New products

Raptor Engineering Defender Rear Cowl Instrument Panel Mount. Steel Replacement that fits both Left- and Right-Hand Drive Defender to 2006. No More...

Raptor Engineering's Steel Binnacle (Instrument Panel Face), for Left Hand Drive from 2000 to 2006, (after the TD5 Facelift).This is a direct repla...

Raptor Engineering's Steel Binnacle (Instrument Panel Face), for Right Hand Drive 1983-2000. This is a direct replacement for the poor plastic orig...

Raptor Engineering's Steel Binnacle (Instrument Panel Face), for Right Hand Drive 2000 to 2006. This is a direct replacement for the poor plastic o...

Instrument Panel Rear Cowl Aluminium. No More Broken Bits of Plastic! Fits Defender Right Hand Drive and Left-Hand Drive without A/C, (with upper b...

Instrument Panel Rear Cowl Defender Right Hand Drive and LHD without In-Dash Factory AC, 1983 to 2006. Typically broken when taking the dash apart....

Instrument Panel Facia Defender Left Hand Drive from 1983 to '98, (up to VIN: WA159806), Plastic. For Later see BE-YAF100090 (linked below left). F...

Gasket for Steering Box Side Plate.Fits Series 1-3 1956-84.Supersedes SC-261880.For a Steering Box Rebuild Kit see SC-DA1236.

Bolt 1/4"-28 UNF x 1 1/2" Hex Cap Bolt Grade 5 Zinc

Bulkhead to Windscreen/Windshield Seal Series 2-3, Defender to 2006.Supersedes SL-330877, SL-395430, SL-395431, SL-ALR1737, SL-ALR5058, SL-MTC6959F...

Timing Chain Gear for Crankshaft.Fits Series 1 2.0L Diesel, Series and Defender 2.25L Gas or Diesel, and Defender 2.5L Gas.For the Woodruff Key, se...

Bushing for Front Sway / Anti-Roll Bar Defender HD Susp

Battery Hold-Down J-Clamp Kit

Gearbox Case and Top Cover for Series 3 Gearbox Suffix B onwards.Fits Series 3, 4 and 6 Cylinder, Gas or Diesel, from roughly September 1972.New Ol...

Heater Core with Pipes for Defender Puma Right Hand Drive, 2007-16. Land Rover Genuine. For the Heater Core Only, see HS-DA3860 (linked below left)...

Heater Core with Pipes for Defender Puma Left Hand Drive, 2007-16. Land Rover Genuine. For the Heater Core Only, see HS-DA3860 (linked below left)....

Heater Core for Defender Puma 2007 to 2016. Fits Left or Right Hand Drive. No Pipes. Made in the UK. For Heater Core with Pipes, see HS-LR020952LR ...

Fuel Tank Mounting Kit for Defender 90 1987-98. Front Side Tank.

Fuel Tank Mounting Kit for Defender 110 and 130 1987-98.

A-Frame Nudge Bar for Defender.Quality made Black Rubber A-Frame. Mounting Hardware, Fasteners and spot light brackets included. For Defenders with...

Looking for the perfect gift for the Landy lover in your life? Or need a way to say thanks to a friend who's lent a helping hand? Look no further, ...

Nut for Steering Drop Arm on Adwest Lightweight Steering Box.For Defender, Discovery 1 and Range Rover Classic.For the Tab Lock Washer, see SC-6002...

Tab Lock Washer for Steering Drop Arm 48mm Adwest Steering Box.Defender 1983-2016. Alternate to SC-STC874. Measure before you buy please.

Tab Lock Washer 60mm for Steering Drop Arm Adwest.For Discovery 1 1989-98, Range Rover Classic 1992-94 and Some Defenders. Alternate to SC-600265. ...

YRM Rear Row Forward Facing Seat Conversion Kit for Defender 90 to 2006.Complete Kit with HD Galvanized Seat Sub-Frames, Aluminium Forward Facing S...

Seat Box Repair Rear Angle Piece With Holes for Series 2-3.

Seat Box Repair Back Angle (Blank No Holes) for Defender and Series 2 to 3.

Rear Body Support (Top Hat) Series 2-3 109 Regular, Defender 110 Hardtop/Regular 2 or 3 Door.Typically 3 Required.

Rear Body Support (Top Hat) for Under Tub FloorFor Series 2-3 109 Station Wagon, Defender 110 Station Wagon.Typically 3 Required.

Rear Body Support (Top Hat) for Under Tub Floor. For Series 2-3 88", Defender 90. Typically, 3 Required.

Rear Floor Support 3mm Aluminium. Lower Tailgate at Floor.For Series 2 to 3 and All Defenders but the High-Capacity.Made in the UK.

Under Seat Tool Box for Center Seat. Aluminium.For Series 2-3, 1958-84.Note: If you have an Over-Drive installed, this may not fit. Does Not Fit 6 ...

Rear body mount 3mm aluminium for All Rear Tubs. Fits Series 2 to 3 and All Defenders but the High Capacity. For the Chassis to Body Nut Plates, se...

Temperature Sender Unit for 300Tdi Defender BlackTop.Located in the Thermostat Housing. For the Thermostat Sender for the Discovery/RRC 300Tdi, see...

Introducing our very own Green Lane roasted coffee. Keep yourself caffeinated in the shop, or in the kitchen. Green Lane is a medium bodied roast...

Copper-Nickel Pipe Front Right or Left Cylinder to Hose.For Series 3 88" to June 1980.