Defender Hardware

Swivel Hub Grease Sachet, 370 grams, sufficient for 1 swivel hub. Perfect solution for those leaky swivels. Not recommended if you wade through wat...

Everything you need to affix your door cards properly to your door.This kit does one door, either front, or middle, not the rear safari doors.That'...

Castle Nut for Halfshaft, Output Shaft and Differential Pinion.Requires Cotter Pin AD-PS608101L and Flat Washer AD-571922.

Hinge Bushing for Hood (Bonnet),For Series 2a-3, 1972 on, Defender through to 2016,

Bolt for Caliper M12 x 35mm (1.25" fine thread) . Fits Defender Front and Rear, 1994 onward. Discovery 1, Discovery 2, RRC, and RR-P38. Check your ...

Stainless Steel Front Vent Hinge Pin Kit (Set of 4) Notes: For Welded On Hinges. 4 Required per Bulkhead. For Series 2-3 and Most Defenders to 2007...

Rubber Seal for Fuel Sender UnitFor 109 Station Wagon, Defender Side and Rear Tank to 1998.For the Twist Clamp, see EF-ARA1501L.

Mounting Pad between Rear Tub Floor and Cross-Braces6 Required for Series 1-3 86"/88" and Defender 90 8 Required for Series 2-3 109" Station Wagon ...

Battery Hold-Down J-Clamp Kit

Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed EndPackage of 10

Clamp Ring for Fuel Sender For 109 Station Wagon, Defender Side and Rear Tank to 1998. For Rubber Seal, see EF-ARA1502L (linked below).

These are the fasteners necessary for fitting the bumper end caps (CP-DPT100070) on the Defender. You'll need four per cap, so eight in total. The...

Stainless Steel Antiluce Pin Kit for TailgateFor Series and Defender.Shiny Pair.

Hinge to Door Screw 2" Long for Series 3 and Defender Hinges up to 2006, OEM This is the longer screw that holds the Hinge to the Door. For the sho...

Defender Bumper Stainless Steel Bolt Kit with Tap Blocks and Black Caps.

Staple for Hood Strap on Rear Tub and on Windscreen Rail.For Series and Defender.You are Purchasing 1, not 10 as shown in photo.

Propshaft Bolt and Nut Kit for One Rear Propshaft OEM. For Defender, Discovery 1, RRC, and RR P38.

Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed End, Aluminium Stem. For a Package of 10, see RV-78248-10 (linked below).

Headliner Fir Tree Fasteners Light Grey Various UsesDefender, Discovery 2, RR P38

Striker for Anti-Burst Door Handle Defender 90/110/130 from AA270227(1987). OEMAll Front and Middle-Row Doors. Not for the Rear Safari Door.

Spire Nuts for Floor Screws and Other Uses Package of 10

Nut Spire for Front Wing to Bulkhead Series 2-3, 90/110

Bolt ACME for Front Wing to Bulkhead S 2-3, 90/110 Zinc. OEM.

Trim Ring for Manual Window Handle Defender Black

Key Blank Ignition Defender 1987-2017.All Defenders with Steering Column Lock.Aftermarket.Supersedes KB-STC4798, KB-AAU8276.

Captive Nut Door Hinge to BulkheadFor Series 3 and Defender up to 1998, and earlier bulkheads repaired with New Door Posts.OEM. These are UNF Threa...

Front Wings to Bulkhead Fastener Kit.For Series 2, 2a and 3, and Defender.

Stainless Steel Bolt Kit for Bonnet Hinges.For Series 3 and Defender.

Bolt Kit Rear Suspension Trailing Arms and A-Frame Bolts. For Defender up to VIN: YA159807 (1999), Discovery 1, and RRC. For Imperial Bushings. For...

Propshaft Bolt and Nut Kit for Front Propshaft. OEM. For Defender, Discovery 1, RRC, RR P38.

Set of 2 Stainless Steel Door Hinge Pin Kits For Series 2-2a, 1958-71. Does One Door. Front, Middle, or Rear 2-Hinge Safari Door.

Front Door Window Handle Crank Black. For Defender from LA932528, (1994 on). For the Clip that holds this to the Regulator, see DP-BNP4556L. For th...

Hinge to Bulkhead Screw 1.5" Long for Series 3 and Defender Hinge, OEMThis is the shorter screw that holds the Hinge to the Bulkhead. For the longe...

Rope Tie-Down (U-shape) on Rear Tub for Canvas Top. OEM.Zinc Coated. For Series 1-3 and Defender. Requires 2 Rivets, RV-RU612373.

Bolt For Disc (Rotor) to Hub Defender, RRC, D1 OEM.Normally 5 required per side.Supersedes: BN-AFU1180, BN-FTC1368, BN-UYG500030.

Floor Screw Acme Thread Series 1-3 and DefenderFor a Package of 10 Floor Screws see FS-320045-10 (linked below left), or a Package of 10 Screws and...

Bolt for Drive Flange Member. OEM.For Defender from VIN: LA930456 (1994on), Discovery 1 1992on, and RRC.With LocTite on Ends. For the Flange AD-RUC...

Tailgate Hinge Kit for Series or Defender Bolt to Rear-Cross. OEM.

Plastic Clip for Bonnet Prop Single on Discovery 2 and Defender from 1998-2106 OEM

Stainless Steel Front 2-Door Bolt Kit For Series 3 88" and 109" Regular or Truck Cab, Defender 90 and 110 Regular and Truck Cab. Includes Allan Key...

Stud M10 x 35mm for Exhaust Manifold 300Tdi Defender OEM.For the Nuts to go with these, see BN-FX110047L.

Bolt for TD5 Damper and Flywheel - Manual Gearbox OEM Note: You are purchasing 1, not 8 as shown in the photo.

Plastic Nut Sert for S3/90/110 Head Light Bezel to Front Wing. OEM.The screw required when mounting the Head Light Bezel is FS-AB608047L.

Plastic Nail Trim Clip for Dash Panel Defender. OEM.Note: You are Purchasing 1, not 10 as shown.

Plastic Lockut Nut for Grill to Radiator Series 3, Defender, Dash, Wing Vents, Various Uses OEM Note: You are purchasing 1, not 10 as shown in the...

Screw for Fuel Pump Pickup or Return Defender/RRC Steel Tank OEM

Washer Spring Lock for Fuel Pump, PickUp Tube & Fuel SenderFits Defender and RRC Steel Tanks.