Best Selling Products

2.25L 4 Cylinder Ignition Lead Set Series 2a 1961-70 Push-In.Lucas Original. Longer Ignition Coil to Distributor Wire, for Coil located on Left-Han...

Gasket for Inlet Manifold to Phenolic Block and Block to Carburetor or Adapter. For Series 2-3, 1958-84 Two Required for Solex Carburetor, Two Requ...

Hose for Air Cleaner to Carburetor Elbow on 2.25L and 2.6L With Stainless Steel Clamps - Ready to Install. Series 2 to 3. For the same Hose without...

Blanking Plug/Grommet for Bell HousingSeries 1, 2 and 2a to 1963

Fuel Pipe Tank to Pump 88/109 Forward Tank Series 2-3 1958-84 For the Fuel Line that runs from the Pump to the Carburetor, see EF-557432, (for Sole...

Wire Grommet for Frame Harness in Chassis.For Series 1 to 3, 1948 to 84.Note: Typically you need 2, one at each end...1 5/8"OD, 1 1/4"panel-hole, 1...

Wheel Stud Series 1/2/2A 1948-1970 Push-In Type Note: You are purchasing 1, not 10 as shown in the photo.

Zenith 361V Carburetor Overhaul Kit 4Cyl Series 2a-3 frm 1968

Transfer/Low Range Lever Grommet (Rubber Boot).Series 1-3 1953-84.Supersedes BG-303821.

Rear Crankshaft Oil Seal Kit with Retainer Halves Fits,Series 1 and 2 2.0L Diesel, 1957-59.Series 2, 2a, and 3 3 Bearing 2.25L Engine, 1958-84.Ser...

Made from heavy-duty water-resistant nylon this shoulder bag features two embroidered and three felt appliqué patches. Felt appliqué with embroider...

Our vintage Land Rover ‘Field Service Kit’ is constructed in durable nylon with webbing straps, 2 layer felt appliqué LR Badge and two woven patche...

Knob for Transfer Lever (Red) Series 1-3 1953-84

Hub Cap Black Defender from 1994, Discovery 1, and RRC from 1986.

Hose for Air Cleaner to Carburetor Elbow on 2.25L and 2.6L Series 2 to 3. For the same Hose with Stainless Steel Clamps, see EF-517093K (linked bel...

Dimmer (High-Low Beam), Dip SwitchFloor Mounted Rear-Connections.Series 1 to 2a.Supersedes BE-232026, Lucas 31372A.

Brake Adjuster Kit.Contains Parts to do 4 Adjusters. Does both Axles for 80"/86"/88" from 1948 up to June 1980. 6 Adjusters required for 88" from J...

Axle Breather Valve Series 1-3 1948-84, and Range Rover Classic.

Gasket for Exhaust Pipe 3-Hole. Fits Defender TD5 1999 to 2006. Fits Defender V8, and also used on V8's in Range Rover Classic, Discovery 1, Discov...

Rubber Seal for Valve Cover Dome Nut 2.25/2.6L Engine

Bolt for Caliper M12 x 35mm (1.25" fine thread) . Fits Defender Front and Rear, 1994 onward. Discovery 1, Discovery 2, RRC, and RR-P38. Check your ...

Seal for Windshield Glass and Rear Safari Door.For Series 2 to 3 Windscreen Glass, 1958-84, and Rear Safari Doors on Series and Defender 1958-2001....

Pair of Mirrors 8" x 5" and Arms for Door Hinges. For Late Series or Defender. Necessary hardware included. For a single Mirror, see GM-MTC5217 (li...

Rubber Seal and Aluminium Channel for Sliding Door Windows, Series 2-3.Used on Front and 2nd Row Doors, Side Sliding Window Panels, and Pick-Up Cab...