Aftermarket

Special Stud for Swivel Housing 7/16"BSF Series 2a-3 This Stud has a thicker non-threaded center. 4 Required for Top, February 1962-66. 2 required ...

Spring Clip for Tools behind Front Seats Series 1-3.For tools, like the hand crank, with a diameter up to 5/8".You'll need a rivet for installation...

Series 1, 2, 2a and 3 Rear Mud Flaps Pair.With Brackets. Mudflaps are Plain, No Logo.,For Land Rover Genuine with Logo, see MF-320590LR.

Shock Absorber -Front 86/88 Std PR2 w/Bushings Series 1-3

Service Kit for Defender 2.4L & 2.2L Puma 2007 to VIN: DA444246 (2013). Includes Oil, Fuel and Air Filters, plus Oil Drain Plug with Rubber Seal.

Securon Seat Belt Front Outer or Center Lap or Rear Bench, Static.For Series or Defender.

Rubber Seal for Gearbox Selector Detent Spring 48-84

Replacement Headlamp Retaining Ring with Black Bezel.Includes the retaining bezel, mounting ring, clips, screws and 2 adjuster screws.For Defender ...

Push-Button Starter Switch Series 1-2a, 1948-1966. Note: This Does Not include the Knob. Use your original, or see BE-605280 (linked below). Supers...

Radiator Top Hose Series 2 and Early 2A. 1958-1968. Petrol and diesel.

P-Clamp for Brake Lines.For Series 1-3 Single or Dual Line 3/16 and 1/4" Pipes.Supersedes BC-50640.

Oil Filler Cap for Series 3 2.25L Eng 901, 904 Suff C-D and 2.6L Also Used on many North American Standard Series 3's upto 1974 with EGR.

Oil Sump Gasket for TD5 Defender, Discovery 2

Oil Pan Sump Drain Plug for TD5. For Defender or Discovery 2 with the TD5 Engine. Requires copper washer CS-CDU1001L (linked below).

Nut 1/4" BSF for Various Uses. For the Swivel Lock stop Bott, Yellow 4WD Knob, 4WD Clevis Assembly, Transfer Case Bottom Cover, Series 1 2.0L Intak...

The good old standard lug nut. This is a 16mm wheel nut (metric, my American friends). Fits the Series 3 from 1971 through 1984, Defender, and Di...

Lucas L841 Rubber Base for Side Marker Lamp.For Late Series 2a and Series 3 North American Standard.

Rebuild Kit for CB-Type Master Cylinder BB-520849.For Series 2 and Early 2A 88" Short Wheel Base.

Brake Shoes Axle Set 10" Front or Rear. OEM, Mintex.Fits Series 1 80", 86", and 107" Front with 10" Brakes.Series 2-3 88" Front up to June 1980.Ser...

Interior Lamp Metal with Glass Lens. Series 1-3 1956-84. Defender to VIN LA939975, (1995). For later Defender Switched Lamp, see LA-AMR3155 (linked...

Gasket Paper for Oil Sump, aka Oil Pan GasketFor 4 cylinder 2.25L and 2.5L Gas, 2.0L and 2.25L Diesel.Supersedes EG-247088G.

Frost Core Plug 1-7/8" Push-In Cup for 2.0L, 2.25L, and 2.5L Gas or Diesel (Side Plugs)Series 1 2.0L uses 4. Series 2-3 2.25L uses 3.

Fuel Filler Cap Locking Vented 2-Lug Black. For Defender 1986 to 98.For Non-Locking, See EF-NTC2757 (linked below left) Not for NAS 1993-97 Defende...

Front Spring Shackle Plate Threaded 9/16" UNF.Inner Shackle for Series 2a-3, 88" and 109", From March 1963, Suffix B on.

Exhaust Manifold Stud Kit (3 Studs, locks, & brass nuts) 2.25L Gas 61-84 For Mounting Down Pipe to Manifold. (These are included in the Comple...

Exhaust Hanger Bracket Kit (3 Brackets) for Left Exit System 86/88" 1954-84 Pre-assembled, ready to bolt into position. Please check your chassis f...

This is a rubberized end cap for the Defender's front bumper.Fits either side on the standard bumper starting in 1984 all the way through the end o...

Cylinder Block Freeze Plug KitFor Series 2a-3 2.25L Gas or Diesel and Defender 2.5L Gas or Naturally Aspirated Diesel.Note: for Series 3 1972on 2.2...

Copper-Nickel Pipe, (will not rust), with Brass Fittings for use on;Series 2 and 2a, 1958 to 1971 with separate Brake/Clutch Reservoir Canister.1/...

Clutch Release Bearing Series 1 to 2A, 1948-71Used for both 9" and 9-1/2" Clutch. 2.25L and 2.6L NADA.Also used on Front Output of LT230 for Defend...

Service Kit for Series 2A/3 - 1964 onwards with Lucas 25D distributor with fixed points Will not fit vehicles fitted with a Ducellier distributor...

Bulb 12v for Stop/Tail LampFits Series, Defender, Discovery 1, Discovery 2, RRC, and RR P38

Axle U-Bolt Rear with NutsFor Series 1-3 86/88, 107/109 to end of 2a, Rover Axle4 Required.

9.5" Clutch Plate Optional 1964-71, Standard 1970-84 Late 2A, Series 3 Optional 9.5" Clutch used on NADA Gas/Dsl 88 and 109, 1964-71. Standard on D...

If your fuel cooler starts leaking on your Td5 Defender (or imported Discovery) this kit can be an economical fix may save you from replacing the e...

Oil Pan Sump Drain Plug for 2.0L and 2.25L Engines. Series 1-3. 3/8" BSF Thread. Supersedes EP-3088. You May Require the Copper Seal, CS-243959 (li...