Aftermarket

This heavy weight fleece hoody from Red Canoe features a ‘Chain Stitched’ original font vintage Land Rover word mark on the front chest and a woven...

First of a colour series, this 5-panel cap features a ‘felt appliqué’ vintage Land Rover front icon. Each letter is individually stitched down like...

Gearbox and Transfer Case Gasket Set - Series 1-3 1948-84

Exhaust and Inlet Manifold Gasket - 4 Cylinder 2.25L Gas.For Series 2 to 3, and Defender 2.25 and 2.5L Gas Engines.

Copper Washer for Oil Sump Drain Plug Series 1-3 And for Heater Control Adapter on Series 3 Crushable Copper Seal

Master Clutch Cylinder For 88" and 109", Late Series 2a, (1969-71 North American Standard), and Series 3 (1971-84). Land Rover 90/110/130 and Defen...

Pilot or Spigot Bushing for Flywheel. Series 1-3, 1948 through to end of TD5, Defender, Discovery 2Supersedes 8566L.

Speedometer Cable for Series 1-2A (1950-1971)Note: You must keep and re-use the original Round Plate with 3 holes that mounts the cable to the tran...

Set of 3 Replacement Rubber Grommets for Series 2a-3 1967-84.Handbrake, Gear, and Transfer Lever.Handbrake has Oval Hole. This set can work for ear...

Oil Seal, Front or Rear Output Shaft, Corteco (OEM) Series 1-3, 1948-84. Every. Single. Series.

Hub Oil Seal.Fits Series 1, 1948 to 58, Front Axle. Fits Rear Fully-Floating Axles on 109", and 88" with the optional full float axles from 1957 to...

Clutch Slave CylinderSeries 2 and 2A, 1958-71Mounts on the Right-Hand side of the transmission. For the later Series 3 Slave Cylinder, see CC-59123...

Swivel Hub Oil Seal, The large seal for the front swivel balls.For Series 1-3, 1948-1984.For a Kit with the Seal Retainer and Correct Bolts and Nut...

Steering Box Repair Kit for Series 1-3, 1956-84Quality Kit Made in the UK.This Kit Includes;2x SC-271384 Bearing Race, 1xSC-271013 O-Ring,20x SC-BL...

Hub Lock Washer. For Series 1-3, the whole run from 1948 through 1984. For Land Rover 90/110 and Defender Front Axles to VIN: KA930455, (1993) and ...

Gasket for Rover Differential, Front or Rear.For Series 1-3, Range Rover Classic 1970-95, Discovery 1 1989-98, Discovery 2 1999-04, Defender Front...

Rubber Buffer between Bulkhead and the Bonnet.For Series 2-3 and Defender up to VIN: LA939975, (1994).See BG-MRC6270 for Under Bonnet Buffer (Defen...

This is an under the seat mounted fuel tank that suits both petrol and diesel 88" Series trucks from 1958 through 1984. Also fits 109" up until Aug...

Door Top Rubber Seal (Between Door and Door Top)Series 2-3

The 3 Brothers Canadiana Shirt gives a nod to the land we call home. A maple leaf collage of Rovers and the geography they roam sits on the front,...

Wheel Stud Series 1/2/2A 1958-1971 Screw-In Type

Shackle Bolt for Front-End of Front Spring and Front-End of Rear Spring 9/16" UNF For 88" and 109"

Radiator Cap for Series 2a-3 9lb Pressure Gas/Diesel. Includes Rubber Seal. Not for Series 1, Series 2 or Early Series 2a. See EC-217437 for Series...

PAIR of Front Vent Rubber Seal Series 2-3 and Defender.(These are the fit to bulkhead type, with Grooves for the Vents to seal into).