Aftermarket

Rope Cleat for Side of Rear Tub Series and Defender (Rivet-on). You'll need 2 or 3 Rivets RV-78248 to fasten to the body side.Normally you require ...

Rubber Seal Kit for Pick-Up Truck Cab Rear Corner Window.Series 2-3 and Defender to 1989Includes the Weatherstrip, SL-330790, and Filler Strip, SL-...

Handbrake Lever Grommet (Boot) for Series 2 and 2a, 1958-66.Note: Hole for Handbrake Lever is Round. For the later Series 2a/3 Grommet with the Ova...

Reverse Lamp Assembly Perei Rectangular Clear.Used on Defenders up to VIN: 1A612403 (2001). Bulb is included in assembly. For Later Round Lamp see ...

Rear Safari Door Skin Panel Aluminum for Series 2-3 or Defender up to 2006, (Lower Only).For Upper "Goal Post replacement Skins, see DP-DA3613.

Rear Stop/Tail Light AssemblyRed 2-3/4" Diameter Euro-Style Plastic LensFor Series and Early Defenders with bullet connections.

Rear Door Stay Gas Strut Heavy Duty for Defender up to 2002Does your Defender's rear door sometimes close on you unexpectedly?This neat and easily ...

Rear Corner Trim Panel Galvanized LH Series 2-3

Rear Cross-Member Bolt Kit Stainless Steel.Metric, For Series and Defender.To bolt the rear tub to rear body mounting bracket, (Puma style), and to...

Rear Reflector Red for all Series, Bolt-on, 2.25" Diameter.PAIR.

Radiator Hose Kit for Series 1 1948-58 1.6L and 2.0L EnginesIncludes EC-268037 and EC-268038 with Stainless Steel Clamps.

Rear Cross Member with Extensions - No Spring Hangers For Series 2-3 88" and 109". (88" will require Spring Hangers cut from your original frame or...

Pulley for Alternator on Series 2a/3 Gas or Diesel. Internal Shaft Diameter is 0.59", 15mm. Be sure this fits your Alternator.

Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed End, Aluminium Stem. For a Package of 10, see RV-78248-10 (linked below).

Power Steering Pump for 300Tdi Defender, Discovery 1. For Earlier (200Tdi) see SC-NTC9070. For Later (TD5) see SC-QVB101350 (linked below).

Propshaft, (Drive Shaft), Front for Series 1-3 4 Cylinder 1956-84.Fits Series 1 88" and 109", 1956-58.Fits Series 2-3 88" and 109" 4 Cylinder, (Not...

Peg for LT76 Gearbox Mainshaft Series 1-3, 1948-84 For the other Peg, see GT-RTC1979 (linked below).

Outer Hub Bearing For Series 1 Front, Series 2, 2A and 3 Front and Rear up to 1980. For Inner Hub Bearing, see AD-RTC3416 (linked below left). For ...

Copper Oil Pan Drain Plug Washer. For 300Tdi, (see note below), 2.0L MPI, and Range Rover P38 4.0, 4.6L V8. For a replacement Plug, see EP-UAM2957L...

Oil Filter for 200/300TDI 2.5G/D, 2.5TD, V8-Gas

Oil Filter Coopers for 200/300TDI 2.5G/D, 2.5TD, V8-Gas

This is the left rear mudflap for the Defender 110/130, mounted on the steel bracket. No logo, just plain black.Matching flap for the right side i...

Nut 5/16" BSF for Various Uses. Note: You are purchasing 1, not 5 as shown in the photo.

NTN Outer Hub Bearing Series 1 Front, Series 2/2A/3 Front and Rear up to 1980. For Inner Hub Bearing see AD-RTC3416G (linked below left) For a comp...

NTN Inner Hub Bearing Series 1 Front, Series 2, 2A and 3, Front and Rear up to 1980. For Outer Hub Bearing see AD-RTC3426G (linked below left) For ...

Nut Retainer for Door Handle/Lock Assembly For Series and Defender Pull-Up Door Handles. 1 Required per Door Handle. Requires 2x Bolts BN-SE106161L...

Nut Spire for Front Wing to Bulkhead Series 2-3, 90/110

Master Cylinder Rebuild Kit for Series 1 SWB, 80, 86, and 88" 1948-58 For Original 3-Bolt Master Cylinders 235006 and 241687. For a Kit of just the...

Lucas 25D4 Type Electronic Ignition Distributor Negative Earth for 2.25L Series 2-3. Also Works on the Series 1 2.0L Engine, Negative Earth of cour...

Mirror Head 4-1/2" Round Series 1-3 (No Arm)

Leaf Spring Kit for Series 1-3 86/88" LHD Standard with U-Bolts. Standard Duty Set of Leaf Springs and U-Bolts. *Note: a $40 surcharge for addition...

Locker Plate for Swivel Pin Series 1-2a 1948-1962 3/8" Studs 4 Required per Side, 8 per Axle. You are purchasing 1, not 10 as shown in the photo.

Lens for Front/Rear Indicator, Euro Amber Plastic 2-5/8" Dia

Joint Washer (Brass) for Oil Seal Retainer on Rover Differential. NOS. Series 2-3, 1958-67. Check your Differential first. This will not work on ea...

Indicator Switch Horn and Headlamp Dip Defender up to VIN GA455945, 1990. For Later, see BE-STC439 (linked below).

Instrument Panel Rear Cowl for Defender Left Hand Drive with In-Dash Factory AC, up to 2006. Plastic. Typically broken when taking the dash apart. ...