Best selling products

Exhaust Manifold Stud for 1.6/2.0/2.25L 4 Cyl Gas or Diesel For Manifold to Exhaust Down Pipe

Delphi OEM Wheel Cylinder Right Hand Front 10" Brakes on Series 1, 2, 2a and 3 86"/88" 1954 to June 1980 Rear 10" Brakes on Series 3 88" from J...

Inlet and Exhaust Manifold Stud Fastening Kit - 4 Cylinder 2.25L Gas Complete Kit of Correct Studs, Bolts, Nuts, and Washers for Mounting both the...

Locking Hasp for Fuel Cap, (Gas or Diesel).Fits Series 2-3. (Fuel cap not included).

Panel Light Bulb Bayonet 12v 2w Series and Defender Instrument Panel Series 3 requires 3 of these.

Front Grill for Defender 90/110/130 Black Plastic.

Fuel Filler Tube Hose for 88" & 109" Regular Side Tank with Clamps.For Series 2-3 88" and 109" Side Fuel Tanks.

These are the fasteners necessary for fitting the bumper end caps (CP-DPT100070) on the Defender. You'll need four per cap, so eight in total. The...

Fuel Tank Fitting Kit for 88/109R Side Fuel Tank (552174)

Rubber Buffer for Seat Back, Door Check and Side Steps (54-84). OEM

Starter Motor for 2.5L Diesel, 2.5L Turbo Diesel, 200Tdi and 300Tdi Engine. Defender, Discovery 1, RRC Supersedes ERR5009 PRC5109 NAD10039 ERC52...

Brake Pad Retaining Spring Kit for Front or Rear Solid Rotors.Used with Pins Kit BB-RTC5001 (linked below).

Wheel Cylinder Repair Kit Axle Set.For Series 1-3, 10" Front or 11" Rear Wheel Cylinders 243296 and 243297. Also for Series 1 80" 1950-53 Front Axl...

Spring Clip for Transfer Gear Change Lever Series 1-3 1954-84

Breather Hose for Side or Rear Fuel TankFor 88" and 109" Series 2-3, and Defender up to VIN: MA159806, (1983-98)Can also be used for the 109 Rear T...

O-Ring Seal for Reverse Gear Selector Shaft.Series 1-3, 1955-84.Supersedes GT-272597.

Defender Bumper Stainless Steel Bolt Kit with Tap Blocks and Black Caps.

Key Washer for Hub Bearing Series 1 Front, Series 2-3 Front & Rear. OEM.

Oil Filter for Series 1 2.0L Spreadbore Engine and Series 2a/3 6 Cylinder.Land Rover Genuine.

Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84

Copper Seal for Radiator Drain Plug or Drain Tap and 2.25L Engine Block Drain Plug or Drain Tap.</p>For Series 1-3.

Brake Pad Retaining Kit Axle Set. OEM.For Front Vented Rotors on Defender, Discovery 1 and RRC.Supersedes BB-RTC6799, BB-STC8575.

Battery Hold-Down J-Clamp Kit

Housing for Door Lock Knob. For Defender 1987on, and Range Rover Classic from VIN: FA351847 on. For a Complete Kit of all 3 Parts, see DP-DA2499Kit...

Oil Seal for Steering Relay Series 1-3.2 Typically Required, one at the top, one at the bottom.If you are taking your Steering Relay apart, Be Very...

Felt Ring for Hand Brake and Clutch Cross-Shaft Bearings.For Series 2-2a Clutch, (2 Required), and Series 1-2a Left Hand Drive Handbrake Lever Shaf...

Lucas Ignition Contact Points Fixed for Series 1 to 3, 1954-76.Fits Series 1 Late Lucas DM2 LU 40504A Distributor, Series 2 to 3 Lucas 25D4 and 25D...

LED Headlamp Black 7" H4 with Angel Eye Ring Daytime Running Lights, and Amber Turn Signals.Fits Series 1-3, Defender, and RRC. PAIRLamps have the ...

Door Seal 1-Piece Push-On for Front Right Hand Door.For Late Series 3, and all Defenders.

Fuel Filter for 200 Tdi and 300Tdi.Fits Defender, Discovery1 and RRC.OEM, Coopers Fiam.

Fuel Filter for 200 Tdi and 300Tdi.Fits Defender, Discovery1 and RRC.Quality Aftermarket.

Hose Connector for Zenith or Weber Carburetor to Air Cleaner Elbow For Series 2a-3 1968on, or earlier if converted to a Zenith or Weber Carb. If yo...

Steering Drop Arm (Pitman Arm) for Left Hand Steering.3 or 4-Pin Adwest Manual or Power Steering Box.Left Hand Drive Defenders, 1983-2016.

Lucas Fuse Panel for Series 2/2a 2-Fuse Unit with Lid 1966-71 For the Earlier single fuse panel see BE-219078 (linked below left). For the later Se...

Front Spring Shackle Plate Plain (1956-1984) 88"/109"

Haynes Series II,IIA and III Owners Workshop Manual.The Haynes Land Rover Series II, IIA and III Petrol & Diesel Manual features detailed photo...

Silencer and Tailpipe Assembly for 300Tdi 110/130. *Note: a $40 surcharge for additional packaging will apply to this sale. Please add the surcharg...

Powerspark Electronic Ignition Kit for Lucas DM2 and 25D4 Distributor. For Series 1 and 2 with the Lucas DM2 Distributor and Series 2a and 3 with t...

If you have a roof rack and load it for serious adventure you undoubtedly have a good number of lashing straps to secure all the gear. This light a...

Windscreen Defender Clear Laminated All Models (1983 to 2016). Recommend fitting with a new seal, SL-LR056278. See below *Note: a $40 surcharge for...

Clutch Flex Hose for Series 3 1971-1984 4-Cylinder Engine.

This large travel bag is the flagship of the inaugural collection made in durable yet lightweight nylon with webbing straps.One embroidered and thr...

Washer Flat for Sway Bar Link and Bottom of Shock. OEM.Note: You are purchasing 1 not 10 as shown in photo.

Windscreen Glass Laminated Series 2-3 1958-1984 Does 1-Side. Fits Left Hand or Right-Hand Side. For Glazing Seal see SL-78159, *Note: a $40 surchar...

Rubber Grommet for Brake Line P-Clamps 3/16"-1/4"

Pair of Transmission Handbrake Shoes for Series 2a-3 from 1964 through to the end of 1984. Superseded PNs: RTC3404 607249 541994 516031 515455.

Set of 4 Series Hub Caps, Metal Silver.Used up to Sept 1983.