Best selling products

EGR Blanking Kit for 300Tdi.For Defender, Discovery 1, and RRC.The EGR (exhaust gas recirculation) blanking kit enables you to remove the original ...

Gasket Cork for Rear Camshaft Cover.For Series 1 1.6L and 2.0L 1948-58.

Valve Guide for Inlet Valves on 2.6L 6 Cylinder European Version. Not for Series 2a NADA 2.6L.Supersedes EP-504169.New Old Stock.

Shim for Pinion Bearing Inner 0.020"Early Land Rover Differential up to end of Axle Suffix A, Feb 1964.

Shim for Pinion Bearing Inner 0.005" Early Land Rover Differential Axle Suff-A.

Special Bolt to hold Breather Cap on Rocker Cover.For Series 1-3 1956-84.

Bulkhead to Chassis Support Bracket Left Hand Hot-Dip Galvanized.For Series 2-3.Made from 3mm Steel, Machine Cut and CNC Pressed for Accuracy, Hot-...

Axle Shaft LH Rear w/ Fixed Drive Flange D90, D110 '02>, D1, RRC

Axle Shaft RH Rear w/ Fixed Drive Flange D90, D110 '02>, D1, RRC

Vent Louvre for AC Facia Defender LHD to WA159806 (1998) Dash requires 5. For RHD See AC-RTC7411, For later (TD5 LH & RHD) see AC-BTR7071.

Coolant Expansion Tank Unit Clear.You Can See the Coolant Level without Removing the Cap!Note: Cap is Not included, see EC-NTC7161 (linked below).F...

Glass for Middle Door Sliding Rear 109" Series 2-3, Left or Right Hand.Except for 109 V8.Includes Glass Finger Pull.This is the Sliding Rear Piece ...

Glass for 2nd Row Middle Door Fixed Front 109" Series 2-3 Left or Right Hand.Except for 109 V8.This is the Fixed Front Piece as shown on the left i...

Gasket for Oil Sump V8 4.0L and 4.6L.For Discovery 2 1999-04 and Range Rover 1995-02.

Swing away rear spare wheel carrier for Defender half-door or drop-down tailgate. With fittings and instructions.

Heater/Glow Plug for 200Tdi (1989-1994) & 300Tdi (1994-2006)

Bolt for Anti-Roll Bar (also called a Sway Bar) to Ball Joint Front or Rear for Defender 90, Discovery 1 and Range Rover Classic.Requires Metal-Loc...

Bushing for Anti-Roll / Anti-Sway Bar.Fits Defender 90 up to VIN: WA159806,(to 1998), Discovery 1 and Range Rover Classic.

Pipe Adapter for Emission Hose on Carburetor Adapter or Inlet ManifoldFor Late Series 2a and Series 3.You might need the Copper Seal, see CS-243958...

Air Intake Grill for Defender 2.5L Turbo Diesel and 200Tdi to 1994. For later model 300Tdi/Td5, please refer to BP-BTR6188

Gasket Paper for Inlet Pipe to Water Pump Series 1 1.6L and 2.0L, 1948-58.

Filler Strip for Front Door Glass Vertical Rear Left or Right Hand. Fits Defender 90, 110, and 130 from 1987-2016 except NAS.

Backing Panel for Headlamp Left Hand.For Series 2a/3 and Defender 1969-98.Supersedes BP-MTC2063.

Backing Panel for Headlamp Right Hand.For Series 2a/3 1969 to 84 and Defender to 1998.Supersedes BP-MTC2062.

Flywheel Assembly for TD5 Defender and TD5 Discovery 2. OEM Valeo. Note: This is the Dual-Mass Flywheel, which is the original specification; two p...

Clevis Pin for Accelerator Cable Series 3 Diesel, 101 Forward Control, 109 V8, Discovery 1, and Defender up to and including 300Tdi.Requires Split ...

Rear Door Trim Panel Clip Defender from 2A000001

Door Latch Assembly KIT Right Hand Defender 110/130 2nd Row Side Door All the bits needed to get that door closing properly.

Foam Rubber Seal for the Top of the B Post to Roof on Series 2-3 or Defender Station Wagons.

Clip Double Pipes to Chassis for Fuel Lines.For Defender up to 2006 and Range Rover Classic.

Headlamp Pigtail Wire Harness.For Series 2-3, H4 Headlamp Plug with Bullet Connectors.

Accelerator Throttle Cable for Defender 110 2.25L RHD and 2.5L LHD Naturally Aspirated Diesel up to VIN:267061.30" Long.

O-Ring for Fuel Block.For Defender TD5 to 2001, Discovery 2 with the TD5 to 2001.

Knob for Ventilator Control on Dash with Screw.Screw-On Type for Series 2-2a.Quality Re-Production Made in the UK.

Stainless Steel Bolts for the Defender's Rear Safari Door.Using these smart stainless steel replacement bolt and screw kits will prevent rust from ...

Metal Strap for Brake Reservoir (Bean Can) Series 1-2a.

Copper Sealing Washer for Series 2-2a 2.25L Tappet Guide Set Bolt, for Series 3 Windscreen Hinge Bolt, early Series 2-2a Drive Member Fill Plug Scr...

Seatbelt Anchor Bracket Rear Tub Galvanized.For Series 2a 88". Typically 2 or 4 are installed. Support Brackets for the seat belts mounted inside t...

Headlamp Rim Dust Seal, (goes under the outer Chrome Ring, part LA-142001).For Series 1 1948-58 and Series 2/2a up to 1963, (Not for North American...

Front Door Hinge Kit Left and Right Hand Early Square Hinges. For Series 2-3 or Early Defender. Complete wih fasteners and seals. For Mirrors to fi...

Decal for Center Diff Lock Instructions, Manual Transmission. LR Genuine.For Discovery 1 and Range Rover Classic.

Warning Plate Negative Earth 12 Volt Series 2a-3.Land Rover Genuine.

Seal Upper for Series 3 Diesel Fuel Filter and Defender Sedimentor.

Seal Lower for Series 3 Diesel Fuel Filter and Defender Sedimentor.

Pulley for Generator Dynamo on Series 2a, 1961-71 (No Fan).

Gasket for 7-Stud Water Pump on 4 Cylinder Military Engines.

Washer Bottle Grommet for Washer Pump.For Defender 1987-06, Dicscovery 1 1989-98, and Range Rover Classic 1986-94.

Finisher Trim for Right Hand Windscreen/Door A-Post.For Defender, Black.For the Left Hand Side, see BP-MWC2314 (linked below).