Aftermarket

Special Stud for Swivel Housing 7/16"BSF Series 2a-3 This Stud has a thicker non-threaded center. 4 Required for Top, February 1962-66. 2 required ...

Speedometer Cable for Series 3 1972-1984, 2.25L and 2.6L.Works for Left or Right Hand Drive .

Spring Clip for Tools behind Front Seats Series 1-3.For tools, like the hand crank, with a diameter up to 5/8".You'll need a rivet for installation...

Series 1, 2, 2a and 3 Rear Mud Flaps Pair.With Brackets. Mudflaps are Plain, No Logo.,For Land Rover Genuine with Logo, see MF-320590LR.

Shock Absorber -Front 86/88 Std PR2 w/Bushings Series 1-3

Shackle Bolt for Rear of Front Spring - 9/16" UNF 88/109

Series 2, 2a and 3 Front Mud Flaps Kit, Pair.With Brackets. Mudflaps are Plain, no Logo.Land Rover doesn't make front mudflaps for Series... we don...

Replacement Headlamp Retaining Ring with Black Bezel.Includes the retaining bezel, mounting ring, clips, screws and 2 adjuster screws.For Defender ...

Push-Button Starter Switch Series 1-2a, 1948-1966. Note: This Does Not include the Knob. Use your original, or see BE-605280 (linked below). Supers...

O-Ring and Washer Seal Kit for TD5 Injectors 5x O-Rings (EF-ERR7004, Made in Italy), 5x Washers (EF-ERR6417, Made in Germany). Defender and Discove...

Oil Sump Gasket for TD5 Defender, Discovery 2

Oil Pan Sump Drain Plug for TD5. For Defender or Discovery 2 with the TD5 Engine. Requires copper washer CS-CDU1001L (linked below).

Muffler and Tail Pipe Right Exit for SWB 88" and LWB 109" Regular. Fits: Series 1 SWB 86" and LWB 107" 1954-1958. Gas or Diesel. Series 2, 2A and 3...

Lucas L841 Rubber Base for Side Marker Lamp.For Late Series 2a and Series 3 North American Standard.

Rebuild Kit for CB-Type Master Cylinder BB-520849.For Series 2 and Early 2A 88" Short Wheel Base.

Lucas Ignition Coil Sport Non-Resistor Type, 4 and 6 Cylinder, 1967-84. Can be used on earlier models, if you have a push-in ignition lead. Used on...

Locating Pin for Main Gear Lever Series 2-3 OEM

Interior Lamp Metal with Glass Lens. Series 1-3 1956-84. Defender to VIN LA939975, (1995). For later Defender Switched Lamp, see LA-AMR3155 (linked...

Horn Low Note 12v for Series 1-3 and Defender to the end of 1997. With spade connectors, not plugs. For the High-Tone Horn, see BE-YEB10026 (linked...

Hose Clamp 2" - 3" Diameter x 1/2" Band All Stainless.For Various Uses.

Heavy Duty Steering Track Rod, Drag Link and Greasable Tie-Rod Ends.Suitable for Series 2 through Series 3, (1958 to 1984). Excellent product!

Haynes Defender 90/110 Diesel Owners Workshop Manual Covers Land Rover 90, 110 and Defender up to 2007 with 2.25/2.5L, 2.5TD, 200/300Tdi, TD5 Diese...

Gasket Paper for Water Pump, For Series 2a-3, 1961-84. 9-Hole Water Pump, Gas or Diesel. This does not fit the Series 2, (1958-61), 8-Hole Water Pu...

Gasket for Oil Filter Housing to Block Series 3 2.25L Gas or Diesel, and 2.6L, 1971-85, (See note below). Defender 2.5TD and 200Tdi, 1986-94. Super...

Gasket Paper for Oil Sump, aka Oil Pan GasketFor 4 cylinder 2.25L and 2.5L Gas, 2.0L and 2.25L Diesel.Supersedes EG-247088G.

Frost Core Plug 1-7/8" Push-In Cup for 2.0L, 2.25L, and 2.5L Gas or Diesel (Side Plugs)Series 1 2.0L uses 4. Series 2-3 2.25L uses 3.

PAIR of Front Vent Foam Rubber Seal for Series 3, Defender.Note that this is a foam rubber, (closed cell), seal with Self-Adhesive strip for attach...

Front Suspension Shackles Kit.For 86" and 88" Series 1-3, 1956-84.Shackles, Bolts and Nuts for mounting Front Springs.

Front Spring Shackle Plate Threaded 9/16" UNF.Inner Shackle for Series 2a-3, 88" and 109", From March 1963, Suffix B on.

Exhaust Manifold Stud Kit (3 Studs, locks, & brass nuts) 2.25L Gas 61-84 For Mounting Down Pipe to Manifold. (These are included in the Comple...

This is a rubberized end cap for the Defender's front bumper.Fits either side on the standard bumper starting in 1984 all the way through the end o...

Dust Cap for Wheel Cylinder or Clutch Slave Bleed Screw pn: BB-556508. You are purchasing 1, not 10 as shown in the photo.

Diesel Fuel Pump Kit for 2.25D, 2.5D, 2.5TD and 200TDI Defender with Pipes.Supersedes EF-563146, EF-ETC7869 and EF-RTC6180.

Cylinder Block Freeze Plug KitFor Series 2a-3 2.25L Gas or Diesel and Defender 2.5L Gas or Naturally Aspirated Diesel.Note: for Series 3 1972on 2.2...

Cup Holder for Cubby Box.Fits most standard sized cubby boxes. Removable for cleaning.

Cyclone Oil Breather 2.5NA, 200/300Tdi Defender, D1, RRC