Aftermarket

Bolt for Front Panhard Rod 90/110 OEM (2 required) Note: You are purchasing 1, not 5 as shown in the photo.

Bolt for Bonnet Spare Wheel Carrier Mounting. OEM.1/2" BSF x 3" Long. Works with Clamp BP-347262.

Bolt 5/16" BSF x 1" Various Uses (Transmission Brake Drum) Note: You are purchasing 1, not 10 as shown in the photo.

Bolt Fitment Kit for Deluxe Seat 109" Adjustable Seat Frames (Outer)

Bolt and Nut Kit for 109" Shocks Front/Rear Series 2-3.

Bolt Kit for Seal Retainer to Swivel Hub.This is an Axle Set; does both Left and Right Hand Sides.Series 1 to 3, 1948-84.

Bolt Kit for Front Stub Axle to Swivel Hub. This is an Axle Set; does both Left- and Right-Hand Sides. For Series 1-3, 1948-84.

Bonnet Canvas Strip Tan with Hold Down Clips Series 3 '71-84

Bonnet Canvas Strip Tan w/ Brass Split Rivets Series 1 48-58

Blower Motor and Fan for Smiths Heater Series 2a and 3.This is for the two piece Smiths Heater system used on late Series 2a's and Series 3's.

Bolt 1/4" UNF x 5/8" for Body Panels and Other Uses

Blanking Plug for Bulkhead 1/2"OD 3/8"panel-hole Blk Rubber

Bearing Front or Rear Rover Differential Outer Pinion Series 2, 2a, 3 - 1958 onwards, Defender. Check your application, Defender's have various Dif...

Bearing for Differential Inner Pinion-EndSeries 1-2a to 1964. Up to Axle Suffix A Inclusive. For later Differential Inner Bearing see AF-539706.

Belt for Power Steering Pump Defender 200TDI.

Battery Hold-Down J-Clamp Rod for Series Battery Boxes.7-1/2" Long Total, 5-3/4" to Thread.Requires BSF Threaded Wing Nut FS-250431 (linked below)....

Bearing for Rear Layshaft Gearbox Series 1-2a, 1948-72

Alternator A127 100Amp for 300Tdi with 49mm PulleyFits Defender from Engine 16L 25165, (1996/7), (or Upgrade for Earlier, Note the change in Pulley...

Alternator with Pump for TD5 Defender Disco2 Denso

Air filter Defender TD5, Discovery 2 V8 and TD5, Rover Rover P38 V8 and 2.5L turbo diesel. OEM Mahle.

A bit of fun on a t-shirt, because life's too short to take things too seriously.

Want to gift someone something for their Landy but you aren't sure what?  This gift card will fix that for you.  Available in a variety of denomina...

Accelerator Cable for Defender Left Hand Drive 300Tdi from VIN: MA939976, (1995).

First Speed Gear on Layshaft for Gearbox Suffix C on (1965 to 1971).14-Tooth Gear.

Hood Stick Set for a Full Canvas Hood.Fits 88" SWB Series 2-3, 1958-84.Can also be used for the Bikini Hoods by removing the rear hoop and cross bars.

9" Clutch Kit with Cover/Pressure Plate, Friction Plate, Bearing and Flywheel Bushing Kit 1948-69 Series 1-2a. Kit Contains CC-591704, CC-591705, C...

Adapter for Intake Manifold to Zenith or Weber Carburetor.Includes the Nuts and Locks for the Carburetor to the Adapter. Requires Gaskets EG-278163...

This is a crushable copper seal/washer. 16mm It has had many uses in different trucks over the years, including as a fuel tank drain plug, a radiat...

Top rocker valve cover gasket for the 6 cylinder 2.6L Westlake NADA

Plastic Locknut for Defender 90/110, Discovery 1, Range Rover Classic Various Uses Nut Insert Locknut No. 6 and No. 8 Screws You are buying one, no...

This kit includes everything you need to completely redo the handbrake (parking brake) system in your Land Rover Series 2A-3. 1964-1984. Kit includ...

Locking Tab for Exhaust Manifold 2.25L Gas (2 required) 

Service Kit for 300Tdi Oil, Air, Fuel Filters, Washers.

Gasket Paper Swivel Housing to Axle Defender 90/110, Discovery 1, RRC

Pick-Up Tube and Elbow for Side Gas Tank. OEM.  Series 2-3 88" and 109" Regular/PickUp,1958-84   Requires Gasket EG-ESR3277, not included.  Superse...

Front Crank Oil Seal - Inner 300Tdi

Bushing Kit Polyurethane, Radius Arm to Axle. For Defender 1994on, and RRC 1986-94.

Ignition Coil 12V 3 Ohms with Acorn Screw HT Connector. For Series 1, 2 and Early Series 2a. Note: This is for Solid Copper-Core Ignition Leads. Fo...

Oil Filler Cap for 200/300Tdi, Defender, D1, RRC

Sliding Perspex Window for Door Top Series 1 1954-58.This is a replacement window made from 5mm Perspex. It does not have the aluminium frame aroun...

12V LED Flasher Unit Manual Adjustable. LED and Standard Bulb Mix Capable.

Series 2, 2a and 3 Headlamp Relay Upgrade Kit. Series 2, 2a and 3 Supplementary Kit which independently fuses Headlamps, provides power via Relays ...

Rubber Seal for Brake or Clutch Reservoir Cap. For Cap number BB-SJL500030, (aka: BB-500201). Supersedes BB-260820.

Spring Rear 109" Station Wagon, Regular and Truck Cab Series 2-3 1958-84 10-Leaf Standard Weight Capacity. Left or Right Hand for a LHD. Right Hand...

Spring Front 107/109" Station Wagon, Regular and Truck Cab For Series 1-3, 109" Gas 4, 6 and 8 Cylinder. Series 2-3 88" Diesel. Also Series 1 107" ...

Track Rod Tube Assembly with Ball Joints Defender 90/110

Viscous Fan Coupling Double-End Wrench 32mm/36mm

Front Mud Flaps Only, (no Brackets), Plain, Pair. For Defender 90, 110, 130. 1983-2006. For Galvanized Brackets to go with this, see MF-DA1188.