Best selling products

LED License Plate Light AssemblySeries 1-3, Defender AllWipac

Leaf Spring Kit for Series 1-3 86/88" LHD Standard with U-Bolts. Standard Duty Set of Leaf Springs and U-Bolts. *Note: a $40 surcharge for addition...

Performance Air Filter for Series 2.25L Gas.Fits Zenith or Weber Carburetor.And yes, it just fits under your bonnet.

Washer Lock for 2BA Screws and TS-MSC4657 Studs and Various Other Uses. OEM. You are purchasing 1, not 10 as shown in the photo.

Drain Plug for Gearbox & Transfer Case & S2a Axle

Shim for Intermediate Gear for Series 2a to 3, September 1963 to 1984.Quantity As Required. These are 0.005" shims.

Brake Pipe Clip Stand-Offs Plastic

Brake Rear 3-Way Tee Union.For Series 1 86" and 107" 1954-58 and Series 2, 2a, and 3, 88" SWB and 109" LWB up to June 1980.Brass. 3x 3/8" Imperial ...

Front Chassis Repair Leg . Left side. Series 2-3

Gasket Cork for Oil Sump Series 1 1.6L or 2.0L 1948-58

Gasket Cork for Side Valve Cover.For Series 1 1.6L or 2.0L Gas Engine, 1948-58.

Electronic Black Cap Distributor for 2.25L/2.5L - 45D4 Type. Ready to go electronic ignition. Black cap is cosmetic.  Same as the red cap (EE-ETC58...

Rubber Gaitor for Overdrive Lever.For the Fairey or Global Roamer Over-Drive on Series 1-3.

Bulb-Holder 2-Pin 21W IndicatorDefender 1995on, Discovery 1, Discovery 2, RR P38

Stub Axle Front for 88 or 109. Series 2-3 Up to June of 1980

Half Shaft Rear Axle Left Hand.Series From 1958 to June of 1980. 10-Spline. Rover Axle.

Copper Oil Pan Drain Plug Washer. For 300Tdi, (see note below), 2.0L MPI, and Range Rover P38 4.0, 4.6L V8. For a replacement Plug, see EP-UAM2957L...

Air Filter, Fits:Discovery 1 V8.Discovery 1 2.0L MPI Gas from VIN: MA081992.Range Rover Classic V8 and Range Rover Classic 300Tdi.For the Defender ...

Ferodo Brake Pad Set RearFor Defender 110/130 Up To VIN 1A614447 (Model Year 2001)Requires Fitting Kit BB-DA4105 (linked below left).For Later see ...

Brake Shoes Axle Set 10" Front or Rear. OEM, Ferodo. Made in Italy.Fits Series 1 80", 86", and 107" Front with 10" Brakes.Series 2-3 88" Front up t...

Hinge to Bulkhead Screw 1.5" Long for Series 3 and Defender Hinge, OEMThis is the shorter screw that holds the Hinge to the Bulkhead. For the longe...

Radiator Hose Kit for Series 1 1948-58 1.6L and 2.0L EnginesIncludes EC-268037 and EC-268038 with Stainless Steel Clamps.

Stainless Steel Screw Pan Head Slotted Drive #4-24 x 3/8" for Various Uses.Used on Series 1 to 3 Glass Retainers.

Screw 3/4"x#8 Black Philips Pan Head for Defender Wing Top Vent Grills OEM.7 Screws Required per Vent Grill.

Mirror Arm for Wing Mount Extended 8-1/2" Series 1-3 For Mirror Heads, see GM-606187 for 6" Round, or GM-DA2130 for 7" x 5" (both linked below).

Rubber Gasket for Bell Housing Top Cover Plate 1958-84

Spring for Gearbox Reverse and Transfer Selector 1948-84

Aluminum Wing Top Protectors Series 2, 2a, 3 (Pair). Requires 20x RV-782-716 Pop Rivets

Collar for Under Spring of 4WD Lever Series 1-3.

Corteco OEM Oil Seal for Gearbox to Transfer Case Input Shaft.For Series 1-3.

Heater Control Valve for Kodiak Mark II & III Series 2/2a

Headlamp Mounting Kit with Chrome Retention Ring. OEM by Wipac. For Series 1-3 and Defender. For the more Original Steel Buckets used on Series, se...

Brake Drum 11" 107/109" Series 1-2a, 1954-68.

Fuel Filler Tube Hose for 109" LWB Series 2-3 Rear Tank.Notes: Requires HC-TS52-12-SS and HC-TS32-12-SS Clamps (see below links).

Fuel Cap Rubber Seal/Gasket Series 2 - 3

Drain tap coolant valve for cylinder block or original radiator, (will not fit new replacement radiators EC-577609). Sometimes referred to as a pet...

Parabolic Springs PAIR 3 Leaf Rear with U-Bolts and Nuts. For Short Wheel Base 86", 88", or Long Wheel Base, 107", 109". Series 1-3. Note: For Heav...

Front Parabolic Springs Pair 2 Leaf with U-Bolts.Series 1-3, 86, 88, 109". *Note: a $40 surcharge for additional packaging will apply to this sale....

Rear Body Nut Plate and Fasteners for Series and Defender to 2002.Plate is Aluminium with Stainless Nutserts, Bolts and Washers Stainless Steel, Ri...

Push Rod for 2.25 and 2.5L Gas Series/Early Defender OEM 8:1

Oil Seal for the Output Shaft, Front or Rear, on the LT230 Transfer Case. For Defender, Discovery 1 and Range Rover Classic.

Prop Shaft Nut Special Tool 1/2" Drive. Because regular sockets just don't fit... For Series, Defender, Discovery 1 and 2, Range Rover Classic and ...

WE CAN NOT SHIP PAINT OUTSIDE OF CANADA Paintman Paints Limestone Land Rover Series and early 90s and 110s, 1959 to 1984. 500ml can.  Mainly used o...

Gasket for TD5 Turbo to Manifold. For Defender, and Discovery 2 with the TD5 engine. OEM ELRING, Made in the UK.

Gasket Exhaust Manifold to Cylinder Head V8 3.5/3.9/4.0/4.6L (4 Required, 2 Per Side).

Valve Seal (O-Ring Type) for Series 1 1.6 and 2.0L Inlet and Series 2-2a 2.25L Exhaust to 1968. 1.6L from Eng #061106720 on. 2.25L to March 1968 En...

Fuse Box Cover for the Puma Defender, 2007 on

Raptor Steel Instrument Panel Heater Control End Plate. For Defender 1983-06. This is a direct replacement for the poor plastic original LHD End Pa...