Aftermarket

Jerry Can Green Metal 20L 'Don't Get Caught Short'

Key Blank for Series 1, 2 and 2a Ignition and Early Hook Type Door Lock Barrels. Single-Sided, Flat on One Side, Used with BE-395141 Key Cylinder (...

Key Blank Ignition Defender 1987-2017.All Defenders with Steering Column Lock.Aftermarket.Supersedes KB-STC4798, KB-AAU8276.

Ignition Switch for the Series 2a-3 from 1967 through 1984. Gas, Without Steering Lock. No Key or Lock Cylinder. For that, you are after BE-395141.

Horn High Note 12v for Series 1-3, Defender to the end of 1997. With spade connectors, not plugs. For the Low-Tone Horn, see BE-YEB10027 (linked be...

Heater Intake Seal to Front Wing Series 2a/3 1972-84.Quality Made from High Density 1/2" Neoprene Foam. Made in Canada!

Hub Lock Washer for Stub Axle. For Defender from VIN: LA930456, (1994 onwards). For Discovery 1 between 1989-1998, and the Range Rover Classic from...

Headlight Bezel Right Hand Black for Defender up to VIN: WA159806 (1998). Requires 2x FS-AB608047L & 2x FS-79051. For the Left-Hand Bezel see B...

Hand Brake Shoe Retention Kit. Fits Defenders, Discovery 2 and Range Rover P38 from 1993on. 

Heater Control Cable Hot/Cold Lever Series 3 and Defender up to 2006. 50" Long. Needs to be Cut-Down for Series 3 use. Supersedes: HS-347941 and HS...

Heater Control Valve for Kodiak Mark II & III Series 2/2a

Gasket for Fuel Pump Side Cover to Engine Block2.25L Engine, Series 2-3

Gasket Metal for Turbo Oil Return Line.Defender TD5, 1999-2006.

Gearbox and Transfer Case Gasket and Seal Kit For Series 3. Gasket Set with all Seals required for a full tear-down and rebuild. Includes Front/Rea...

Gasket for Choke Thermostat Cold Start Otter Switch on 2.25L Head

Glass Fuse 15AMP 7.5AMP Continuous for Series 1-3

Gasket Kit for Zenith 361V Carburetor Series 2a-3 from 1968

Galvanized Stays for Rear Sill/Wings PAIR,In Front of the Rear Tires on Series 2-3, 88 and 109". Left and Right Hand.

Front Tow Ring Galvanized Each.For Series 1-3.

Fuel Cap Locking Defender 1999on, Threaded Type, With Leash From VIN: XA159807. For Cap without the Leash, See EF-LR075664NL (linked below).

Fuel Pump and Sender Unit In-Tank Rear. For Defender 110/130 TD5. Note: Includes EF-WGQ000020 Seal, but you may require the Clamp Ring, EF-ESR3808 ...

Splash Guard (Mud Shield) for Early Series 2/2a 1958 to April of 1969. Left Hand for Left Hand Drive (Galvanized Steel Sheet). For the RH side, see...

Front Vent Rubber Seal Moulded Series 2-3, Defender This is the Formed Rubber Seal fitted to the bulkhead

Fuel Gauge 12v Series 2a-3 1967-84 Negative Earth. Fuel Gauge and Fuel Sender need to match. This matches Senders EF-90560612, EF-623097 and EF-PRC...

Fuel Sender Unit Gas or Diesel Under Seat and Rear Tanks from 1967 until 1984. Series 2a-3, 88" 1967-84, 109" Station Wagons 1967-74 with Original ...

Exhaust Manifold Stud Kit (4 Studs, locks, brass nuts and the Gasket) For Series 1 2.0L Gas 1954-58, and Series 1-3 Diesel 2.0 and 2.25L 1957 to S...

Foam Gaskets for 3mm Premium Wing Top Protectors. These gaskets sit between the Defender wing and the chequer plate.Fits all Land Rover 90/110's an...

Exhaust Mounting Rubber For Defender, Discovery 2, Range Rover P38, TD5, Tdi, V8. Supersedes: NTC3650

Fixing / Stud Plate for Door Handle/Lock Assembly For Series and Defender Pull-Up Door Handles.1 Required per Door Handle.Requires 2x Nuts BN-NH106...

Ferodo Brake Pad Set RearFor Defender 110/130 Up To VIN 1A614447 (Model Year 2001)Requires Fitting Kit BB-DA4105 (linked below left).For Later see ...

Engine or Gearbox Mount for V8 RRC, 90/110, D1 & 101 F/C With Nuts.

Door Window Channel Strip Upper (Front Windows) for Series and Military Land Rovers.

Delphi PAIR Brake Rotor Rear Solid Defender 110/130 frm XA159807, (from 1999on). This is for both ABS and Non-ABS 110 Rear. Use Brake Pad Fitting K...

Door Bottom Repair Kit, (1 piece, 1 meter long) .This repair piece fits the front doors of the Series 2, 2a, 3 and Defenders (also fits the rear do...

Delphi AP Brake Pad Set Rear Defender 110/130 2002-14.Requires Pad Retaining Pins BB-RTC5001 and springs/cotter pins BB-STC8576 (linked below).

Copper Nickel Pipe, Clutch Master Cylinder to Flex Hose, most 88" and 109" Series 2 and 2a, Left-Hand Drive, 1958 to 1967. 3/16" Copper-Nickel Pipe...