Aftermarket

Coupler Drive Gear for Lucas DistributorSeries 2a upto 1967

Copper Nickel Pipe Reservoir to Brake Master Cylinder.1/4" pipe for use on Series 2a 109" Single Line Brake Systems, from Suffix F, March 1967 with...

Cylinder Head Bolt for TD5 Engine 12 Required Defender and Discovery 2 with TD5. For a Full Set of 12, see EP-ERR5384Kit (linked below)

Copper-Nickel Pipe Set Series 3 109" Dual Line LHD with Servo, No Proportioning Valve

Copper-Nickle Brake Line Set Defender 90 1985-91 LHD

Copper-Nickel Brake Set Series 2a 4-Cyl 109" LWB LHD 1961-71All Pipes in this kit are 3/16" Copper-Nickel with UNF Brass Fittings.Single Line Brake...

Black Wheel Nut for Alloy Rims. Fits Defender, Discovery 1, and RRC. Note: These are for the Alloy Rims, not Steel Rims. For a Set of 20, see AW-RR...

Dash End Trim Panel Left Hand Black Plastic. For Defender Left Hand Drive w/o AC. Before buying this, Check out the Raptor Steel replacements! BE-R...

Stainless Steel Bolt Kit for the Defender Bumper.Includes the Black Cover Caps. Does Not include the Special Tap Blocks, see BN-ALQ710040K for a Co...

Defender XS Front Grill and Lamp Cover Set Black Silver Mesh. Note: Fasteners are not included. For Stainless Steel Fasteners, you would need 2x F...

Cover for Differential Rear Salisbury S3 109 Def 110/130>06

Cotter Pin for 24-Spline Series 3 Hubs and 101 Track Rod Ends

Corteco Oil Seal Stub Axle InnerFor Defender from 1994, RRC 1992-94, and Discovery 1

Defender Tailgate Assembly with Hinges, Brackets and Latch Eyes. Has the Cable Retention Brackets. For earlier Series Chain Retention type of Tailg...

Dayco Timing Belt for 2.5NA & 2.5TD

Cylinder Head Complete 300Tdi with Valves and Head Bolts. This head has additional waterways for improved cooling. Use a Multi-Leaf Metal Head Gask...

Crankshaft Damper Pulley for TD5 Defender and Discovery 2 with the TD5Recommended that you also replace the Bolt, EP-LYG101190 (linked below).

Fan Belt for Rover 3.5L V8 w/o AC, w/o PAS

Dayco Belt for A/C Compressor on 300Tdi D1, RRC, Defender

Cup Washer for Instrument Panel to Cowl 90/110. OEM. Note: You are purchasing 1, not 10 as shown in the photo

Defrost Demister Vent Dash Top Cover.For Series 3, 1975 to 84.These are 10.75" wide, adaptable for the early Defender vents, (to 1988), HS-MTC6040,...

Defender - A Celebration of the Best 4 x 4 Vol 2 From the team at Land Rover Monthly, this 228 page magbook celebrates the Defender including vehic...

Series 2a-3 109" LHD Dual-Line w/Valve 1970-80 All Pipes in this kit are 3/16" Copper-Nickel with UNF Brass Fittings. Dual Line System with Propo...

Series 2 88" LHD 1958-1961All Pipes in this kit are 3/16" Copper-Nickel with UNF Brass Fittings.Includes Plastic Pipe Stand-Offs, (PN: BC-CRC1250L)...

CV-Joint for Defender 1994 - 2006, Discovery 1 w/ABS, RRC 1992 onwards. 24 splines to the drive flange, 32 splines towards the driveshaft

Clutch Repair Kit Cover and Plate For Defender Puma 2007-16, 2.4 and 2.2 TDCi. Supersedes CC-LR117128, CC-LR048731, CC-LR037956.

Accelerator Control Rod Cross Shaft to Engine Ball-Joint TypeFor 1958 Series 2 with the 2.0L Spreadbore Engine.Threaded 2BA, 2-3/8" Long.See EF-AAU...

Clutch Plate for TD5 Defender, Discovery 2

Connector Assembly Fuel Regulator TD5 from 2002 This is a 3-Pipe unit for Defender TD5 from VIN 2A622434, and Discovery 2 TD5 from VIN 2A736340. Re...

Connecting Rod Assembly 2.25L Diesel Series 2a through to early Land Rover 90 and 110

Copper-Nickel Brake Pipe Set Defender 110 CSW LHD w/ABS 1992-2003

Copper-Nickel Brake Line Set Defender 110 1988-91 To Vin HA901219 LHD

Series 1 80" LHD 1948-1953All Pipes in this kit are 1/4" Copper-Nickel with UNF Brass Fittings.For Rubber-Lined P-Clips see PN's: BC-56666 and BC-6...

Connecting Rod Big End Bearing Set .010 Thou Over.For 2.5L Naturally Aspirated Diesel, 2.5L Turbo Diesel, 200Tdi, and 300Tdi.OEM King.

Clutch Slave Cylinder for Defender and Discovery 2.300Tdi from Gearbox 56A0669087K (1999)TD5 up to 2007

Clutch Plate Standard Duty Defender 2.5NA, 2.5TD, 200Tdi and 300Tdi.