Aftermarket

Rubber Seal for Pickup Cab to Tub Bulkhead Series 2 to 3, 88/109, Defender to 1991

Rubber Grommet Pad for Mounting Radiator, Intercooler, and for Overflow Bottle Mount.For Defender, RRC, and Discovery 1.2 Required for Bottom-Mount...

Rubber Buffer for Hard Top Side Panels.

Rubber Seal for Door Pillar to Roof and Door Pillar to Tub.Series 2-3 and Defender.SOLD INDIVIDUALLY. You may require 4 in total, 2 per side.

Rubber Gaitor for Overdrive Lever.For the Fairey or Global Roamer Over-Drive on Series 1-3.

Rubber Buffer for Seat Back (Series 2/2a) and Rear Step

Rotor Arm 2.25L 4 Cylinder from Series 3 Engine Suffix D 1975-84Used on the Later 45D4 Distributor, see EE-ETC5835.

Reproduction Solex 32PBI Carburetor for Series 1 2.0L

Rear Stop/Taillight Assembly, Red, Defender 1995on, Wipac Note: Bulb Not included. See LB-264590.

Remote Axle Breather for Series 1-3, 40" Pipe

Rear Seat Assembly, Black Frame with Black Vinyl Cushion and Back For Series 2-3 88" or 109" Station Wagon, Defender 90/110SW (81cm wide bench seat...

Rear Axle Bump Stop Black Def 90/110, D1 94-98, RRC to95

Push-Button Door Handle Right Hand Middle Door.Defender 1987onNo Key Cylinder. Use RTC3022 up to VIN: 1A622423. Leave Blank for 2002 on.If you requ...

Rear Body Panel for Rear Tub LH 88/109 Series 2-3 1958-82. Aluminium.Series 3 up to 1982. For Later Series 3 and Defender, see BP-STC1855.

Rear Body Panel for Rear Tub Right Hand 88/109 Series 2-3 1958-82. Aluminium. Series 3 up to 1982. For Later Series 3 and Defender, see BP-STC1854.

Rear Indicator Lamp Amber Defender 1994on, OEM WipacFits: Defender RoW 1995 - 2016 Market dependent.Supersedes LA-STC1229G, LA-AMR6515G, LA-XFD5000...

PAIR of Rear Axle Re-Bound/Check Straps Extended Length for 109" 1-Ton or with the bigger Salisbury Rear Axle.

PAIR of Rear Axle Re-Bound/Check Straps for 86/88 (237100 and 598854), Standard Length.

Power Steering Pump for Defender TD5 (1998-07).

Phenolic Block for Solex Carburetor or Adapter to Zenith or Weber Carburetor.For Series 2 to 3, 1958-84.

Performance Air Filter for Series 2.25L Gas.Fits Zenith or Weber Carburetor.And yes, it just fits under your bonnet.

Plastic Lockut Nut for Grill to Radiator Series 3, Defender, Dash, Wing Vents, Various Uses OEM Note: You are purchasing 1, not 10 as shown in the...

Oil Seal Diff Pinion Rover Axle, 90/110 VA '97on, D1, D2, RRC

Mudflap and Bracket Rear Left Hand Black Plain with Cut-out for Exhaust Tailpipe.For Defender 90 Rest of the World, (not NAS).For the Right Hand Mu...

Mud Excluder for Front Crank Oil Seal Fits 2.25L Gas or Diesel, and 2.5L Gas. After drilling out the original rivets that hold the Mud Shield in pl...

Mud Flaps for Range Rover Classic Front or Rear (No Bracket)

Mud Rear Corner Speaker Panels (Pair) for 5.25" Speakers.

MUD Half Door Trim Panels Pair.Notes: For 2 Piece Front Doors. Also Fits Early/Military Defenders with 2-Piece Doors. Some Trimming is Required for...

Nut 3/8" BSF Nylon Self Lock.For Swivel Flange to Axle Bolt, and Rear Stub Axle to the Axle.For Series 1 to 3.

Reproduction Lucas Knob for Ignition and Light Switch For Series 1-2a, 1954-66. For the Switch, see BE-90519775 (linked below).

Lower Steering Column Shroud for Defender Note: Will Not Fit Puma fitted with Bluetooth and/or Dynamic Stability Control. Supersedes BP-MTC3500. 

Main Bearing Set Standard 2.25L Gas or Diesel 3-Bearing 1961-84.OEM King. For Seires 2a to 3.Note: Does not fit the Series 2 (1958-61) Engine.

Mirror Arm for Wing Mount Extended 8-1/2" Series 1-3 For Mirror Heads, see GM-606187 for 6" Round, or GM-DA2130 for 7" x 5" (both linked below).

Mirror 8"x5" and Arm for Door Hinges For Series from August 1982 or Defender. Works on Left or Right Hand Door. Convex Mirror. Note: Your Upper Doo...

Lucas L691 Front or Rear Indicator Lamp Complete Amber Plastic.North American Standard in the 60's. These are 3-1/8" in diameter. Larger than the E...

Lucas L594 Clear Glass Beehive Lens

Rebuild Kit for NRC6096 / NRC8690 Dual Line Master Cylinder For Non-North American Standard Series 3 1971-84, Land Rover 90/110 and Defenders with...

Left Hand Anti-Burst Door Striker. For Series 3 with Anti-Burst Door Latches, and Land Rover 90/110 with 2-Piece Front Doors and Anti-Burst Door La...

LED License Plate Light AssemblySeries 1-3, Defender AllWipac

Lock Washer Shake-Proof Int Tooth 7/16" for Series 1 Brake Hose & Series 2, 2a, 3 Clutch Hose.

Knob Thumb Screw for Fuse Box Cover Under Dash DefenderTypically 2 needed...

Intermediate Pipe and Silencer 300Tdi 110/130   *Note: a $40 surcharge for additional packaging will apply to this sale. Please add the surcharge l...

Switch Arm for Headlight Dip, Flash & Horn. For the Series 3 from 1971 through 1984.

Heater/Glow Plug for TD5 Engine For Defender and Discovery 2's with the TD5 Engine. 4 Required, not 5. Guess they didn't have room for the 5th Glow...

Hub Bearing for Series 3 1980 on, Defender, RRC and D1, Timken. Supersedes: AD-RTC3429

Original Hinge Pin Kit for Series 2 and 2a Slotted Screw Head and Lock Tab Washer. For Front, Middle Door Hinges and 2-Hinge or 3-Hinge Rear Safari...

Hand Brake Relay Shaft Replacement or Conversion Kit Used on 1967-84 Series 2a-3 Chassis, or when changing your Series 2 or early 2a chassis to a l...

Grab-Handles for Rear Cross Member. Heavy Duty Galvanized PAIR, with Hardware. For Series or Defender. Well, typically for Series....