Aftermarket

Defender Tailgate Assembly with Hinges, Brackets and Latch Eyes. Has the Cable Retention Brackets. For earlier Series Chain Retention type of Tailg...

Dayco Timing Belt for 2.5NA & 2.5TD

Cylinder Head Complete 300Tdi with Valves and Head Bolts. This head has additional waterways for improved cooling. Use a Multi-Leaf Metal Head Gask...

Crankshaft Damper Pulley for TD5 Defender and Discovery 2 with the TD5Recommended that you also replace the Bolt, EP-LYG101190 (linked below).

Fan Belt for Rover 3.5L V8 w/o AC, w/o PAS

Dayco Belt for A/C Compressor on 300Tdi D1, RRC, Defender

Cup Washer for Instrument Panel to Cowl 90/110. OEM. Note: You are purchasing 1, not 10 as shown in the photo

Defrost Demister Vent Dash Top Cover.For Series 3, 1975 to 84.These are 10.75" wide, adaptable for the early Defender vents, (to 1988), HS-MTC6040,...

Defender - A Celebration of the Best 4 x 4 Vol 2 From the team at Land Rover Monthly, this 228 page magbook celebrates the Defender including vehic...

Series 2a-3 109" LHD Dual-Line w/Valve 1970-80 All Pipes in this kit are 3/16" Copper-Nickel with UNF Brass Fittings. Dual Line System with Propo...

Series 2 88" LHD 1958-1961All Pipes in this kit are 3/16" Copper-Nickel with UNF Brass Fittings.Includes Plastic Pipe Stand-Offs, (PN: BC-CRC1250L)...

CV-Joint for Defender 1994 - 2006, Discovery 1 w/ABS, RRC 1992 onwards. 24 splines to the drive flange, 32 splines towards the driveshaft

Clutch Repair Kit Cover and Plate For Defender Puma 2007-16, 2.4 and 2.2 TDCi. Supersedes CC-LR117128, CC-LR048731, CC-LR037956.

Accelerator Control Rod Cross Shaft to Engine Ball-Joint TypeFor 1958 Series 2 with the 2.0L Spreadbore Engine.Threaded 2BA, 2-3/8" Long.See EF-AAU...

Clutch Plate for TD5 Defender, Discovery 2

Connector Assembly Fuel Regulator TD5 from 2002 This is a 3-Pipe unit for Defender TD5 from VIN 2A622434, and Discovery 2 TD5 from VIN 2A736340. Re...

Connecting Rod Assembly 2.25L Diesel Series 2a through to early Land Rover 90 and 110

Copper-Nickel Brake Pipe Set Defender 110 CSW LHD w/ABS 1992-2003

Copper-Nickel Brake Line Set Defender 110 1988-91 To Vin HA901219 LHD

Series 1 80" LHD 1948-1953All Pipes in this kit are 1/4" Copper-Nickel with UNF Brass Fittings.For Rubber-Lined P-Clips see PN's: BC-56666 and BC-6...

Connecting Rod Big End Bearing Set .010 Thou Over.For 2.5L Naturally Aspirated Diesel, 2.5L Turbo Diesel, 200Tdi, and 300Tdi.OEM King.

Clutch Slave Cylinder for Defender and Discovery 2.300Tdi from Gearbox 56A0669087K (1999)TD5 up to 2007

Clutch Plate Standard Duty Defender 2.5NA, 2.5TD, 200Tdi and 300Tdi.

Clutch Slave Repair Kit RRC 70-94, D1 89-94, 90/110, LT77

Connecting Tube for Clutch Throw Out Cross Shaft.For Series 2 to 2a.

Clip for Clutch Release Throw-Out Lever S3, Def, RRCto'94, D1

Complete Floor Bolt Kit for Series 1 1954-58 86/88/107/109"

Clutch Pedal Pivot Bushing on the Clutch Pedal Spring, CC-EDP7510L (linked below).For Defender 1994 onwards.

Connecting Rod Bolt for most 2.5L Engines upto 1998 (300Tdi) OEM Note: You are purchasing 1, not 4 as shown in the photo.

Connecting Rod Nut for most 2.5L Engines upto 1998 (300Tdi) OEM

Connecting Rod Big End Bearing Set .020 US 2.25L Gas/Diesel 1961-84.For Series 2a to 3.Note: Does not fit the Series 2 (1958-61) Engine.

Connecting Rod Big End Bearing Set .020 Thou Over.For 2.5L Naturally Aspirated Diesel, 2.5L Turbo Diesel, 200Tdi, and 300Tdi.OEM King.

Connecting Rod "Big End" Bearing Set .010 US.1955-58 Series 1 2.0L Spreadbore Engine.New Old Stock.

Connecting Rod Bearing Set .040 US.Series 1 1955-58 2.0L Gas Spreadbore Engine.New Old Stock.

Clip for Clevis Pin Various Uses, Gearbox, Handbrake, LT230

Control Cable for Heater Outlet Main Air Valve. Actuated when turning on the Blower.For Defender to VIN: 2A633474, 2002.For later see HS-JFF000140 ...

Complete Front Wiper Arm/Blade Kit for Defender LHD 1983-01.Includes 2 Wiper Arms, 2 Sprung Blades, 2 Adapters for Wiper Arms, and a Hex Key for th...

Exhaust System for Series 1 107/109" 2.0L 1954-58. Right Exit Tailpipe. This kit fits: Series 1, LWB 107" or 109" all Gas or Diesel models 1954 to ...

Clutch Release Bearing. Series 3, 71-84, Defender, Range Rover Classic, Discovery 1,

Complete Service Kit Ducellier Ignition Some Series 3's.Includes; ES-RTC3184 Oil Filter, EF-606168 Fuel Filter (in-line), 4x EE-RTC3570 Spark Plugs...

Complete Service Kit Lucas Sliding Points Late Series 3.Includes; ES-RTC3184 Oil Filter, EF-606168 Fuel Filter (in-line), 4x EE-RTC3570 Spark Plugs...

C-Post 45 Degree Repair Section 2-Piece Left Hand.For Defender or Series 2-3, 4 Door Crew Cab or 5 Door Station Wagon.Note: This is for Push On Typ...

C-Post 45 Degree Repair Section 2-Piece Right Hand.For Defender or Series 2-3, 4 Door Crew Cab or 5 Door Station Wagon.Note: This is for Push On Ty...

Channel for Door Check Strap LH Defender from 1987on

Channel for Door Check Strap RH Defender from 1987on

Center Muffler Twin Pipe RRC 3.5L V8 From Eng Suff F

Series 1-3 109" Extended w/BushingsPerfect for Parabolic Springs!Uses a Cellular Foam insert instead of Nitrogen Gas or Air. Allows for 50% more Oil.

Clamp for Exhaust Front Down Pipe Defender 2.5TD and 200Tdi.