Aftermarket

Oil Seal for the Output Shaft, Front or Rear, on the LT230 Transfer Case. For Defender, Discovery 1 and Range Rover Classic.

Prop Shaft Nut Special Tool 1/2" Drive. Because regular sockets just don't fit... For Series, Defender, Discovery 1 and 2, Range Rover Classic and ...

WE CAN NOT SHIP PAINT OUTSIDE OF CANADA Paintman Paints Limestone Land Rover Series and early 90s and 110s, 1959 to 1984. 500ml can.  Mainly used o...

Gasket for TD5 Turbo to Manifold. For Defender, and Discovery 2 with the TD5 engine. OEM ELRING, Made in the UK.

Gasket Exhaust Manifold to Cylinder Head V8 3.5/3.9/4.0/4.6L (4 Required, 2 Per Side).

Valve Seal (O-Ring Type) for Series 1 1.6 and 2.0L Inlet and Series 2-2a 2.25L Exhaust to 1968. 1.6L from Eng #061106720 on. 2.25L to March 1968 En...

Fuse Box Cover for the Puma Defender, 2007 on

Raptor Steel Instrument Panel Heater Control End Plate. For Defender 1983-06. This is a direct replacement for the poor plastic original LHD End Pa...

Raptor Engineering's Steel Binnacle (Instrument Panel Face), for Left Hand Drive from 1983-2000, (before the TD5 Facelift).This is a direct replace...

Bushing for Front Sway / Anti-Roll Bar Defender HD Susp

Rear body mount 3mm aluminium for All Rear Tubs. Fits Series 2 to 3 and All Defenders but the High Capacity. For the Chassis to Body Nut Plates, se...

Bushing Kit, Lower Link Trailing Arm to Chassis (Pair of SS-NTC9027).For Defender 1983-2016, Discovery 1 1989-1998, Range Rover Classic 1987-1995. ...

Wiring Harness Plug for Lucas Alternator. With 2x 3/8" and 1x 1/4" Female Connectors. For Series 2a and 3, (or earlier dynamo to alternator convers...

Standard Brass Bullet Connector 2.0mm2, 16 to 12 Gauge Wire.Suitable for crimping or soldering.For a Complete Kit of Various Sized Bullet Ends and ...

Standard Brass Bullet Wire End Connector 1.0mm2, 20 to 18 Gauge Wire.Suitable for crimping or soldering.aka: WH-541684.For a Complete Kit of Variou...

Wiper Tube End Piece for Wiper Drive Cable Assembly.For Series 2a and 3 from 1968, Defender to 2016.Supersedes WW-575047.

Cover for Door Check Right Hand Front Door Black.For Defender 1983 on.

Stud for Rocker Valve Cover 2.25L Gas.Series 2 to 2a, 1958 to 71.Note: Not for Series 3. See EP-TE605211L for Engine Prefix 901, 904 and 361, 364 ...

Door Handle Assembly Right Hand with Lock and Keys. Also, for Rear Safari Door. Slam Type Door Handle, Series 2-3. Note: You'll need 1x DP-AFB71025...

Hylomar 101 RTV Silicon Sealant Tube.85 Grams, For Gasketing/Sealing.

Stud 3/8" BSF for Steering Lever on Top of Swivel Housing, (Pendant Type).For Series 1-2a 1950 to February 1962, 1 Required per Side, (2 per Axle)....

Stud 3/8" BSF for Steering Lever on Top of Swivel Housing, (Pendant Type).For Series 1-2a 1950 to February 1962, 3 Required per Side, (6 per Axle)....

Lucas 25D4 Type Points Ignition Distributor for 2.25L Series 2-3. Also Works on the Series 1 2.0L Engine! If you are looking for an Aesthetically I...

Valve Cover Dome Nut for Series 1 to 3, 2.25L Gas and 2.0L Diesel.For a Complete Kit of the Dome Nuts, Washers and Rubber Seals, see EP-DOMEKIT.