Best Selling Products

Lucas Headlamp Bowl Kit Metal PAIR.Steel Buckets, Rings and Rubber Seals; like the Originals. For Series 1-3, Defender and Range Rover Classic.This...

Key Washer for Hub Bearing Series 1 Front, Series 2-3 Front & Rear. OEM.

Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84

Interior Rearview Mirror for Series 2-3 with Hardtop, 1958-84. For Series 2-2a you require 2x FS-AD606041L to fasten (linked below left). For Serie...

Ignition Coil Non-Resistor Type, 4 and 6 Cylinder 1967-84. Can be used on earlier models, if you have a push-in ignition lead. Used on Positive or ...

Hard Top Seal Left Hand Side Panel to Roof Top Series 2-3, 88" and 109" Regular and Station Wagon Also for Early Land Rover 90/110 Regular and Stat...

Hard Top Seal Right Hand Side Panel to Roof Top Series 2-3, 88" and 109" Regular and Station Wagon Also for Early Land Rover 90/110 Regular and Sta...

Land Rover Genuine right and left rear rubber mud flap with logo.   Includes mounting bracket. Fits all Series.

Gasket Set for Bottom Overhaul - 4cyl 2.25L Gas.If you are taking on a complete engine overhaul... a) good for you, and b) use this with EG-STC1567...

Gasket Copper-Clad for between Intermediate Pipe to Muffler Series 2-3, 88 and 109" Exhaust Systems. Also for Series 1 Front Pipe to Manifold and S...

Locking Hasp for Fuel Cap, (Gas or Diesel).Fits Series 2-3. (Fuel cap not included).

Front Grill for Defender 90/110/130 Black Plastic.

Defender Bumper Stainless Steel Bolt Kit with Tap Blocks and Black Caps.

Copper-Nickel Pipe, (will not rust), with Brass Fittings for use on;Series 2 and 2a, 1958 to 1971 with separate Brake/Clutch Reservoir Canister.1/...

Brake Shoes Axle Set 10" Front or Rear, Aftermarket.Fits Series 1 80", 86", and 107" Front with 10" Brakes.Series 2-3 88" Front up to June 1980.Ser...

These are the fasteners necessary for fitting the bumper end caps (CP-DPT100070) on the Defender. You'll need four per cap, so eight in total. The...

Side Air Intake Grill for 300Tdi/TD5 Defender 1995on Black. For earlier 200Tdi trucks, you'll need BP-MWC2501 Requires 5x FS-AB608047L Screws, or ...

Repair Kit for Smiths Jaeger 4" Instrument Gauge, (Speedometer or Fuel/Temp/Charge Cluster). Kit includes the 4" Diameter Glass, Black Bezel, Inner...

Brake Pad Retaining Kit Axle Set. OEM.For Front Vented Rotors on Defender, Discovery 1 and RRC.Supersedes BB-RTC6799, BB-STC8575.

Housing for Door Lock Knob. For Defender 1987on, and Range Rover Classic from VIN: FA351847 on. For a Complete Kit of all 3 Parts, see DP-DA2499Kit...

Wiring Harness for Fuel Injection. aka: Injector Wiring Harness.TD5 Defender and Discovery 2.

Felt Ring for Hand Brake and Clutch Cross-Shaft Bearings.For Series 2-2a Clutch, (2 Required), and Series 1-2a Left Hand Drive Handbrake Lever Shaf...

Land Rover Genuine Grill Badge Green/Gold Oval,Clips onto the Original Defender Plastic Grill 1983-2016.

Gasket for Exhaust Manifold to Y-Pipe V8 and Dsl OEM.Fits EFI V8 engine 3.5, 3.9, 4.0, 4.2 and 4.6L. 2 Typically required.

LED Headlamp Black 7" H4 with Angel Eye Ring Daytime Running Lights, and Amber Turn Signals.Fits Series 1-3, Defender, and RRC. PAIRLamps have the ...

Door Seal 1-Piece Push-On for Front Right Hand Door.For Late Series 3, and all Defenders.

Fuel Filter for 200 Tdi and 300Tdi.Fits Defender, Discovery1 and RRC.Quality Aftermarket.

Bulbs 12v Stop/Tail Lamp 2-Pack by Ring

Steering Drop Arm (Pitman Arm) for Left Hand Steering.3 or 4-Pin Adwest Manual or Power Steering Box.Left Hand Drive Defenders, 1983-2016.

Lucas Fuse Panel for Series 2/2a 2-Fuse Unit with Lid 1966-71 For the Earlier single fuse panel see BE-219078 (linked below left). For the later Se...

Fuel Filler Cap Locking Vented 2-Lug Black. For Defender 1986 to 98.For Non-Locking, See EF-NTC2757 (linked below left) Not for NAS 1993-97 Defende...

The Defender's front mudflap for the right-hand side. Fits the 90, 110, and 130. Plain black... no logo, no fuss. Matching left side is MF-LR055333.

The Defender's front mudflap for the left-hand side. Fits the 90, 110, and 130. Plain black... no logo, no fuss. Matching right side is MF-LR055323.

Front Spring Shackle Plate Plain (1956-1984) 88"/109"

Oil Filler Cap for Series 3 2.25L Eng 901, 904 Suff C-D and 2.6L Also Used on many North American Standard Series 3's upto 1974 with EGR.