Two Bolt-Holes,...

Bracket for Rear Anti-Roll / Anti-Sway Bar.For Defender 90 1994on. Uses Bushing SS-EGP1889 (linked below).For the Earlier Defender 90 Bracket with ...

Bracket for Rear Anti-Roll Anti-Sway Bar Bushing.For Defender110/130 with the 4-Bolt Bracket. For Defender 2-Bolt Type, (Some Defender 110/130's an...

Idler Wheel for Timing Chain.For Series 1-3, 2.0L Diesel, 2.25L Gas and Diesel.

Water Temperature Sender for V8 Carburetor.For Range Rover Classic to 1991, Series 3 Stage 1 V8, and 101 Forward Control V8.

2.25L Connecting Rod Gudgeon Pin Bearing