Aftermarket

Rear Crankshaft Oil Seal Kit with Retainer Halves Fits,Series 1 and 2 2.0L Diesel, 1957-59.Series 2, 2a, and 3 3 Bearing 2.25L Engine, 1958-84.Ser...

Pedal Pad for Brake or Clutch Defender 87on (frm AA234188)

Oil Seal, Front or Rear Output Shaft on Transfer Case of transmission, Series 1-3, 1948-1984.Fits every single Series truck. Keep it simple.

Brake Spring, Lower for 10" Shoes. For use on: Series 1 to 3, Front 80", 86", 88", and 107" with 10" Front Brakes up to June 1980. Series 1 to 3 Re...

Ignition Condenser for Series 1-3, 1954-76.For the 2.0L, 2.25L 4 Cylinder, and the 2.6L 6 Cylinder.

Hand Brake Expander Dust Cover for Series 2a and 3; 1964on. Also happens to fit Land Rover 90's, 110's, Discovery 1's, and Range Rover Classics... ...

Gasket for Bottom of Transfer Case Series 1-3 1948-84

Gasket for Fuel Pump to Engine Block 2.25L Gas/Dsl S 2-3

Distributor Cap for 2.25L 4 Cylinder 1967-74 up to Series 3 Engine Suffix C, 25D4 Distributor.Can be Used In Place of Earlier EE-600328 Screw-In Ty...

Carburetor Zenith 361V Replacement Series 2a-3 2.25L April 1967 to 1984.Note: To replace a Solex Carb on an earlier 2 or 2a, you are going to need ...

Master Brake Cylinder CV-Type.For Series 2A 88" Short Wheel Base No-Servo Single-Line 1964-84.Also, the Clutch Master Cylinder for Series 2-2a, 195...

Brake Adjuster Kit.Contains Parts to do 4 Adjusters. Does both Axles for 80"/86"/88" from 1948 up to June 1980. 6 Adjusters required for 88" from J...

Brake Kit Rear Axle Set, 4 Cylinder, SWB 88", up to June '80 Kit includes; 1x STC2796 10" brake shoes axle set 1x 243302 right wheel cylinder, 1x...

Set of 3 Replacement Rubber Pedal Pads, (Clutch, Brake, Accelerator/Gas/Diesel) Series 2, 2a, and 3; 1958-84.

Zenith 361V Carburetor Overhaul Kit 4Cyl Series 2a-3 frm 1968

Wing Mirror Round 4 1/2" with Standard 6" Arm - PAIR.For Series 1 - 3

Water Pump Assembly Series 2A to 3, 2.25L. Gas or Diesel Engine, 9-Hole Pump with the Gasket. Note: This Does Not Fit the 1958 to 61 Series 2 Engin...

Shock Absorber Kit 86/88" Standard Pro Oil Front and Rear.With Bolts, Nuts, Fasteners. Everything Needed to Install.

Smiths/Jaeger Speedometer Assembly KPH for Series 1-2a, 1954-67.Calibrated for 88" or 109" using 16" Tires, (7.50x16 or 235/85 r16, 880 TPKM). Kilo...

Radiator Hose Kit for late Series 2A and Series 3 (1968-1984) with the clamps. For 2.25L Gas or Diesel. Also Required if replacing your Radiator wi...

Prop Shaft Rubber Gator and Clamps. All Series trucks and Early Defenders. For a Pair of these, see AP-276484PR (linked below left) For the later D...

Locker for Stub Axle to Swivel Housing and Rear Brake Back Plate for every Series Truck.Supersedes AD-232416.

Hub Cap Black Defender from 1994, Discovery 1, and RRC from 1986.

Gasket for Inlet Manifold to Phenolic Block and Block to Carburetor or Adapter. For Series 2-3, 1958-84 Two Required for Solex Carburetor, Two Requ...