Aftermarket

Lucas 25D4 Type Points Ignition Distributor for 2.25L Series 2-3. Also Works on the Series 1 2.0L Engine! If you are looking for an Aesthetically I...

Valve Cover Dome Nut for Series 1 to 3, 2.25L Gas and 2.0L Diesel.For a Complete Kit of the Dome Nuts, Washers and Rubber Seals, see EP-DOMEKIT.

Firtree Fastener for Interior Trim Panels, OEM.For Defender 1986-06.For the Snapsac that these push into, see DP-MWC3136 (linked below).For Kits of...

Gasket for Inside Hand Brake Drum 1964-84

Stainless Steel Wiper Arms and 10" Blades, Pair of Arms and Blades. Left-Park, (meaning they point to the Left when Parked), Bayonet Type. Fits Ser...

Gasket Paper for Water Pump.For Series 1 1.6L and 2.0L 1948-58.

Thrust Washer for Steering Relay.For Series 1-3, (2 Typically Required).Note: You are Purchasing 1, not 10 as shown in photo.

Nut 5/16"-24 UNF Hex Nut Zinc Various Uses

Heater Control Cable Kit for Defender from 1995-2001.Includes HS-STC4849 Lever and Cable Assembly, HS-UTP1908 Wiring Harness, and HS-RTC5978 Trunni...

Castrol Classic Pump Oil Can with Fixed and Flexible Applicator Nozzles. 500ml.Pump action screw top cans, supplied with exchangeable fixed and fle...

Bushing for Left-Hand Drive Clutch Pedal Shaft or Right-Hand Drive Brake Pedal Shaft.For Series 1, 1954-58.

Gasket Set for Bottom-End Series 1 1948-58 1.6L and 2.0L Engine.Sometimes called a "Conversion Set", as this combined with a Top End Head Gasket Se...

Spring or Chassis Bushing for Series 1 80" Narrow Springs.Front Springs: 1948-51. Rear Springs: 1948-53. Front Chassis: 1948-50. Rear Chassis: 1948...

Replacement Heater Core for Kodiak Mark 3 or 4 Heater.Note: This Heater Core measures 7-1/16" x 7-11/16" x 1-1/4". The original is 8" x 8" x 2-1/2"...

Pipe Fuel Feed/Return for Diesel Tank 110 or 130 to VIN: WA159806 (Up to 1998).Requires Seal EG-ESR3278. You may also require the Fasteners, see 5x...

Wire Grommet for Flasher, Horn Lead and Other Uses, Black Rubber.Series 2-3, 1-5/16"OD, 1" Panel-Hole, 5/16" Wire Hole. 34.5mm OD, 27mm Panel-Hole,...

Bolt for Oil Pump Sprocket on TD5.For Defender or Discovery 2 with the TD5 Engine.OEM.

Gasket Cork for Water Pump (8-Hole) Series 1-2, 2.25L Gas 1958-61, and 2.0L Diesel 1956-61.

Lucas 31788 OEM Switch for Side and Head Lights or Smiths Heater Fan Switch. For Series 2a-3, 1967-84. For Earlier Series Ignition / Headlamp Switc...

Windscreen Brackets Kit Aluminium Billet Black Pair.For Defender. Includes the bolts and gaskets. Replace your corroded Defender windscreen bracket...

Original Cork Gasket for Oil Filter Housing to Block.Series 1 2.0L (Filter Housing to Adapter), Series 2-3, 2.25L and 2.6L.Defender 2.5TD and 200Td...

Gasket Cork for Flywheel Timing Inspection Cover.For Series 1-3.

Set of 20 Wheel Nuts 1-1/16" for Late Series 2a 1969-71.

Engine or Gearbox Mounting Rubber with Nuts for 2.25L Diesel Engine.Series 2-3 Diesel.Sometimes used as a stronger Engine Mount for Gas Engines and...

Gasket Paper for Rear Hub to Axle Case 90/110 up to '98

Bushing for Front Half-Shaft Series 1 and Early 2/2a Stub Axle.

Cap for Coolant Expansion Tank.Fits Defender 200Tdi and 300Tdi, Discovery 1 V8 and MPI, and Range Rover Classic V8.Note: For use on Tank EC-PCF1015...

Coolant Expansion Tank Unit Black.Note: Cap is Not included, see EC-NTC7161 (linked below).Fits Defender 200Tdi and 300Tdi, Discovery 1 V8 and MPI,...

Fuel Filter for TD5 Defender 90/110, Discovery TD5 Cooper

Bushing for Rear Sway / Anti-Roll Bar.For Defender 110/130.Not for 110 V8, or Defender 90, See SS-NTC7394 or SS-EGP1889.

Hose, Breather to Air Intake Elbow 2.25L Gas.For Series 3 North American Standard, and Engine Prefix 901 and 904 Suffix C and D.

Front Wing Headlamp Panel Left Hand for Series 2a/3 1969-84. Includes Headlamp Backing Panel, BP-345621. For the Right Hand Panel, see BP-345623 (l...

Anchor for Transmission Hand Brake Return Spring (on Transfer Case).Series 1 to 3, 1954-84.

Bonnet Hinge Kit Aluminium Billet Black Pair.For Defender. With bolts and bonnet hinge bushings.

Knob for Ventilator Control on Dash Push-On Type.For Series 2-2a.Quality Re-Production Made in the UK.

L594 Side Lamp Clear Glass Beehive Assembly Complete.Single Pole.,For Series 1 to 2a, various models.

Aluminum Retainer Kit for Rear Safari Door Glass. 6 piece Kit. For Series 2-3 1958-85, And Defender up to 2001. You will need roughly 30 screws, se...

Bell Crank Linkage Arm for Zenith Carburetor 1968on.Also required if changing from a Solex Carburetor to a Zenith or Weber Carb, (from a push-up le...

Gasket For Water Inlet.For Series 1 to 3, 2.0L Diesel, 2.25L Gas or Diesel, and Defender 2.25L Gas, 2.5L Gas and Naturally Aspirated Diesel, 2.5L ...

Brass Brake Pipe Fitting (Nut) Male 7/16" x 20 UNF for 1/4" Copper Nickel Pipe.

Locker Plate for Spring U-Bolts .For Series 1, 1948-51 with the Early Narrow 2.5" Wide Leaf Springs, (Supersedes SS-217261); and Series 1 to 2a, 19...

Set of 20 Black Wheel Nuts for Alloy Rims.Fits Defender, Discovery 1, and RRC.Note: These are for the Alloy Rims, not Steel Rims.

Mounting/Filler Rail for Truck Cab on Series 2-3 88" SWB.Reproduction of No Longer Available Part. Fills the Gap when putting a Truck Cab on an 88"...

Fuel Filler Hose for Side Tank Defender 90. From VIN: AA259679 to WA159806, (1986-1998). Requires Hose Clamps 1x HC-TS40-12-SS and 1x HC-TS44-12-SS...

Complete Engine Gasket Set for 4 Cyl 2.25L Gas with Copper Head Gasket.Fits Series 2-3, 1958-84. Has both 7 and 9 Bolt Water Pump Gaskets.For the l...

Door Hinge Left Hand Lower Front Door, and Upper and Lower 2nd Row Doors.New Style, (Puma Style), for Series 3 and Defender.Supersedes DP-BDB710190...

Pair of Front Rope Tie-Downs with Rivets.Left and Right Hand Rope Tie-Downs, Galvanized. With Aluminium Sealed-End Pop Rivets. For Full 88/109 Canv...

Mirror Glass Only Convex for Defender 8"x5" Mirrors.