Aftermarket

Weather Seal and Filler Strip for Alpine Windows and Rear Cat-Flap Window. Series 1-3 1948 to 84 and Defender to 1989; With 5mm Thick Glass.   Does...

Wheel Cylinder Left Hand for Rear 10" Brakes.For Series 1, 2, 2a and 3, 86" and 88" 1954 to June 1980.

Toggle Switch for Dash, Interior, Wipers, and Other Uses.Single Pole Single Throw. Series 1-3.

Thermostat 4 Cylinder 2.25L 82C Degree Winter Thermostat,For Series 2a-3 Eng Suff D-on, (March 1963-84.This is the Shouldered Type that fits Top T...

Stainless Steel Front Vent Hinge Pin Kit (Set of 4) Notes: For Welded On Hinges. 4 Required per Bulkhead. For Series 2-3 and Most Defenders to 2007...

Steering Relay Assembly, Series 1-3For a Kit of the Relay to Chassis Bolts, see SC-SRELBNKIT.

Smiths/Jaeger Speedometer Assembly KPH for Series 1-2a, 1954-67.Calibrated for 88" or 109" using 16" Tires, (7.50x16 or 235/85 r16, 880 TPKM). Kilo...

Rubber Seal and Aluminium Channel for Sliding Door Windows, Series 2-3.Used on Front and 2nd Row Doors, Side Sliding Window Panels, and Pick-Up Cab...

Rubber Seal for Fuel Sender UnitFor 109 Station Wagon, Defender Side and Rear Tank to 1998.For the Twist Clamp, see EF-ARA1501L.

Rear Crankshaft Oil Seal, someimes referred to as the Rear Main SealFits,Series 1 and 2 2.0L Diesel, 1957-59.Series 2, 2a, and 3 3 Bearing 2.25L E...

PAIR of Rear Axle Re-Bound/Check Straps Extended Length for 86/88"Particularly perfect for Parabolic Springs, which raise the car 1 to 2 inches.

Radiator for 4-Cylinder Series 2a-3 1968-84 3-Row Copper Core. Can be used on earlier Series 2-2a, 1958-68. You must replace rad hoses with later S...

Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed EndPackage of 10

Pair of Mirrors 8" x 5" and Arms for Door Hinges. For Late Series or Defender. Necessary hardware included. For a single Mirror, see GM-MTC5217 (li...

Hub Spanner Wrench for Hub Locking Nut 2-1/16" 52mm. For locknut FRC8700.

Hub Cap - Series 3 from October 1983 (black plastic). Land Rover 90/110, and Defender to 1993. From 1994 onward, you'll want FTC5414 (linked below).

Grommet for Bell Housing Clutch Shaft Series 1-2a 1952-67 Up to Gearbox Suffix D April 1967. For the later Grommet, see BG-553262 (linked below).

Gasket Paper for Swivel Hub to Axle Case 1948-1984

Fuel Filler Tube Hose for 88" & 109" Regular Side Tank. For Series 2-3 88" and 109" Side Fuel Tanks See EF-543764K for Hose with Clamps (linked...

Door Seal 1-Piece Push-On for Front Left Hand Door.For Late Series 3, and all Defenders.

Cotter Pin for Halfshaft Nut, Rover Differential Flange, and Output Shaft. OEM. Note: You are purchasing 1, not 10 as shown in the photo.

Cunifer Pipe Reservoir to Brake Master Cylinder, 88 and 109, 1958-67. Copper-Nickel 1/4" pipe for use on; Series 2 and 2a, 88" SWB or 109" LWB, f...

Complete Set of Lights for Series 2, 2A or 3 and Early Defender to 1994.European Style, 73mm, 2-3/4" Lamps with bullet connector wiring, including ...

Clutch Slave Cylinder OEM TRW Series 3 1971-84, (Slave is on the Left Hand side of the transmission), Land Rover 90/110 4 cylinder and Defender LT7...