Best Selling Products

Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84

Interior Rearview Mirror for Series 2-3 with Hardtop, 1958-84. For Series 2-2a you require 2x FS-AD606041L to fasten (linked below left). For Serie...

Inlet and Exhaust Manifold Stud Fastening Kit - 4 Cylinder 2.25L Gas Complete Kit of Correct Studs, Bolts, Nuts, and Washers for Mounting both the...

Ignition Coil Non-Resistor Type, 4 and 6 Cylinder 1967-84. Can be used on earlier models, if you have a push-in ignition lead. Used on Positive or ...

Gasket for Fuel Sender Unit Gas Tank Series 1-3 (Fiber)

Genuine Set Wipac Lights for Series 2, 2A or 3 and Early Defender up to 1994.Light Kit. European Style, OEM, 73mm, 2-3/4" Lamps with bullet connect...

Gasket Set for Bottom Overhaul - 4cyl 2.25L Gas.If you are taking on a complete engine overhaul... a) good for you, and b) use this with EG-STC1567...

Locking Hasp for Fuel Cap, (Gas or Diesel).Fits Series 2-3. (Fuel cap not included).

Front Grill for Defender 90/110/130 Black Plastic.

Fuel Filler Tube Hose for 88" & 109" Regular Side Tank with Clamps.For Series 2-3 88" and 109" Side Fuel Tanks.

Fuel Tank Fitting Kit for 88/109R Side Fuel Tank (552174)

Delphi OEM Wheel Cylinder Right Hand for Rear 10" Brakes.For Series 1, 2, 2a and 3, 86" and 88" 1954 to June 1980.

Delphi OEM Wheel Cylinder Right Hand Front 10" Brakes on Series 1, 2, 2a and 3 86"/88" 1954 to June 1980 Rear 10" Brakes on Series 3 88" from J...

Defender Bumper Stainless Steel Bolt Kit with Tap Blocks and Black Caps.

Clamp Ring for Fuel Sender For 109 Station Wagon, Defender Side and Rear Tank to 1998. For Rubber Seal, see EF-ARA1502L (linked below).

Breather Hose for Side or Rear Fuel TankFor 88" and 109" Series 2-3, and Defender up to VIN: MA159806, (1983-98)Can also be used for the 109 Rear T...

Brake Pad Retention Pin Kit for Solid Rotors DefenderUsed with Springs Kit BB-STC8576 (linked below).

Brake Pad Retaining Spring Kit for Front or Rear Solid Rotors.Used with Pins Kit BB-RTC5001 (linked below).

Brake Servo Booster Assembly for Late Series 2a and 3.Supersedes BB-569338 and BB-AEU1043.

These are the fasteners necessary for fitting the bumper end caps (CP-DPT100070) on the Defender. You'll need four per cap, so eight in total. The...

Copper Seal for Radiator Drain Plug or Drain Tap and 2.25L Engine Block Drain Plug or Drain Tap.</p>For Series 1-3.

Brake Pad Retaining Kit Axle Set. OEM.For Front Vented Rotors on Defender, Discovery 1 and RRC.Supersedes BB-RTC6799, BB-STC8575.

Battery Hold-Down J-Clamp Kit

Housing for Door Lock Knob. For Defender 1987on, and Range Rover Classic from VIN: FA351847 on. For a Complete Kit of all 3 Parts, see DP-DA2499Kit...

Oil Seal for Steering Relay Series 1-3.2 Typically Required, one at the top, one at the bottom.If you are taking your Steering Relay apart, Be Very...

Felt Ring for Hand Brake and Clutch Cross-Shaft Bearings.For Series 2-2a Clutch, (2 Required), and Series 1-2a Left Hand Drive Handbrake Lever Shaf...

Lucas Ignition Contact Points Fixed for Series 1 to 3, 1954-76.Fits Series 1 Late Lucas DM2 LU 40504A Distributor, Series 2 to 3 Lucas 25D4 and 25D...

LED Headlamp Black 7" H4 with Angel Eye Ring Daytime Running Lights, and Amber Turn Signals.Fits Series 1-3, Defender, and RRC. PAIRLamps have the ...

Door Seal 1-Piece Push-On for Front Right Hand Door.For Late Series 3, and all Defenders.

Fuel Filter for 200 Tdi and 300Tdi.Fits Defender, Discovery1 and RRC.OEM, Coopers Fiam.

Fuel Filter for 200 Tdi and 300Tdi.Fits Defender, Discovery1 and RRC.Quality Aftermarket.

Hose Connector for Zenith or Weber Carburetor to Air Cleaner Elbow For Series 2a-3 1968on, or earlier if converted to a Zenith or Weber Carb. If yo...

Steering Drop Arm (Pitman Arm) for Left Hand Steering.3 or 4-Pin Adwest Manual or Power Steering Box.Left Hand Drive Defenders, 1983-2016.

Lucas Fuse Panel for Series 2/2a 2-Fuse Unit with Lid 1966-71 For the Earlier single fuse panel see BE-219078 (linked below left). For the later Se...

Front Spring Shackle Plate Plain (1956-1984) 88"/109"