Aftermarket

Stainless Steel Front Vent Hinge Pin Kit (Set of 4) Notes: For Welded On Hinges. 4 Required per Bulkhead. For Series 2-3 and Most Defenders to 2007...

Staple for Hood Strap on Rear Tub and on Windscreen Rail.For Series and Defender.You are Purchasing 1, not 10 as shown in photo.

Steering Rod Kit for Series 2a to 3, 1962 to 1984.Complete with Track Rod SC-NRC132 (43-1/8") and Drag Link SC-NRC4609 (28-3/4"), 2 Left and 2 Righ...

Steering Rod Clamp Kit, (Clamp, Grade 8 Bolt and Philidas All-Metal Lock Nut).For Steering Track and Drag Link Tie Rod Ends. For Series 1 to 3, Def...

Starting Handle for Series Engines, (tool for timing) 1948-84.Make certain that your engine has the starting dog on the crankshaft.You might need t...

Spring for Clutch Pedal Return Series 1 1954-58

Spring Clip for Transfer Gear Change Lever Series 1-3 1954-84

Set of 6 Stainless Steel Door Hinge Pin Kits For Series 2-2a 1958-71. For Two Front and One 2-Hinge Rear Safari Door.

Service Kit for Defender 2.4L & 2.2L Puma 2007 to VIN: DA444246Includes Oil, Fuel and Air Filters, plus Oil Drain Plug with Rubber Seal.

Serpentine Belt TD5 90/110 w/o AC D2 w/oAC w/oACE Dayco

Service Kit for Defender with 2.5NA Diesel and 2.5Turbo Diesel. Includes Oil, Fuel and Air Filters, and Copper Seal(s).

Rubber Seal for Pickup Cab to Tub Bulkhead Series 2 to 3, 88/109, Defender to 1991

Rubber Plug for Cylinder Head Camshaft Front TD5 OEM Defender and Discovery 2 with the TD5 Engine.For the Rear Camshaft Seal, see EP-ERR5369.

Rubber Grommet for Brake Line P-Clamps 3/16"-1/4"

Handbrake Lever Grommet (Boot) for Series 2 and 2a, 1958-66.Note: Hole for Handbrake Lever is Round. For the later Series 2a/3 Grommet with the Ova...

Replacement Headlamp Retaining Ring with Black Bezel.Includes the retaining bezel, mounting ring, clips, screws and 2 adjuster screws.For Defender ...

Rear Safari Door Skin Panel Aluminum for Series 2-3 or Defender up to 2006, (Lower Only).For Upper "Goal Post replacement Skins, see DP-DA3613.

PAIR of Rear Axle Re-Bound/Check Straps Extended Length for 86/88"Particularly perfect for Parabolic Springs, which raise the car 1 to 2 inches.

Radiator Muff for Defender Black w/Black Edging (Britpart Product. Black with Black Trim)

Radiator Hose Kit for Series 1 1948-58 1.6L and 2.0L EnginesIncludes EC-268037 and EC-268038 with Stainless Steel Clamps.

Powerspark Electronic Ignition Kit for Lucas DM2 and 25D4 Distributor. For Series 1 and 2 with the Lucas DM2 Distributor and Series 2a and 3 with t...

P-Clamp for Brake Lines.For Series 1-3 Single or Dual Line 3/16 and 1/4" Pipes.Supersedes BC-50640.

Oil Filter for 200/300TDI 2.5G/D, 2.5TD, V8-Gas

OEM Service Kit for 300Tdi Oil, Air, Fuel Filters, Washers.

Pair of Mirrors 8"x5" and Arms for Door Hinges. For Late Series or Defender. Note: Your Upper Door Hinges must have the two holes to mount the Mirr...

Mirror Head 7" x 5" Each for Series 1 to 3.Fits the Standard Mirror Arm, (post type requiring a clamp to fit the mirror head), GM-DA2128.Typically ...

Red Canoe's Land Rover Heritage wallet features a heavily embossed vintage Land Rover mark in top grain cowhide. Built to last and age with charact...

If you have a roof rack and load it for serious adventure you undoubtedly have a good number of lashing straps to secure all the gear. This light a...

Locker Plate for Swivel Pin Series 1-2a 1948-1962 3/8" StudsYou are purchasing 1, not 10 as shown in the photo.4 Required per Side, 8 per Axle.

Intermediate Pipe and Silencer 300Tdi 110/130

Hub Oil Seal, Leather and Metal. For those that like to keep things more original.Fits Series 1, 1948 to 58, Front Axle. Fits Rear Fully-Floating A...

Interior Rearview Mirror for Series 2-3 with Hardtop, 1958-84. For Series 2-2a you require 2x FS-AD606041L to fasten (linked below left). For Serie...

Inlet and Exhaust Manifold Stud Fastening Kit - 4 Cylinder 2.25L Gas Complete Kit of Correct Studs, Bolts, Nuts, and Washers for Mounting both the...

Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84

Hose for Air Cleaner to Carburetor Elbow on 2.25L and 2.6L With Stainless Steel Clamps - Ready to Install. Series 2 to 3. For the same Hose without...

Hub Bearing and Oil Seal Kit OEM Fits Series 1, 1948 to 58, Front Axle. Fits Rear Fully-Floating Axles on 109", and 88" with the optional full floa...

Hub Oil Seal Series 3 mid-1980on, Defender to '93, RRC to '85. OEM.Defender up to VIN KA930455, (1993), up to Axle No 20L13358B RHS, up to Axle No ...

Corteco OEM Hub Oil SealFits Series 1, 1948 to 58, Front Axle. Fits Rear Fully-Floating Axles on 109", and 88" with the optional full float axles f...

Grommet for Windshield Washer Pump Front or RearDefender 1999on OEM

Good Vibes + Galvanized. What more could you need? The allure of an old Landy isn't just about the truck. It's about what you do with it, what yo...

Haynes Series II,IIA and III Owners Workshop Manual.The Haynes Land Rover Series II, IIA and III Petrol & Diesel Manual features detailed photo...

Hazard Switch Rocker Illuminated.For Defender up to 2006

Gasket for Fuel Pump Side Cover to Engine Block2.25L Engine, Series 2-3

Gasket for Fuel Pump. For 2.5L Naturally Aspirated Diesel, 2.5L Turbo Diesel, 200Tdi and 300TDI. Defender, Discovery 1, Range Rover Classic.

Gearbox and Transfer Case Gasket and Seal Kit For Series 3. Gasket Set with all Seals required for a full tear-down and rebuild. Includes Front/Rea...

Gasket for Fuel Sender Unit Gas Tank Series 1-3 (Fiber)

Glass Fuse 25AMP 12AMP Continuous for Series 1-3 OEM

Galvanized Stays for Rear Sill/Wings PAIR,In Front of the Rear Tires on Series 2-3, 88 and 109". Left and Right Hand.