Best Selling Products

Front Crankshaft Oil Seal Fits, Series 1, 1.6 and 2.0L Series 2, 2a, and 3, 2.25L 4Cyl and 2.6L 6Cyl Defender, Discovery 1 and RRC, 2.5L NA Diesel,...

Front Side Light Assembly, Clear Wipac GenuineClear 2-3/4" Diameter Euro-Style Plastic LensFor Series and Early Defenders with bullet connections.

Replacement Footwell with Pleats Right-Side for Left Hand Drive Series 2 to 3 Bulkhead Supplied in 2 Pieces, ready for riveting or welding.

Replacement Footwell with Pleats Left-Side for Left Hand Drive Series 2 to 3 Bulkhead Supplied in 2 Pieces, ready for riveting or welding.

Fan Belt Alternator 2.5P/D/TD 200TDI 90/110

Felt Seal for Output Shaft on Gearbox. OEM. Series 2a-3. Not typically used on Series 1's, 2's or early 2a's.

Exhaust Hanger Bracket Kit (2 Brackets) for Right Exit System 86/88" 1954-84 Pre-assembled, ready to bolt into position. Please check your chassis ...

Fan Belt for 2L Diesel, Series 2 2.25L 1958-61, & 2.6L FC LR

Door Seal 1-Piece Push-On for Right Hand 2nd-Row Door.For Late Series 3, and all Defenders.

Door Switch for Dome LightOEM, Front and Middle Doors, Defender up to 2016, RRC.For Rear Safari Door Switch, see BE-PRC8548 (linked below).

Drive Flange for Differential 4 Spline Type Rover Differential.Uses Castle Nut AD-3259 and Cotter Pin AD-PS608101L (linked below). You might need a...

Drive Flange Member 10-Spline Series 1-3 1948 to June 1980.

Door Rubber Sold by the Meter (Glue-On) Series 2-3

Distributor for 2.25L and 2.5L Engine - 45D4 Type Points.Complete with Rotor, Cap and Points. This is the later 45D type, suitable for all 2.25L en...

Defender XS Front Grill and Lamp Cover Set.Black with Silver Mesh. Stainless Steel Fasteners Included.Note: The Oval Badge is not Included. Choice ...

Connecting Rod Big End Bearing Set Standard 2.25L Gas/Diesel 1961-84.For Series 2a to 3.Note: Does not fit the Series 2 (1958-61) Engine.

Clutch Flex Hose for Series 3 2.6L 6 Cylinder Engine, 1971-84, and Land Rover 90/100, Defenders with the LT77 Gearbox up to 1994,For Series 3 2.25L...

Clutch or Brake Master Cylinder Adapter 3/8"UNF Male to 7/16" UNF Female.Depending on the purpose, you will require BC-233220 Copper Seal and/or BC...

Copper-Nickel Brake Set Series 2a 4-Cyl 88" SWB LHD 1961-71All Pipes in this kit are 3/16" Copper-Nickel with UNF Brass Fittings.Single Line Brake ...

Brass Drain Plug for Differential, Fuel Tank or Transfer Case.For Series 1-3.Large Slotted Type. Requires Copper Washer GT-FRC4809.For a proper too...

Captive Nut Door Hinge to BulkheadFor Series 3 and Defender up to 1998, and earlier bulkheads repaired with New Door Posts.OEM. These are UNF Threa...

Brake Pipe P-Clamp w/Rubber Grommet for 3/16"/1/4" Pipe Package of 10.

Brake Pad Retaining Kit RearDefender 90 AllDiscovery 1 1994-99,Range Rover Classic 1987-95

Brake Rotor Front Vented 90/110 LA(94on), D1, RRC (FTC902)

Brake Caliper Rear Defender 110/130 LH to 1A614447 (roughly 1994-2001)

Bolt Kit Axle Set, for SC-DA3169 or SC-DA3181 Swivel Ball Housing Kits.Includes all Fasteners required for the Seal Retainer to the Swivel Hub, Fro...

Bolt 3/8" BSF x 1 19/32" for Drive Flange Member. OEM. These bolt both the front and the rear drive flanges to the hub assemblies. You will need s...

Bleed Screw for Front Calipers 90/110 and D1

Bolt ACME for Front Wing to Bulkhead S 2-3, 90/110 Zinc. OEM.

Our third of three sticker packs to show off your 3BCR loyalty. Each Sticker Pack contains 3 individual stickers. Sticker Pack 3 contains 1 Circle ...

Accelerator Pedal Pad Defender 1999on

2.25L 4 Cylinder Ignition Lead Set For Late 2a, Series 3, 1970-84. OEM.Shorter Ignition Coil to Distributor Wire, for Coil located on Right Hand s...

Battery Hold Down Frame for Series 1-3. For the J-Clamp Rods, see FS-562953L, or FS-562953Kit (linked bleow).

Automec Small Pipe Bender Tool for 3/16" Copper-Nickel Pipe Great tool for making the right bends when installing any of the 3/16" kits.

Rubber Neoprene Foam Seal Gasket for Steering Column. Series 1 to 2a, 1954-71. Supersedes SC-303995. Quality Made from Neoprene Foam Rubber. Made i...

The world’s first LED interior lamp replacement designed specifically for the Land Rover Defender. Plug & Play connection. Fixings are supplied...