Best Selling Products

Hose LH Valve Cover to Plenum V8 D1, RRC, P38, Def

Hose Oil Rocker Cover to Oil Drain 300Tdi Def, D1, RRC

Hose Oil Breather/Cyclone to Cleaner 300Tdi Defender

J-Bolt for Battery Clamp.Fits Defender up to 1990, (after use FS-STC307 to 1998, '99 on uses FS-YJJ100070), and for Optional Battery.See FS-MUC7513...

J-Bolt for Battery Clamp Defender 1990-1999. OEM.

Intermediate Gear Shaft for Series 1-2a. Up to Gearbox Suffix A; 1948 to September 1962. Supersedes GT-219470 GT-267794. For later shaft, see GT-59...

Interlocking Plunger for Gear Selector Shafts

Inspection Cover Plate Gearbox Selectors.For Series 3 1971-84 LT76 Gearbox.

Hose Clamp 40-60mm (1-1/2" - 2-3/8") for Turbo Hoses.For 200Tdi, 300Tdi and TD5 OEM. Defender, Discovery, and RRC.

Hose Clamp 7/16" - 1" Diameter x 1/2" Bandwidth Stainless for Various Uses

Hose Clamp 7/16" - 1" Diameter x 5/16" Bandwidth Stainless for Various Uses

Hose Clamp 11/16" - 1-1/2" Diameter x 1/2" Bandwidth Stainless Various Uses

Hose Clamp 1/2" - 1-1/2" Diameter x 5/16" Narrow Bandwidth Stainless Various Uses.

Hose Clamp 3/4" - 1-3/4" Diameter x1/2" Bandwidth All Stainless Various Uses.

Hose Clamp 1-3/8" - 2-3/8" Diameter x 5/16" Narrow Bandwidth Stainless Various Uses.

Hose Clamp 2-1/2"-3-1/2" Diameter x 9/16" Bandwidth Stainless for Various Uses.

Key Blank Series 2a-3 Door & Upper Tailgate Latch FP Type

Intermediate Pipe Series 1 86/88 2.0L Gas 54-58 and 88 Diesel 57 to 09-73 Fits: Series 1 2.0L Gas 1954-1958; Series 2 2.25L Gas 1958-60 Series 1, ...

Hub Lock Washer For Defender Rear Axle from Axle 22S08283B to VIN: KA930455, (1993). For earlier Rear or Front Hubs, see AD-217353 (linked below le...

Hub Bearing and Oil Seal Kit. Defender Rear up to 1993 OEM

Terrafirma Heavy-Duty 1-Piece Single-Mass Flywheel and Clutch Kit for the TD5.Heavy-Duty One-Piece Flywheel, Clutch and HD Release Bearing; Designe...

Heater Blower Motor and Fan for Left Hand Drive Defender, OEM. Up to 1994, VIN LA939975

Head Gasket Set Defender 2.5L Turbo Diesel.With Head Gasket.

Heavy-Duty Clutch Fork and Install Kit for LT77 and R380 4 Cylinder. Notes: Also includes the Flywheel Bushing. Fits Defender 4 Cylinder to 1998, R...

Horn Relay for Range Rover 1995 to 2002 (Yellow) LRGenuine

Hazard Switch Rocker Illuminated for 90/110/130 upto '06 BP

Headlamp Guards Front Fixed-Type Series/Defender Pair

Heavy-Duty Rubber Mats Foam-Backed Defender with the LT77 Transmission.RH and LH Pair. Defender up to 1993Contains BTR7895 and BTR7896.

Hinge Stop Assembly Reverse Gate Assy 1948-79 LR Gen

Hose Clamp 1" - 2" Diameter x 5/16" Narrow SS Band Steel Screw

Hose Clamp 1-1/2" - 2-1/2" Diameter x 1/2" Bandwidth Stainless Various Uses

Heater Control Valve, Brass for Series 2, 2a 1958-71. The Copper Seal needed for this is CS-243959 (linked below).

Heater Hose Inlet Defender TD5 LHD

Heater Hose Inlet V8 Carb RRC, Defender, D1 V-GA449988on

Heater Hose Matrix Inlet to Pipe RRC 87-94, D1 89-98

Heater Hose Matrix Outlet to Pipe RRC 87-94, D1 89-98

Heater Hose Return Defender Right Hand Drive 300Tdi.

Heater Hose Inlet Defender 90/110 RHD 300Tdi

Heater Hose Inlet Defender Left Hand Drive 200Tdi up to 1991 (to VIN: HA700725) For later 200Tdi, see HS-BTR1133 (linked below).

Heater Hose Thermostat Bypass RRC 78on, EFI D1, 90/110

Heater Hose Pump to Pipe RRC V8 Carb Eng Suff D on

Heater Hose Water Pump to Heater Pipe RRC/D1 EFI V8

Heater Hose Maniifold to Heater Pipe RRC 87-94, D1 to MA

Heater Hose Outlet Defender TD5 LHD

Heater Defrost Hose Kit 1-1/4" Black Neoprene Hose with Clamps. For Right Hand Drive Series 1 and 2 Smiths Heater. These Hoses are the real thing; ...

Heater Defrost Hose Kit 1.5" Black Neoprene Hose with Clamps. For late Series 2a and Series 3 Left Hand Drive with the Smiths Heater, (2-piece heat...

Heater Hose Oulet V8 Carb RRC 1986-91, D1 1989-98

Heater Blower Control Assembly. For LHD Defender 90/110/130 from 1983 to 1994. For Later, (1995 to 2001), use this Control Assembly and Wiring Harn...