Aftermarket

Spherical Bearing Cover for Clutch Cross Shaft and Left-Hand Drive Hand Brake. Series 1 to 3. Typically, 2 Required.

Spacer for Differential Pinion Seal on Salisbury DifferentialAlso known as a Crush Sleeve Series 3 109 Rear and 109 1-Ton Front. Defender 110/130 R...

Speedometer Cable for Right Hand Drive Defender 1-Piece, 1986-2007.For the LHD cable see EP-PRC6021.

Split Ring Retainer for Series Gearbox Layshaft.For Series 1-2a, up to and including Suffix C, 1948-66.

Snap Ring for 2nd and 3rd Mainshaft Gears. Series 1-3 1948-84.Supersedes GT-6402 or GT-06402.

Shock Absorber Kit Standard Oil-Filled Allmakes Pro For Series 1 through 3, 86" and 88", 1954 to 84.For a Kit with new Bolts, Nuts, Washers and Cot...

Replacement Shock Absorber Bushing Standard For 88" Upper and Lower, Front or Rear Shocks, (4 required per Shock)For 109" Upper and Lower of Front ...

Shock Absorber 107 and 109 Heavy-Duty Front with Bushings

Side Marker Bulb 12v 6w Small Bayonet (Lucas 989)

Set of 12 Cylinder Head Bolts for TD5 Engine. Defender and Discovery 2 with TD5 Engine. For a Head Gasket Sets, see EG-DA2112G-EARLY or EG-DA2112G-...

Service Kit for 200Tdi Oil, Air, Fuel Filters, Washers Aftermarket

Set of 4 Bleed Screws and Dust Covers for Wheel Cylinders. Series 1-3

Sensor for Crankshaft TD5 Defender 90/110 Disco 2.  Does not include any wiring.  For wire repair section, see LA-STC1188 (linked below)

Shim for Front Axle Shaft 1.35mm Defender, Discovery 1, and Range Rover Classic

Series 1, 2, and 2a Swivel Pin Railko Conversion Kit, Full Axle Set.Does Both Swivels.For Converting older style Swivel Pin Housing Units to King P...

Front Left Side Defender Seatbelt Reel Assembly.OEM. Fits Defender 90 Station Wagon, 90 and 110 Regular 2-Door Hard Tops and Truck Cabs. Note the L...

Seat Box End Repair Panel Aluminum Right HandSeries 2-3 and Defender

Screw for Fuel Pump Pickup or Return Defender/RRC Steel Tank OEM

Stainless Steel Seal/Mat Retainer for Rear Safari Door Lower Floor Seal, Made in the UK.This is the Later Series 3 and Defender Seal Retainer; earl...

Rubber Grommet Pad for Mounting Radiator, Intercooler, and for Overflow Bottle Mount.For Defender, RRC, and Discovery 1.2 Required for Bottom-Mount...

Rubber Strip for around the Steering Column where the Clamp tightens down.For Series 1-3.

Rubber O-Ring Seal for Bypass Tube, Thermostat to Water Pump.For Series 1 1.6L and 2.0L Gas Engines 1948-58 and 2.6L 6 Cylinder Pump.

Rubber Mount Bushing for Radiator Mounting.Defender, 2.25L Gas, 2.5L Gas, 2.5L NA Diesel, 2.5L Turbo Diesel, 200Tdi, and 3.5 V8; Typically 2-Requir...

Rubber Grommet for Engine Cover TD5.For Defender and Discovery 2 TD5. 3 Required. For the Special Bolt, see EP-LYG000230. For the Flat Washer see B...