Aftermarket

Drive Flange for Differential 4 Spline Type Rover Differential.Uses Castle Nut AD-3259 and Cotter Pin AD-PS608101L (linked below). You might need a...

Drive Flange Member 10-Spline Series 1-3 1948 to June 1980.

Door Rubber Sold by the Meter (Glue-On) Series 2-3

Distributor for 2.25L and 2.5L Engine - 45D4 Type Points.Complete with Rotor, Cap and Points. This is the later 45D type, suitable for all 2.25L en...

Defender XS Front Grill and Lamp Cover Set.Black with Silver Mesh. Stainless Steel Fasteners Included.Note: The Oval Badge is not Included. Choice ...

Copper-Nickel Brake Set Series 2a 4-Cyl 88" SWB LHD 1961-71All Pipes in this kit are 3/16" Copper-Nickel with UNF Brass Fittings.Single Line Brake ...

Connecting Rod Big End Bearing Set Standard 2.25L Gas/Diesel 1961-84.For Series 2a to 3.Note: Does not fit the Series 2 (1958-61) Engine.

Clutch Flex Hose for Series 3 2.6L 6 Cylinder Engine, 1971-84, and Land Rover 90/100, Defenders with the LT77 Gearbox up to 1994,For Series 3 2.25L...

Clutch or Brake Master Cylinder Adapter 3/8"UNF Male to 7/16" UNF Female.Depending on the purpose, you will require BC-233220 Copper Seal and/or BC...

Metal Clamp Ring for In-Tank Fuel Pump/Sender For Defender 90/110/130, Discovery 1, Discovery 2, and RR P38, L322.

Captive Nut Door Hinge to BulkheadFor Series 3 and Defender up to 1998, and earlier bulkheads repaired with New Door Posts.OEM. These are UNF Threa...

Brake Pipe P-Clamp w/Rubber Grommet for 3/16"/1/4" Pipe Package of 10.

Brake Pad Retaining Kit RearDefender 90 AllDiscovery 1 1994-99,Range Rover Classic 1987-95

Brake Rotor Front Vented 90/110 LA(94on), D1, RRC (FTC902)

Brass Drain Plug for Differential, Fuel Tank or Transfer Case.For Series 1-3.Large Slotted Type. Requires Copper Washer GT-FRC4809.For a proper too...

Brake Shoes Axle Set 11" Front. Allmakes.Front 107" w/11" Brakes, All Front 109" 4 Cyl, Front 88" from June 1980.

Brake Caliper Rear Defender 110/130 LH to 1A614447 (roughly 1994-2001)

Bolt 3/8" BSF x 1 19/32" for Drive Flange Member. OEM. These bolt both the front and the rear drive flanges to the hub assemblies. You will need s...

Bolt ACME for Front Wing to Bulkhead S 2-3, 90/110 Zinc. OEM.

Bolt Kit Axle Set, for SC-DA3169 or SC-DA3181 Swivel Ball Housing Kits.Includes all Fasteners required for the Seal Retainer to the Swivel Hub, Fro...

Bleed Screw for Front Calipers 90/110 and D1

Our third of three sticker packs to show off your 3BCR loyalty. Each Sticker Pack contains 3 individual stickers. Sticker Pack 3 contains 1 Circle ...

Accelerator Pedal Pad Defender 1999on

2.25L 4 Cylinder Ignition Lead Set For Late 2a, Series 3, 1970-84. OEM.Shorter Ignition Coil to Distributor Wire, for Coil located on Right Hand s...

Automec Small Pipe Bender Tool for 3/16" Copper-Nickel Pipe Great tool for making the right bends when installing any of the 3/16" kits.

Rubber Neoprene Foam Seal Gasket for Steering Column. Series 1 to 2a, 1954-71. Supersedes SC-303995. Quality Made from Neoprene Foam Rubber. Made i...

The world’s first LED interior lamp replacement designed specifically for the Land Rover Defender. Plug & Play connection. Fixings are supplied...

Union Jack Black and Chrome Exterior Decal. 2"x1.25", Self-Adhesive.

Steering Box Gasket Paper 0.005 for Series 1-3 1948-84.Used with Shims SC-261858 on 1956 to 84 Steering Column to Box and End of Box.Supersedes SC-...

Raptor Engineering Defender Rear Cowl Instrument Panel Mount. Steel Replacement that fits both Left- and Right-Hand Drive Defender to 2006. No More...

Wiring Harness Plug for Lucas Alternator. With 2x 3/8" and 1x 1/4" Female Connectors. For Series 2a and 3, (or earlier dynamo to alternator convers...

Our classic 3 Brothers Shop T-Shirt, now in kiddo sizing for all the young enthusiasts in your life. Small, (Size 6 to 8), Medium, (Size 10-12), La...

Clip for Speedometer Cable and Other Applications.Series 1-3.

Firtree Fastener for Door Trim Panels.For Defender Front Door Panels without Speaker from VIN: AA271215 to AA339423. Rear Side Doors to VIN: EA3447...

Temperature Sensor for 300Tdi and TD5.For Defender 300Tdi and TD5, Discovery 1 300Tdi, and Discovery 2 TD5.Notes: Coolant for 300Tdi, TD5 Coolant T...

Solex to Zenith or Weber Carburetor Conversion Kit for Series 2.25L Engine. Since the Solex Carburetor is no longer available, the change to a Zeni...

Mounting Rubber for 200Tdi and 300Tdi Exhaust Systems.Defender 90/110/130, Discovery 1, and Range Rover Classic.OEM.

Flange Plate for Steering Relay Mount to Chassis.For Series 1 to 3, 1948-84.For the required BSF Bolts see BN-250693 (linked bottom left). For the ...

Copper Washer, Nut and Internal-Tooth Washer Kit for 3/8" Hoses,

Rear Safari Door 3-Hinge Kit with Stainless Steel Fittings.Fits Series 2-3, (3 Hinge Rear Doors), and Defender.

Front Wings to Bulkhead Fastener Kit.For Series 2, 2a and 3, and Defender.

Brass Brake Pipe Fitting Female 7/16" x 20 UNF for 1/4" Copper Nickel Pipe.

Vinyl Sticker "Land Rover" for Series 3 Grill. For the Replacement Grills, BP-346346, that No longer have the Logo on them.

Bulkhead to Windscreen/Windshield SealFor Defender Puma, 2007 on.Supersedes SL-DWC500010, SL-DWC500011, and SL-LR016690.Quality Made in the UK.For ...

Coolant Reservoir Tank for Defender TD5 and Puma.

Head Gasket for 2.25L and 2.5L Gas Composite.For Series 2-3 and Defender.

Bolt 7/16"UNF x 2.25" Grade 8 Yellow Zinc.For Upper or Lower Arm to Steering Relay.Series 2 to 3, 1958-84.Supersedes BN-215390, (BSF) and BN-256465...

Torsion Spring for Bell Crank Accelerator Linkage.For Solex Carburetor, Series 2-2a, 1958-69.