Aftermarket

TD5 Defender EGR Blanking Kit with Silicon Hose Kit. Better Mileage. Better performance.

Swivel Housing Repair Kit No Swivel BallFor Defender with ABS, 1999 to 2016.This does One-Side. If you need the Swivel Ball see SC-FTC5366.

Tailgate Antiluce Pins PAIR for Rear Tub Corner Plates Galvanized Kit.Includes Nylock Nuts and Washers.

Stud M8 x 25mm for Exhaust Manifold 300Tdi/TD5 Defender OEM.

Stud for Transfer Case Bottom Cover & Series 1 Inlet Pipe. OEM. Note: You are purchasing 1, not 10 as shown in the photo.

Stud for Water Pump 2.25L Series 2a 1961on. OEM. Note: You are purchasing 1, not 5 as shown in the photo.

Stub Axle Kit for Rear Defender 90 from 1994 on, 110 from VIN: WA769311 (1998on)

Sump Drain Plug for Discovery 2 V8, 300Tdi Eng 16L/23L

Switch for Differential Hi/Low Selection. Fits Defender from VIN: 2A642631, (2002); Discovery 2 from VIN: 3A771055, (2003).For the Earlier Switch, ...

Swivel Hub Seal Retainer 1948 to 1984, Series 1-3.For a Kit with the Seals and Correct Bolts and Nuts, see SC-SOSKITST.

Steering Box Shim Mylar 0.002" for Series 1-3 1956-83Also for RRC Manual Steering Box.See SC-261858 for Steel 0.005" Shim.

Stainless Steel Brake Hose Set Discovery 2 1999-04 ABS

Steering Box Splash Cover for RHD Series 2-3

Spring Rear Standard 86/88" Series 1-3 1954-84 11-Leaf Standard. Used as Left Hand or Right Hand on a LHD 88". This is a Standard Weight Spring, fo...

Striker Pin for Bonnet Catch on Series 2-3, 1958-84Supersedes BP-337969.

Stainless Steel Brake Hose Set +40mm (1.6") Fits: Defender 90 1984-98

Stainless Steel Extended +40mm (1.6") Brake Hose Kit Series 3 88-109"

Stainless Steel Brake Hose Set Defender 110 1983-98

SS Covered Wheel Nut w/Washer for Alloy Rims D2, P38

Stub Axle Kit for Front Defender 90/110/130 from LA (1994) until 2006.

Steering Shaft Indicator Self-Cancelling Ring for Defender

Stainless Steel Slotted Pan-Hd Self-Tap Screws S1 Door Seals

Stainless Steel Screws for Defender Headlamp Panel.4 Screws does 1 Panel - you may need 2 packages.For the Front Grill Screws see FS-DA1138.

Spring for Reverse Stop Gate on Gear Levers (2 Reqd)

Steering Rod Kit for Series 2a to 3, 1962 to 1984 with Greaseable Ends. Complete with Track Rod SC-NRC132 (43-1/8") and Drag Link SC-NRC4609 (28-3/...

Stub Axle. Defender from VIN # LA930456, Discovery 1 from VIN # JA032850, and Range Rover Classic from VIN #. For earlier Defenders, you are likely...

Steering Drag Link with Damper Bracket, (28 3/4") Series 2, 2a, 3.Note on the Damper Bracket. In order to install a Steering Damper Shock, your Cha...

Defender 90/110 Front Stub Axle Kit. Up to 1993 (KA). For later Front models, you are looking for AD-DA3191.

Special Socket Tool for Gearbox Mainshaft Nut Series2-3

Spire Nuts for Floor Screws and Other Uses

Spring for Bonnet Catch RRC, D1, 90/110

Special Stud for Mounting Hard Top Side Panel.For Series 2-3 and Early Land Rover 90/110 to 1986.2 Required per Side Panel.

Special Stud Long UNF for Rover Differential in Axle Case.This is the 3/8" UNF x 1-3/4" Long Push-Through Stud, considered the "Longer" Stud. 6 Typ...

Special Stud Long UNF for Rover Differential in Axle Case.This is the 3/8" UNF x 1-1/4" Long Push-Through Stud, considered the "Shorter" Stud. 4 Ty...

Speedometer Cable Lower for RRC, and All Defender RHD V8 models to VIN:AA267907.

Speedometer Cable for Left Hand Drive Defender from VIN 268017 (1986-2007).For the RHD Cable see EP-PRC6022.

Special Screw for Radiator Fan Cowl Series 2-3

Spire Nut for Defender Front Lamps, Discovery 1 Dash, Series L798 Reverse Light. OEM.

Split (Cotter, Hair) Pin for Door Check Strap Clevis Pin, LT230 Transfer Case, & Other Uses5/16" Diameter by 1-3/16" LongFor Defender Door Chec...

Special Bolt for 4WD Selector Shaft Series 1-3

Speedometer Drive Gear 22 Teeth, Yellow Def/D1/RRC Defender 1987-2006. OEM.

Solex 32PBI-2 Carburetor Service Kit 1.6/2.0L Series 1

Replacement Shock Absorber Bushing, Standard For Lower Front or Rear Shocks 90/109/110 2 Required per Shock.

Replacement Shock Absorber Bushing Set, Polyurethane Yellow.For 88" Upper and Lower, Front or Rear Shocks, (1 Set required per Shock).For 109" Uppe...

Shock Absorber Rear 109" 1-Ton w/Bushings

Shock Absorber - Series 2-3 109" Heavy Duty Rear Includes Bushings

Set Screw Metric M8 x 40mm Pan-Head For Bonnet Buffer Defender, OEM You are purchasing 1 screw not 10 as shown