Aftermarket

Fuel Sender Unit Gas or Diesel Under Seat and Rear Tanks from 1967 until 1984. Series 2a-3, 88" 1967-84, 109" Station Wagons 1967-74 with Original ...

Exhaust Manifold Stud Kit (4 Studs, locks, brass nuts and the Gasket) For Series 1 2.0L Gas 1954-58, and Series 1-3 Diesel 2.0 and 2.25L 1957 to S...

Foam Gaskets for 3mm Premium Wing Top Protectors. These gaskets sit between the Defender wing and the chequer plate.Fits all Land Rover 90/110's an...

Exhaust Mounting Rubber For Defender, Discovery 2, Range Rover P38, TD5, Tdi, V8. Supersedes: NTC3650

Fixing / Stud Plate for Door Handle/Lock Assembly For Series and Defender Pull-Up Door Handles.1 Required per Door Handle.Requires 2x Nuts BN-NH106...

Ferodo Brake Pad Set RearFor Defender 110/130 Up To VIN 1A614447 (Model Year 2001)Requires Fitting Kit BB-DA4105 (linked below left).For Later see ...

Engine or Gearbox Mount for V8 RRC, 90/110, D1 & 101 F/C With Nuts.

Door Window Channel Strip Upper (Front Windows) for Series and Military Land Rovers.

Delphi PAIR Brake Rotor Rear Solid Defender 110/130 frm XA159807, (from 1999on). This is for both ABS and Non-ABS 110 Rear. Use Brake Pad Fitting K...

Door Bottom Repair Kit, (1 piece, 1 meter long) .This repair piece fits the front doors of the Series 2, 2a, 3 and Defenders (also fits the rear do...

Delphi AP Brake Pad Set Rear Defender 110/130 2002-14.Requires Pad Retaining Pins BB-RTC5001 and springs/cotter pins BB-STC8576 (linked below).

Copper Nickel Pipe, Clutch Master Cylinder to Flex Hose, most 88" and 109" Series 2 and 2a, Left-Hand Drive, 1958 to 1967. 3/16" Copper-Nickel Pipe...

Series 2a-3 88" LHD Dual-Line w/Servo w/oValve NA Std 1969-74.All Pipes in this kit are 3/16" Copper-Nickel with UNF Brass Fittings.Dual Line Syste...

Copper Washer for 7/16" Brake Hose BC-219824 Series 1 1948-53.Also used on Series 2/2a Banjo Bolt for Brake Master Cylinder LHD, and with Brake/Clu...

Complete Floor Bolt Kit 4 Cylinder Series 3 1971-84Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells, (...

Clutch Slave Cylinder 300Tdi from Gbx 56A, TD5to07, TRW

Clutch Slave for Tdi on R380 Gearbox.For Defender, Discovery 1, and Range Rover Classic 1992-94.Notes: 300Tdi to Gearbox Serial Number 56A0669086K ...

Coin Tray for Defender Upper Dash 1986-2006,Replacing the Ash Tray,

Series 2a and 3 Swivel King Pin, Bearing and Seal Kit. Full Axle Set.Does Both Swivels. Includes Top Pins, Bushings, Bottom Bearings, Thrust Washer...

Choke Cable for Series 2a (January 1967-71), with a Zenith Carburetor and Series 2a/3 (to 1984) with Weber Carburetors.This works with a Non-Steeri...

Cap for Valve Stem 2.5G, 2.5NA, 2.5TD, 200/300Tdi You are purchasing 1, not 10 as shown in the photo.

Brake Rear 3-Way Tee Union.For Series 1 86" and 107" 1954-58 and Series 2, 2a, and 3, 88" SWB and 109" LWB up to June 1980.Brass. 3x 3/8" Imperial ...

Master Brake CV Type Series 2A 88" and 109" No-Servo Single-Line 1969-84 Used on 88" SWB from July 1980 to '84 Single Line systems. Used on 109" LW...

Brake Caliper Rear Defender 110/130 RH to 1A614447 (roughly 1994-2001). Notes: Uses Solid Rotors, SFP000280 Pads, and DA4105 Kit.

Bolt Kit Rear Suspension Trailing Arms and A-Frame Bolts. For Defender up to VIN: YA185790 (1999), Discovery 1, and RRC. For Imperial Bushings. For...

Bolt for Front Propshaft to Transfer Case For Series 1-3. 3/8" x 1-7/32"UNF. 4 Required. For the other Propshaft Bolts, see BN-509045P This Require...

Bonnet Canvas Strip White w/Brass Split Rivets S 2/2a 58-71

Hinge to Bulkhead Screw 1.5" Long for Series 3 and Defender Hinge, OEMThis is the shorter screw that holds the Hinge to the Bulkhead. For the longe...

Axle U-Bolt "Short" Front Series 1-3 86/88" with Nuts For Front 9-Leaf Springs. 3 Required. For Longer U-Bolt, (1 required), see SS-562641.

Ball Joint Kit Steering Drop Arm Repair Kit For Defender, Discovery 1, and RRC

Bolt 1/4" BSF x 1" Lockstop Set Bolt for Swivel Hub S1-3 OEM

Show your love for your fav Land Rover supplier by sticking these bad boys on whatever you’ve got.Each Sticker Pack contains 3 individual stickers....

Accelerator Pedal Pad for Disco1, RRC, 90/110 to '98

Adapter Pipe for Rear Heater Hose to Engine Cylinder HeadSeries and Defender. Gas and Diesel.OEMThe Thread on this Adapter is 3/8" BSF.Requires Cop...

9" Clutch Plate for 1948-1969 Series 1-2a.For the Clutch Cover/Pressure Plate, see CC-591705.For a Complete Kit with the Cover, Plate and Flywheel ...

Fuel Cap Rubber Seal/Gasket Series 2 - 3

Drain tap coolant valve for cylinder block or original radiator, (will not fit new replacement radiators EC-577609). Sometimes referred to as a pet...

Round Retaining Plate with 3 Holes for Speedometer Cable. For Series 1 to 2a, (1950-1971). Fits on Speedometer Cable EP-RTC3484, holding it to the ...

Front Raised Seat Belt Bar for Soft Tops or No Tops. For Series 2 to 3 and Defender. Designed to fit the top point of your 3 or 4-Point Seat belt a...

Door Handle Assembly Left Hand with Lock and Keys. Slam Type Door Handle, Series 2-3. Note: You'll need 1x DP-AFB710250, 1x DP-AHR710540, 2x FS-AB6...

Top Swivel Pin Shim Kit 0.003-0.030", Set of 8 Shims. For Defender All With or Without ABS, Discovery 1, and Range Rover Classic with ABS from June...

WE CAN NOT SHIP PAINT OUTSIDE OF CANADA Paintman Paints Engine Blue Land Rover Series 2/2a Gas or Diesel, 1958 to 1971. 400ml Aerosol Can. You may ...

Set of 3 Detent Springs for Synchronising Clutch, (Clutch Synchro), Assembly in Gearbox. For Series 1 to 3, 1948-84. 3rd and 4th Gear Synchro. Supe...

Bracket for Mounting the Front Apron Series 2-3.2 or 3 Typically Required depending on which Front Apron you have.

Gasket Cork for Water Pump - New Old Stock.Series 1 1.6L & 2.0L 1948-58.

Stud 3/8" BSF for Steering Lever on Top of Swivel Housing, (Pendant Type).For Series 1-2a 1950 to February 1962, 1 Required per Side, (2 per Axle)....

Stud 3/8" BSF for Steering Lever on Top of Swivel Housing, (Pendant Type).For Series 1-2a 1950 to February 1962, 3 Required per Side, (6 per Axle)....

Stainless Steel Wiper Arms and Blades, Center Park, Bayonet, Pair of Arms and Blades. For Late Series 2a, (1967on), and Series 3, with the Single W...