Aftermarket

Exhaust Manifold Stud Kit (3 Studs, locks, & brass nuts) 2.25L Gas 61-84 For Mounting Down Pipe to Manifold. (These are included in the Comple...

Exhaust Hanger Bracket Kit (3 Brackets) for Left Exit System 86/88" 1954-84 Pre-assembled, ready to bolt into position. Please check your chassis f...

This is a rubberized end cap for the Defender's front bumper.Fits either side on the standard bumper starting in 1984 all the way through the end o...

Cylinder Block Freeze Plug KitFor Series 2a-3 2.25L Gas or Diesel and Defender 2.5L Gas or Naturally Aspirated Diesel.Note: for Series 3 1972on 2.2...

Copper-Nickel Pipe, (will not rust), with Brass Fittings for use on;Series 2 and 2a, 1958 to 1971 with separate Brake/Clutch Reservoir Canister.1/...

Clutch Release Bearing Series 1 to 2A, 1948-71Used for both 9" and 9-1/2" Clutch. 2.25L and 2.6L NADA.Also used on Front Output of LT230 for Defend...

Service Kit for Series 2A/3 - 1964 onwards with Lucas 25D distributor with fixed points Will not fit vehicles fitted with a Ducellier distributor...

Bulb 12v for Stop/Tail LampFits Series, Defender, Discovery 1, Discovery 2, RRC, and RR P38

Axle U-Bolt Rear with NutsFor Series 1-3 86/88, 107/109 to end of 2a, Rover Axle4 Required.

9.5" Clutch Plate Optional 1964-71, Standard 1970-84 Late 2A, Series 3 Optional 9.5" Clutch used on NADA Gas/Dsl 88 and 109, 1964-71. Standard on D...

If your fuel cooler starts leaking on your Td5 Defender (or imported Discovery) this kit can be an economical fix may save you from replacing the e...

Oil Pan Sump Drain Plug for 2.0L and 2.25L Engines. Series 1-3. 3/8" BSF Thread. Supersedes EP-3088. You May Require the Copper Seal, CS-243959 (li...

Wiring Bullet Kit with 175 Brass Bullets, (4 sizes, 1.0mm 24 Gauge, to 3.0mm 8 Gauge, crimp or solder), and 50 Single and 25 Double Connectors. All...

Badge "Defender" Rear Raised Lettering Gloss Black. Similar to DB-DAH500360MBJ but Raised Gloss Black Lettering and Underline Swipe. Self-Adhesive....

Rubber Seal for Wiper Spindle.Fits Late Series 2a, (with Single Wiper Motor), Series 3, and Defender to 2002.

O-Ring for Swivel Pin/Steering Levers.For Series 2a-3, 1964-84.

Wiring Harness for Fuel Injection. aka: Injector Wiring Harness.TD5 Defender and Discovery 2.

Front Door Left and Right Hand Hinge Kit with Stainless Steel Fittings, Fits Series 3 and Defender. For a set of Front and Middle Row Door Hinges, ...

Spherical Bearing for Clutch CrossShaft and HandBrake.For Series 2/2a Clutch Cross Shaft and Left Hand Drive HandBrake Lever up to Suff C, (1948-Ap...

Brake and Clutch Pedal Return Spring Series 2/2a, 3-17/32".Note: you are purchasing 1, not 2 as shown on the photo. Typically 2 are required.

Gasket For Front Timing Cover Joint. For Series 1-3, 2.0 Diesel, 2.25L Gas or Diesel, and Defender 2.25L Gas, 2.5L Gas or Naturally Aspirated Diese...

Oil Seal for Swivel HubFits All Defenders, 1983-2016, Discovery 1 from '91, RRC 1987-95.Supersedes SC-FRC2889, SC-LR059968

Gasket for Drive Flange to Hub, Front or Rear. For Defender, Discovery 1, RRC, up to 1993, (VIN: KA930455). For Later, see EG-571752 (linked below).

Nut for Fuel Pipe Union, 5/16" Plastic Fuel Pipe.For Series, Defender, Discovery 1, Range Rover Classic, and RR P38.For the Fuel Pipe Olive, see EF...

Olive for Fuel Pipe Union, 5/16" Plastic Fuel Pipe. For Series, Defender, Discovery 1, Range Rover Classic, and RR P38. For the Fuel Pipe Nut, see ...

Universal Joint Propshaft Defender 90 1983-06, Discovery 1, RRC, Defender 110 2007on.No Greaser.75mm Diameter across the yoke, end of cap to end of...

Cap for Coolant Expansion Tank TD5.For Defender and Discovery 2 with the TD5.

Fitting Kit for Zenith or Weber Carburetor Series 2a-3.

Earth (Ground) Lead Connector for Lucas Bullet Terminals.Connects two wire bullet connectors to ground. Typically connected via small bolt and nut ...

Wiper Wheel Box Late Series 2a-3, Defender to VIN: 1A622423, (2001).Includes Adapter for Splined Wiper Arm.For later Wheel Box see WW-DKU500010.

Wings to Breakfast Radiator Panel Stud Plate Kit For Series 2-3. Galvanized Plates with Stainless Steel Studs, Nuts and Washers.Includes 2x BP-MRC5...

Wing Top Vent Blanking Plate Left Hand for Left Hand Drive Defender.Supersedes BP-MRC9941.Requires 7 screws, not included. See FS-AB608065L.For Rig...

Wing Mirror 4 1/2" Round with Standard 6" Arm - Each.For Series 1-3

Waist Seal Outer Drop Window Front Door.Fits Defender Left or Right Hand Front Doors.For Inner Seal, see SL-MTC8473.Supersedes SL-MTC8474.For 2nd R...

Rubber Washer Seal for Sliding Window Catch on Station Wagon Hard Top Side Panels.For Series 2-3.2 Required per Catch.

Wheel Cylinder Right Hand Front 86/88" Rear 107/109",Fits Front 10" Brakes on Series 1 to 3 86" and 88", 1954 to June 1980,Rear 10" Brakes on Serie...

Tie Rod End for Track Rod, Drag Link or Longitudinal Tube.Left Hand Thread Series 3 1974-84 Threaded Shoulder.

Tie Rod End for Track Rod, Drag Link or Longitudinal Tube.Right Hand Thread Series 3 1974-84 Threaded Shoulder.

Bell Crank Rod Assembly Lever to Carburetor Series 2a-3 2.25L March 1963on and 2.6L.Final Connection to Solex, Zenith and Weber Carburetors.

Terrafirma Heavy Duty Steering Arms with 3 Track Rod Ends.Fits; Defender 90/110/130

Switch for Side and Head Lights or Smiths Heater Fan Switch.For Series 2a-3, 1967-84.Lucas 31788 Pattern.For Earlier Series Ignition / Headlamp Swi...

Stainless Steel Antiluce Pin Kit for TailgateFor Series and Defender.Shiny Pair.

Steering Damper for Defender 90/110/130 1984-2016

Steering Rod Kit for Series 2a to 3, 1962 to 1984.Complete with Track Rod SC-NRC132 (43-1/8") and Drag Link SC-NRC4609 (28-3/4"), 2 Left and 2 Righ...

The Iconic and Classic front bumper for all Land Rover 90/110 and Defenders from 1984 through 2016. Has predrilled end holes for fitting optional e...

Side Step Folding Kit for Defender 90, 110, 130, LH or RH

Side Repeater Light Assembly (LH or RH) Defender TD5 1999on Discovery 2

Set of 4 Original Door Hinge Pin Kits for Series 2 and 2a. Slotted Screw Head and Lock Tab Washer. For Series 2 to 3. Does Two Hinges. For Stainles...