Aftermarket

Heater Core for Smiths Heater Box Series 2a/3 1968-84.This is for the two piece Smiths heater, not for the Kodiak heater.

Heater Blower Motor Suitable for Smiths Round HeaterFor Series 1 to early 2a.Note: There were many variations of the Smiths Round Heaters; shorteni...

Grommet for Demister Tube Through the Dash.For Defenders up to 2006.

Heater Hose Inlet for Tdi Discovery 1

Heater Hose Outlet Tdi Discovery 1 to LA081991

Grab-Handles for Rear Cross Member Black Aluminium PAIR

Hand Brake Expander Locking Clip, Outer.For Series 2a-3, (1964-84), Defender to VIN: LA935629 (1993), Discovery 1, and RRC to VIN: LA647644 (1993)....

Hand Brake Expander Locking Clip, Inner. For Series 2a-3, (1964-84), Defender to VIN: LA935629 (1993), Discovery 1, and RRC to VIN: LA647644 (1993)...

Hand Brake Expander Locking Clip, Center.For Series 2a-3, (1964-84), Defender to VIN: LA935629 (1993), Discovery 1, and RRC to VIN: LA647644 (1993)...

Gasket Set for Bottom End 300Tdi (no Rear Crank Seal) Made in the UK. No Oil Pan Gasket -Use RTV Sealant, TL-RTC3254 (linked below left). Includes ...

Gasket for Front Output Bearing Retainer on Transfer CaseSeries 1-3, 1951-84Supersedes EG-234525

Gearbox Cross Member for 109" LWB Chassis Series 2-3Weld-On.Or you could fab up some brackets to make this a bolt-on.Made in Great Britain.

Gasket Set for Solex Zenith Stromberg 175CD CarburetorFor 2.6L 6Cyl and 3.5L V8

Gearbox Cross Member for 88" SWB Chassis Series 2-3

Gasket for Fuel Connector Block TD5 from '02 Defender and Discovery 2 TD5 from Engine 10P 15968B, roughly 2002.For use with EF-LR016318 3-Pipe Fuel...

Gasket for Inlet Manifold, Upper to Lower, 4.0L/4.6L 1999on

Girling Repair Kit for Hand Brake Expander Series 2a-3 1961-84 For Repairing Internals of BB-515366 Handbrake Expander. New Old Stock

Glass for Front Door Top Fixed Front.Fits left or Right Hand for Series 2-3, 1958-68.

Gearbox Filler Taper Plug (also for 2.6L Water Pump)

Gasket (Paper) for Gearbox Top Inspection Plate Series 3. Note: You are purchasing 1, not 10 as shown in the photo.

Gasket Cork for Transfer Case Inspection Plate Series 1-3. Supercedes part number 219995.

Gasket Set for Bottom-End 2.25L Diesel, 1962-84.If you are taking on a complete engine overhaul... a) good for you, and b) use this with EG-STC1564...

Head Gasket Set for Top Overhaul 2.25L Diesel.Series 2a-3 1962-84.If you are taking on a complete engine overhaul... a) good for you, and b) use th...

Frost Core Plug Cup for Cylinder Block 1-3/4" DiameterVarious uses.

Frost Core Plug Cup 1-3/8" Various Applications. (Front/Rear Plugs)

Frost Core Plug Push-In Cup 11/16" for Cylinder HeadSeries 3 2.25L Gas 1972on, and 2.5L Gas Defender

Revolutionize the way you secure loads to your vehicle. The Stratchit is the ultimate tie down with stretchy ratcheting performance in a lightweigh...

These steel tie down rings can be used to attach just about anything to the top, sides or bottom of your Front Runner Rack. Galvanized steel, powde...

Fuel Pipe from Pump to Early Zenith Carburetor 1969-72 This is only for the early Zenith Carburetors with the Female Nut and Olive on the Carbureto...

Fuel Filler Cap Non-Locking Vented 2-Lug OEM See EF-STC4072 for Locking Version (linked below left). Not for NAS 1993-97 Defenders, see EF-ESR2872 ...

Fuel Filler Cap Non-Locking No LeashFor Discovery 1 V8, Defender V8, and Defender 1999on

Fuel Pump for Defender 90 TD5 1998-07

Fuel Pump Glass Sediment Bowl Retainer Clip

Front Right-Hand Wing Top Only for Defender Tdi or Earlier

Fuel Pipe Tank to Pump 109 Station Wagon Series 2-3. Rear Tank. For the Fuel Line that runs from the Pump to the Carburetor, see EF-557432, (for So...

Fuel Tank Gas or Diesel Rear for 109 Station Wagon 72on, 109 Regular 2-Door Aug 1974 on.Earlier Tanks are no longer available. To fit this on earli...

Front Vent Hinge Pin for Welded On Hinges 4 Typically Required. Series 2-3 and Defender up to 1998. OEM. For a Stainless Steel Pin Kit see BP-DA117...

Fusible Link 40Amp Green Defender

Fuel Tank Outrigger LH for Spare Fuel Tank on 88" SWB

Fuel Filter for Series 3, LR 90/110 Gas, on Bulkhead or Rail For Series 3 2.25L Gas on Bulkhead, and Early Defender V8 & 2.5L Gas. For 2.25L, 2...

Front Exhaust Pipe Diesel 88&109" 08/74 to 84. Please note that a $40 handling surcharge applies to this purchase.  Please select the surcharge...

Flexible Fuel Pipe Pump to Pipe on Carburetor.For Series 1 1954-58.

Foam Gaskets for 3mm Premium Wing Top Protectors 2007on

Front Left-Hand Wing Top Only for Defender Tdi or Earlier

Floorboard Panel Right Hand Front for Defender 300Tdi, TD5, and V8.

Front Bumper Defender 90/110 Galvanized No End Holes. For stainless steel bumper bolt kit see BN-DA1139, and for stainless steel bumper bolt kit wi...

Front Exhaust Down Pipe 90/110 200Tdi up to 1995. *Note: a $40 surcharge for additional packaging will apply to this sale. Please add the surcharge...

Front Door Bottom Weather Strip Rivet-On Defender 1994-05, Left or Right Hand.Rivets to Door Bottom. From VIN LA933877 to 5A696476 (1994 to 2005 MY...