Aftermarket

Rear Corner Capping RH in Black Primer Defender 90/110 Supersedes: AQL710440, AQL710021, AQL710020, ALR9104, AQL710240

Rear Cross-Member Bolt Kit Stainless Steel.Metric, For Series and Defender.To bolt the rear tub to rear body mounting bracket, (Puma style), and to...

Rear Indicator Lamp Amber Defender 1994on, OEM WipacFits: Defender RoW 1995 - 2016 Market dependent.Supersedes LA-STC1229G, LA-AMR6515G, LA-XFD5000...

PAIR of Rear Axle Re-Bound/Check Straps Extended Length for 109" 1-Ton or with the bigger Salisbury Rear Axle.

PAIR of Rear Axle Re-Bound/Check Straps for 86/88 (237100 and 598854), Standard Length.

Rear Light Guard PAIR Zinc with Stainless Steel Fasteners for Series 2-3. These Do Not Fit North American Standard vehicles with the 4" L833 Lucas ...

Radiator Muff for Defender Black w/Green Edging (Britpart Product. Black with Green Trim)

Power Steering Hose Box to Reservoir.For LHD Defender 2.5NA and 200Tdi from VIN JA918810 to LA939975 (1992 to 1994), and 3.5L V8 to VIN SA961767 (1...

Plastic Nail Trim Clip for Dash Panel Defender. OEM.Note: You are Purchasing 1, not 10 as shown.

Plastic Lockut Nut for Grill to Radiator Series 3, Defender, Dash, Wing Vents, Various Uses OEM Note: You are purchasing 1, not 10 as shown in the...

Oil Seal for Clutch Cross-Shaft Series1 RHD and Series 2/2a Left- or Right-Hand Drive; 1948-71. For the Series 1 LHD Oil Seal, see CC-219988 (linke...

OEM Corteco, Oil Seal for the Output Shaft, Front or Rear, on the LT230 Transfer Case.For Defender, Discovery 1 and Range Rover Classic.

Outer Pinion Bearing Front or Rear Rover Differential. Series 1 to 2A, 1948-64. Up to Axle Suffix A Inclusive. For later Diff Outer Bearing see AF-...

Mud Excluder for Front Crank Oil Seal Fits 2.25L Gas or Diesel, and 2.5L Gas. After drilling out the original rivets that hold the Mud Shield in pl...

Nut Metric M6 1.00 Zinc for Various Uses.

Nut Flanged 6mm Plain Zinc for Various Uses. OEM.

Nut 5/16" BSF All-Metal Self-Lock (for Hand Brake Drum). OEM. Note: You are purchasing 1, not 5 as shown in the photo.

Nut 3/8" BSF Nylon Self Lock.For Swivel Flange to Axle Bolt, and Rear Stub Axle to the Axle.For Series 1 to 3.

Muffler and Tail Pipe Left Exit for SWB 88" and LWB 109" Regular. Fits: Series 1 SWB 86" and LWB 107" 1954-1958. Gas or Diesel. Series 2, 2A and 3 ...

Reproduction Lucas Knob for Ignition and Light Switch For Series 1-2a, 1954-66. For the Switch, see BE-90519775 (linked below).

Mainshaft Bushing for 2nd Gear For Series 1-3 (This is 1 half of a two piece bushing, used with GT-FRC4077 linked below left) For the original 1 Pi...

Main Bearing Set Standard 2.25L Gas or Diesel 3-Bearing 1961-84.OEM King. For Seires 2a to 3.Note: Does not fit the Series 2 (1958-61) Engine.

Mounting Bracket for Gearbox LH Series 2-3

Mounting Bracket for Gearbox RH Series 2-3

Metal Cover for Top of Bell Housing Series 2-3

Lucas L488 Bulb Holder Single Contact

Rebuild Kit for NRC6096 / NRC8690 Dual Line Master Cylinder For Non-North American Standard Series 3 1971-84, Land Rover 90/110 and Defenders with...

Land Rover Series 2a Bonneted Control Parts Catalogue.Find the part numbers needed faster with this illustrated parts reference catalogue.

Locker Plate for Timing Chain Wheel to Camshaft. OEM.For Series 1-3, 1948-84

Left Hand Anti-Burst Door Handle Assembly (no key barrel)Series 3 and early or military Defenders. For Lock Cylinders and Keys, see DP-RTC3022, or ...

Light Bulb 12V 1.2W Capless Various Uses

Ignition Contact Points Fixed Red for Lucas 45D Distributor 1976-84Use this if you have Upgraded to the later 45D Distributor.

Interior Switched Dome Light For Defender from VIN: MA939976 (1996). Note: This Requires Bulb LB-586438 (linked below left). For Mounting Bracket s...

Knob Thumb Screw for Fuse Box Cover Under Dash DefenderTypically 2 needed...

Ignition Contact Points for Ducellier Distributor Series 3

Metal 20 litre jerry can holder. (can not included)