Best selling products

Pinion Oil Seal for Rover Differential Front or Rear OEM For Series 1-3 1950-84l Supersedes AF-217507, AF-561360.

"Diesel Only" Plate for Fuel Inlet. OEM. For Series 2 to 3, and Defender to 1997. Can be used on Defender after '97 but you will need to drill hole...

Speedometer Cable for Series 1-2A (1950-1971)Note: You must keep and re-use the original Round Plate with 3 holes that mounts the cable to the tran...

Nylon Lock Nut for Shackle Pins 9/16" UNF

This heavy weight fleece hoody from Red Canoe features a ‘Chain Stitched’ original font vintage Land Rover word mark on the front chest and a woven...

This is an under the seat mounted fuel tank that suits both petrol and diesel 88" Series trucks from 1958 through 1984. Also fits 109" up until Aug...

Everything you need to affix your door cards properly to your door.This kit does one door, either front, or middle, not the rear safari doors.That'...

PAIR of Front Vent Rubber Seal Series 2-3 and Defender.(These are the fit to bulkhead type, with Grooves for the Vents to seal into).

Oil Seal, Front or Rear Output Shaft, Corteco (OEM) Series 1-3, 1948-84. Every. Single. Series.

Front Chassis Bushing for the Rear of the Front Spring. This goes through the Chassis Rail for the Front Spring's rear shackle assembly.For Series ...

Oil Pressure Switch for Series 1-3 2.0L, 2.25L, 2.6L, 4 and 6 Cylinder to 1984.

Gasket Thermostat Housing Upper - 3 Bearing 2.25L petrol and diesel. Series 2a-3. From March of 1963 through until the end of the Series run in 1984.

Water Temperature Transmitter Sender Series 2-3, 2.25L 4-Cylinder and 2.6L 6-Cylinder 5/8" x 18 UNF thread

Panel Light Bulb Screw-In 12v 2.2w for Series 1-3 Instrument Panel Series 1 1954-58 requires 6 or 7. Series 2, 2a requires 6 to 8, depending on Aux...

First of a colour series, this 5-panel cap features a ‘felt appliqué’ vintage Land Rover front icon. Each letter is individually stitched down like...

Wheel Nut 15/16" Wide Series 1/2/2A, 1948-1969 Double-End.For a set of 20 Nuts, see AW-217361-20.For the Later 1-1/16" Wide Single-End Nut, see AW-...

Gearbox and Transfer Case Gasket Set - Series 1-3 1948-84

OEM Service Kit for Td5 Oil, Air, Fuel and Rotor Filters, Washer. Defender or Discovery TD5, 1999 to 2006.

Gasket Paper for Stub Axle Rear.For Series 1 through 3, from 1957 to the end of 1984.

Oil Seal for End of Front Axle Casing 1948-1984 Series 1-3

Gasket for Thermostat Housing, Lower.Series 2-3 from 1958 to 1984.

Champion Brand Spark Plug. N9YC. For Series 2, 2a, and 3 with 2.25L or 2.6L engines with 7:1 Compression Ratio.

Brake Light Switch, Series 3, 1971 to 1984 with Brake ServoAlso used as the Optional Reverse Light Switch on the Gearbox.

Sealing washer designed for differential and gearbox drain plugs. Positioned between the plug and the housing, it ensures a leak-tight seal across ...

Set of 3 Replacement Rubber Grommets for Series 2a-3 1967-84.Handbrake, Gear, and Transfer Lever.Handbrake has Oval Hole. This set can work for ear...

Brake Drum Screws Series 1-3 1948-1984 PACKAGE of 10.

Door Top Rubber Seal (Between Door and Door Top) Series 2-3

Wiper Blade for Defender Front (1983on) or Rear (1989on), up to 2016.Supersedes WW-PRC4278, WW-PRC8559 and WW-DKC000110pmd.

Slotted Drain Plug Tool for Series, Defender, and RRC.Uses a 19mm or 3/4" Socket or Wrench.For use on the Slotted Drain Plug, AF-235592.So much eas...

Rebuild Kit for Clutch or Brake Master Cylinder.For CV-Type 88" Master Cylinder 90569126, (Used as a Brake Master Cylinder on Series 2/2a 88" Singl...

Corteco Pinion Oil Seal Rover Differential Front or Rear.For Series 1-3 1950-84Supersedes AF-217507, AF-561360.

Lock Nut for Hub Bearing Front or Rear.For Series 1-3, Defender, Discovery 1 and RRC, from 1948 through to 1998.OEM Quality.Supersedes AD-217355, A...

Front Crankshaft Oil Seal Corteco OEM Fits, Series 1, 1.6 and 2.0L Series 2, 2a, and 3, 2.25L 4Cyl and 2.6L 6Cyl Defender, Discovery 1 and RRC, 2.5...

Brake Drum 10" Series 1 to 2A 1948-1969. 80", 86", and 88" Front and Rear. Series 1 107" with 10" Brakes.Note: Holes are 0.581", (a bit larger than...

Hub Bearing and Oil Seal Repair Kit. Fits Series 1, 1948 to 58, Front Axle. Fits Rear Fully Floating Axles on 109", and 88" with the optional full ...

Distance Piece Collar for Stub Shaft Front or Rear Axle Race for Hub Seal. OEM. Series 1-3 upto 1980 Series 1 Front Only up to 1956.