Aftermarket

Exhaust Manifold Stud Kit (3 Studs, locks, & brass nuts) 2.25L Gas 61-84 For Mounting Down Pipe to Manifold. (These are included in the Comple...

Exhaust Hanger Bracket Kit (3 Brackets) for Left Exit System 86/88" 1954-84 Pre-assembled, ready to bolt into position. Please check your chassis f...

This is a rubberized end cap for the Defender's front bumper.Fits either side on the standard bumper starting in 1984 all the way through the end o...

Cylinder Block Freeze Plug KitFor Series 2a-3 2.25L Gas or Diesel and Defender 2.5L Gas or Naturally Aspirated Diesel.Note: for Series 3 1972on 2.2...

Copper-Nickel Pipe, (will not rust), with Brass Fittings for use on;Series 2 and 2a, 1958 to 1971 with separate Brake/Clutch Reservoir Canister.1/...

Clutch Release Bearing Series 1 to 2A, 1948-71Used for both 9" and 9-1/2" Clutch. 2.25L and 2.6L NADA.Also used on Front Output of LT230 for Defend...

Service Kit for Series 2A/3 - 1964 onwards with Lucas 25D distributor with fixed points Will not fit vehicles fitted with a Ducellier distributor...

Bulb 12v for Stop/Tail LampFits Series, Defender, Discovery 1, Discovery 2, RRC, and RR P38

Axle U-Bolt Rear with NutsFor Series 1-3 86/88, 107/109 to end of 2a, Rover Axle4 Required.

9.5" Clutch Plate Optional 1964-71, Standard 1970-84 Late 2A, Series 3 Optional 9.5" Clutch used on NADA Gas/Dsl 88 and 109, 1964-71. Standard on D...

If your fuel cooler starts leaking on your Td5 Defender (or imported Discovery) this kit can be an economical fix may save you from replacing the e...

Oil Pan Sump Drain Plug for 2.0L and 2.25L Engines. Series 1-3. 3/8" BSF Thread. Supersedes EP-3088. You May Require the Copper Seal, CS-243959 (li...

Wiring Bullet Kit with 175 Brass Bullets, (4 sizes, 1.0mm 24 Gauge, to 3.0mm 8 Gauge, crimp or solder), and 50 Single and 25 Double Connectors. All...

Badge "Defender" Rear Raised Lettering Gloss Black. Similar to DB-DAH500360MBJ but Raised Gloss Black Lettering and Underline Swipe. Self-Adhesive....

Rubber Seal for Wiper Spindle.Fits Late Series 2a, (with Single Wiper Motor), Series 3, and Defender to 2002.

O-Ring for Swivel Pin/Steering Levers.For Series 2a-3, 1964-84.

Wiring Harness for Fuel Injection. aka: Injector Wiring Harness.TD5 Defender and Discovery 2.

Front Door Left and Right Hand Hinge Kit with Stainless Steel Fittings, Fits Series 3 and Defender. For a set of Front and Middle Row Door Hinges, ...

Spherical Bearing for Clutch CrossShaft and HandBrake.For Series 2/2a Clutch Cross Shaft and Left Hand Drive HandBrake Lever up to Suff C, (1948-Ap...

Brake and Clutch Pedal Return Spring Series 2/2a, 3-17/32".Note: you are purchasing 1, not 2 as shown on the photo. Typically 2 are required.

Gasket For Front Timing Cover Joint. For Series 1-3, 2.0 Diesel, 2.25L Gas or Diesel, and Defender 2.25L Gas, 2.5L Gas or Naturally Aspirated Diese...

Oil Seal for Swivel HubFits All Defenders, 1983-2016, Discovery 1 from '91, RRC 1987-95.Supersedes SC-FRC2889, SC-LR059968

Gasket for Drive Flange to Hub, Front or Rear. For Defender, Discovery 1, RRC, up to 1993, (VIN: KA930455). For Later, see EG-571752 (linked below).

Nut for Fuel Pipe Union, 5/16" Plastic Fuel Pipe.For Series, Defender, Discovery 1, Range Rover Classic, and RR P38.For the Fuel Pipe Olive, see EF...