Aftermarket

Upper Brake Spring for 10" Shoes. For use on;Series 1 to 3, Front 80", 86", 88", and 107" with 10" Front Brakes up to June 1980. Series 1 to 3 Rear...

Exhaust Manifold Stud for 1.6/2.0/2.25L 4 Cyl Gas or Diesel For Manifold to Exhaust Down Pipe

Steering Relay Assembly, Series 1-3For a Kit of the Relay to Chassis Bolts, see SC-SRELBNKIT.

Service Kit for 300Tdi Oil, Air, Fuel Filters, Washers

Radiator for 4-Cylinder Series 2a-3 1968-84 3-Row Copper Core. Can be used on earlier Series 2-2a, 1958-68. You must replace rad hoses with later S...

Radiator Top Hose Series 2 and Early 2A. 1958-1968. Petrol and diesel.

Oil Filter for Series 1 2.0L Spreadbore Engine and Series 2a/3 6 Cylinder.Aftermarket.

Nut 3/8" UNF Nylon Self-Locking for PropShaft and Other uses.

Mounting Pad between Rear Tub Floor and Cross-Braces6 Required for Series 1-3 86"/88" and Defender 90 8 Required for Series 2-3 109" Station Wagon ...

Inspired by 1940s era military attire, our Land Rover coveralls are a versatile classic made for adventure. Durable cotton with a perfect amount of...

This large travel bag is the flagship of the inaugural collection made in durable yet lightweight nylon with webbing straps.One embroidered and thr...

Lock Nut for Hub Bearing Front or Rear.For Series 1-3, Defender, Discovery 1 and RRC, from 1948 through to 1998.OEM Quality.Supersedes AD-217355, A...

Ignition Coil Non-Resistor Type, 4 and 6 Cylinder 1967-84. Can be used on earlier models, if you have a push-in ignition lead. Used on Positive or ...

Hub Cap - Series 3 from October 1983 (black plastic). Land Rover 90/110, and Defender to 1993. From 1994 onward, you'll want FTC5414 (linked below).

Gearbox Mounting Rubber with Nuts.Series 1 Engine Mounts from 1954 to 1958 and Series 2/2a/3 Gearbox Mounts from 1958 up through 1984.

Gasket Paper for Swivel Hub to Axle Case 1948-1984

Gasket OEM Paper for Oil SumpFor 4 cylinder 2.25L and 2.5L Gas, 2.0L and 2.25L Diesel.Supersedes EG-247088G.

Fuel Pump Rebuild Overhaul Kit for Series 2-3 Notched Stem Shaft. This will NOT work with Slot-Type shaft fuel pumps. See second photo for more det...

Flasher Unit for Turn Signal 3-Pin.For Series 1-2a, 1954 - 1971.

Escutcheon for Door Sill ButtonFor Defender 1987on, and Range Rover Classic from VIN: FA351847 1989on.For a Complete Kit of all 3 Parts, see DP-DA2...

Cotter Pin for Halfshaft Nut, Rover Differential Flange, and Output Shaft. OEM. Note: You are purchasing 1, not 10 as shown in the photo.

LED Headlamp Black 7" H4Fits Series 1-3, Defender, and RRC. PAIRLamps have the H4 Plug which plugs right into your standard light wiring harness.DO...

Copper Washer/Seal for Swivel Housing Drain Plug. For Series 1-3, Discovery 1, Range Rover Classic, Land Rover 90/110 and Defenders up until 1994. ...

Complete Floor Bolt Kit 4 Cylinder Series 2-2a 1958-70Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells...