New products

Connecting Rod Big End Bearing Set .040 US 2.25L Gas/Diesel 1961-84. For Series 2a to 3. Note: Does not fit the Series 2 (1958-61) Engine.

Terrafirma De-cat Down Pipe for Defender Puma 2.4L   *Note: a $40 surcharge for additional packaging will apply to this sale. Please add the surcha...

Fuel sender unit 110 V8 gas rear tank w/low fuel warning.

Upper lefthand side panel seal for Defender 110, regular hardtop from 1987 onward. 

 Upper righthand side panel seal for Defender 110, regular hardtop from 1987 onward. 

Safety Catch Assembly for Cable Release Type Bonnet Defender

Cork gasket for the valve cover on the European 2.6L 6 cylinder engines in the Series 2a and Series 3.  Not for the Westlake head in the NADAs.  If...

This is a crushable copper seal/washer. 16mm It has had many uses in different trucks over the years, including as a fuel tank drain plug, a radiat...

Top rocker valve cover gasket for the 6 cylinder 2.6L Westlake NADA

Washer for Swivel Housing Plain M10 Defender, RRC, D1

Galvanized Body Support Bracket for Defender 110/130 Strengthen the structure of your Defender with this galvanized body support bracket, designed ...

Thermostat 88 Degree C for 3.5L, 3.9, 4.0L and 4.2L V8. Land Rover Genuine. For Discovery 1, Range Rover Classic, and Defender. You'll need gasket ...

Rubber Boot for Wiper Motor on Late Series 2a

Black Wheel Nut for Steel Wheels - D2/P38 SPECIAL ORDER: Please note this item is special order and there will be a substantial passage of time bet...

These are black steelies for the Discovery 2 or the Range Rover P38. 8" x 16", ET25 offset. SPECIAL ORDER: Please note this item is special order a...

Drain tap coolant valve for cylinder block or original radiator, (will not fit new replacement radiators EC-577609). Sometimes referred to as a pet...

Front Crank Oil Seal Outer for 300Tdi from VA560898

NKG Spark Plug Cover with Resistor for Copper Core Wires

HT Ignition Lead Cable (Copper Core) Series 1, 48-1958. Sold by the Metre. Requires appropriate Split Brass Washers, EE-214279 and the Acorn Nuts, ...

Gasket for Coolant Outlet Elbow, TD5, OEM

Shim for Swivel Pin .003" 1948-1967

Shim for Swivel Pin .030" 1948-1967

This is the handbrake drum for all Defenders to 2016, Discovery 1 and 2, as well as the Range Rover Classic.

Bolt for Rear Radius Arm Bottom Link to Rear Axle for Defender. 5/8" UNF x 4" Hex. For a Complete Kit of Rear Suspension Bolts, see SS-DA7201 up to...

High note horn for your 1998 and onward Defender. The older-style horns used a twin Lucar (spade) connector. This newer series use a plug-style con...

Low note horn for your 1998 and onward Defender. The older-style horns used a twin Lucar (spade) connector. This newer series use a plug-style conn...

This swivel rebuild kit has all the parts needed to replace your vehicle's swivel ball and swivel ball components for one side. The kit includes: a...

Water Sensor for TD5 Fuel Filter OEM

Defender 90, 110 front door handle button latch link.

Hose from the expansion tank into the radiator.  Fits Defender 90, 110, 130 from 1998-2016.

Valve Cover Gasket for Defender 200Tdi

Early Defender Center Tunnel and Lower Bulkhead Cowl Bolt and Nut Kit.. Fits Defenders up to 2003.

Complete Front Floor Fastener Kit for the Defender.  Includes everthing needed to properly secure the floor as it was done at the factory.

Seal Rivet-On for Door Rear Lower Body LH Series 2-3 OEM

Gasket Gearbox to Transfer Case Series 1-3 1948-84