Aftermarket

Key Blank for Series 1, 2 and 2a Ignition and Early Hook Type Door Lock Barrels. Single-Sided, Flat on One Side, Used with BE-395141 Key Cylinder (...

Key Blank Ignition Defender 1987-2017.All Defenders with Steering Column Lock.Aftermarket.Supersedes KB-STC4798, KB-AAU8276.

Lamp Adapter Wiring Harness 2-Pin to Bullet Connectors. For fitting LED Lamps to Series and Early, (Pre-1995), Defender Wiring Harnesses. Small Plu...

Ignition Switch for the Series 2a-3 from 1967 through 1984. Gas, Without Steering Lock. No Key or Lock Cylinder. For that, you are after BE-395141.

Knob for Gear Shift Lever (Black, Push-On) for Late Series 2a and Series 3, 1968-84.This Requires the Knurl Ring Bushing GT-571661 to fit on the Sh...

Horn High Note 12v for Series 1-3, Defender to the end of 1997. With spade connectors, not plugs. For the Low-Tone Horn, see BE-YEB10027 (linked be...

Heater Intake Seal to Front Wing Series 2a/3 1972-84.Quality Made from High Density 1/2" Neoprene Foam. Made in Canada!

Hub Lock Washer for Stub Axle. For Defender from VIN: LA930456, (1994 onwards). For Discovery 1 between 1989-1998, and the Range Rover Classic from...

Heavy Duty Steering Track Rod, Drag Link and Greasable Tie-Rod Ends.Suitable for Series 2 through Series 3, (1958 to 1984). Excellent product!

Headliner Fir Tree Fasteners Light Grey Various UsesDefender, Discovery 2, RR P38

Headlight Bezel Right Hand Black for Defender up to VIN: WA159806 (1998). Requires 2x FS-AB608047L & 2x FS-79051. For the Left-Hand Bezel see B...

Hand Brake Cable for Defender from LA935630 (1994) through to 2016, Left or Right Hand Drive.Supersedes BB-STC1530, BB-SPB000160.

Gasket for Fuel Pump Side Cover to Engine Block2.25L Engine, Series 2-3

Gasket for Oil Filter Housing to Block Series 3 2.25L Gas or Diesel, and 2.6L, 1971-85, (See note below). Defender 2.5TD and 200Tdi, 1986-94. Super...

Gasket Metal for Turbo Oil Return Line.Defender TD5, 1999-2006.

Gearbox and Transfer Case Gasket and Seal Kit For Series 3. Gasket Set with all Seals required for a full tear-down and rebuild. Includes Front/Rea...

Gasket for Choke Thermostat Cold Start Otter Switch on 2.25L Head

Glass Fuse 25AMP 12AMP Continuous for Series 1-3 OEM

Gasket Kit for Zenith 361V Carburetor Series 2a-3 from 1968

Galvanized Stays for Rear Sill/Wings PAIR,In Front of the Rear Tires on Series 2-3, 88 and 109". Left and Right Hand.

Front Tow Ring Galvanized Each.For Series 1-3.

Fuel Pump and Sender Unit In-Tank Rear. For Defender 110/130 TD5. Note: Includes EF-WGQ000020 Seal, but you may require the Clamp Ring, EF-ESR3808 ...

PAIR of Front Vent Foam Rubber Seal for Series 3, Defender.Note that this is a foam rubber, (closed cell), seal with Self-Adhesive strip for attach...

Front Suspension Shackles Kit.For 86" and 88" Series 1-3, 1956-84.Shackles, Bolts and Nuts for mounting Front Springs.

Splash Guard (Mud Shield) for Early Series 2/2a 1958 to April of 1969. Left Hand for Left Hand Drive (Galvanized Steel Sheet). For the RH side, see...

Front Vent Rubber Seal Moulded Series 2-3, Defender This is the Formed Rubber Seal fitted to the bulkhead

Fuel Gauge 12v Series 2a-3 1967-84 Negative Earth. Fuel Gauge and Fuel Sender need to match. This matches Senders EF-90560612, EF-623097 and EF-PRC...

Fuel Sender Unit Gas or Diesel Under Seat and Rear Tanks from 1967 until 1984. Series 2a-3, 88" 1967-84, 109" Station Wagons 1967-74 with Original ...

Front Crankshaft Oil Seal Fits, Series 1, 1.6 and 2.0L Series 2, 2a, and 3, 2.25L 4Cyl and 2.6L 6Cyl Defender, Discovery 1 and RRC, 2.5L NA Diesel,...

Exhaust Manifold Stud Kit (4 Studs, locks, brass nuts and the Gasket) For Series 1 2.0L Gas 1954-58, and Series 1-3 Diesel 2.0 and 2.25L 1957 to S...

Replacement Footwell with Pleats Right-Side for Left Hand Drive Series 2 to 3 Bulkhead Supplied in 2 Pieces, ready for riveting or welding.

Replacement Footwell with Pleats Left-Side for Left Hand Drive Series 2 to 3 Bulkhead Supplied in 2 Pieces, ready for riveting or welding.

Exhaust Mounting Rubber For Defender, Discovery 2, Range Rover P38, TD5, Tdi, V8. Supersedes: NTC3650

Fixing / Stud Plate for Door Handle/Lock Assembly For Series and Defender Pull-Up Door Handles.1 Required per Door Handle.Requires 2x Nuts BN-NH106...

Fan Belt Alternator 2.5P/D/TD 200TDI 90/110

Exhaust Hanger Bracket Kit (2 Brackets) for Right Exit System 86/88" 1954-84 Pre-assembled, ready to bolt into position. Please check your chassis ...

Fan Belt for 2L Diesel, Series 2 2.25L 1958-61, & 2.6L FC LR

Door Seal 1-Piece Push-On for Left Hand 2nd Row Door.For Late Series 3, and all Defenders.

Door Seal 1-Piece Push-On for Right Hand 2nd-Row Door.For Late Series 3, and all Defenders.

Drive Flange for Differential 4 Spline Type Rover Differential.Uses Castle Nut AD-3259 and Cotter Pin AD-PS608101L (linked below). You might need a...

Door Window Channel Strip Upper (Front Windows) for Series and Military Land Rovers.

Drive Flange Member 10-Spline Series 1-3 1948 to June 1980.

Door Rubber Sold by the Meter (Glue-On) Series 2-3

Dust Cap for Wheel Cylinder or Clutch Slave Bleed Screw pn: BB-556508. You are purchasing 1, not 10 as shown in the photo.

Delphi PAIR Brake Rotor Rear Solid Defender 110/130 frm XA159807, (from 1999on). This is for both ABS and Non-ABS 110 Rear. Use Brake Pad Fitting K...

Door Bottom Repair Kit, (1 piece, 1 meter long) .This repair piece fits the front doors of the Series 2, 2a, 3 and Defenders (also fits the rear do...

Copper Nickel Pipe, Clutch Flex Hose to Slave, LHD/RHD Series 3 1971-841/4" Copper-Nickel Pipe, (will not rust), with Brass Fittings for use on;88"...

Complete Floor Bolt Kit 4 Cylinder Series 3 1971-84Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells, (...