Aftermarket

Intake to Exhaust Manifold Stud Kit (Studs, Locks, Nuts, and Gasket),For Mounting the Intake Manifold to the Exhaust Manifold on Series 2-3 Gas Eng...

Spring for Hand Brake Relay/Expander Return 1954-84

Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.

Screw for Fastening Speedometer Cable to Gearbox2BA x 1/4". Series 1-3. Typically 3 Required. You may need the Lock Washer, FS-WM702001L.NOTE: You ...

Prop Shaft Rubber Gator and Clamps. All Series trucks and Early Defenders. For a Pair of these, see AP-276484PR (linked below left) For the later D...

Get the job done in our vintage inspired Land Rover shop jacket, a timeless design built to last. This utilitarian staple is perfectly engineered f...

Made from heavy-duty water-resistant nylon this shoulder bag features two embroidered and three felt appliqué patches. Felt appliqué with embroider...

Our vintage Land Rover ‘Field Service Kit’ is constructed in durable nylon with webbing straps, 2 layer felt appliqué LR Badge and two woven patche...

Hinge Bushing for Hood (Bonnet),For Series 2a-3, 1972 on, Defender through to 2016,

Heater/Defrost Hose Kit for Kodiak 2/3 Series 2a-3. Clamps Included. These Hoses are the real thing; neoprene rubber over fiberglass re-enforced te...

Hub Bearing and Oil Seal Kit Defender.Fits both Front and Rear from 1994 onwards.Note: The Kit DOES NOT Include Thrust Washer /Key Washer AD-FTC318...

Grommet for Bell Housing Clutch Shaft Series 1-2a 1952-67 Up to Gearbox Suffix D April 1967. For the later Grommet, see BG-553262 (linked below).

Handbrake Grommet (Boot) Late Series 2a and Series 3, 1967-84. Hole is Oval Shaped for Handbrake Lever. Can work on Series 2 to 2A models, 1958-66,...

Glass Fuse 35AMP 17AMP Continuous for Series 1-3 OEM

Gasket for Thermostat Housing, Lower.Series 2-3 from 1958 to 1984.

Engine Mounting Rubber with Nuts.For Series 2, 2a, 3 Engines, 2.25L and 2.6L, 1958-84.

Exhaust Manifold for 2.25L 4 Cylinder Gas, Series 2a-3, 1961-1984. Can be used to replace Series 2, 2.25L Gooseneck Exhaust Manifold and Front P...

Delphi AP Brake Pad Set Front. Defender 110 and 130 1986on. Defender 90 with Solid Rotors from 1991 to 2016. Defender 90 with Vented Rotors from 19...

Cunifer Pipe Reservoir to Brake Master Cylinder, 88 and 109, 1958-67. Copper-Nickel 1/4" pipe for use on; Series 2 and 2a, 88" SWB or 109" LWB, f...

Castle Nut for Halfshaft, Output Shaft and Differential Pinion.Requires Cotter Pin AD-PS608101L and Flat Washer AD-571922.

Brake Drum 10" Series 1 to 2A 1948-1969. 80", 86", and 88" Front and Rear. Series 1 107" with 10" Brakes.Note: Holes are 0.581", (a bit larger than...

Voltage Regulator for Instrument Panel Series 2-3 1961-84

Wheel Cylinder Left Hand for Rear 10" Brakes.For Series 1, 2, 2a and 3, 86" and 88" 1954 to June 1980.

Weber 34 ICH Carburetor Service Kit for Series 2a-3