New products

Chain Galvanized for Tailgate 28mm 20-Links Series/Defender. OEM.

Pulley for Alternator 300Tdi 49mm. For Defender from Engine 16L 25165 onwards, Discovery 1 and Range Rover Classic. Defender requires Serpentine Fa...

Plastic Cap for Seatbelt and Bumper Bolt HeadsFor Defender, Discovery 1 and RRC.

Cotter Pin for Bottom of Shock Absorbers and Other UsesSeries 2-3 OEMAlso used for holding the rear Tailgate hinge in place.

Securon Seat Belt Lap Center or Rear Bench Seat, Retractable.For Series 1-3 or Defender.

Securon 3-Point Static Shoulder BeltFits Left or Right Hand. For Series 1-3.Note: This is a Shoulder Belt requiring the Upper Mount in Hard Tops, T...

Securon Seat Belt Kit 3-Point Reel, Buckle and Hardware.For Left or Right Hand. Series 2-3 or DefenderNote: This is a Shoulder Belt requiring the U...

Lever Assembly Hot/Cold Upper/LowerFor LHD Series 3 and Defender to 2006.Land Rover Genuine

Fuel Pipe from Pump to Early Zenith Carburetor 1969-72 This is only for the early Zenith Carburetors with the Female Nut and Olive on the Carbureto...

Hose Connector for Zenith or Weber Carburetor to Air Cleaner Elbow For Series 2a-3 1968on, or earlier if converted to a Zenith or Weber Carb. If yo...

Bushing for Rear Sway / Anti-Roll BarFor Defender 110 V8 EFI and Defender 90 with the TD5 engine.For the rest of the Defender 110's, see SS-NRC5674...

Pulley for Alternator 300Tdi 61mm. For Defender Up To Engine 16L 25164, (1995), Discovery 1 and Range Rover Classic. Defender requires Serpentine F...

Hose Clamp 1/2" - 1-1/4" Diameter x 1/2" Bandwidth Stainless Various Uses

Thermostat 88 Deg Fahrenheit for 300Tdi. For Defender, Discovery 1, and Range Rover Classic. There is no gasket between the thermostat housing and ...

Hub Oil Seal Series 3 mid-1980on, Defender to '93, RRC to '85.OEM CortecoDefender up to VIN KA930455, (1993), up to Axle No 20L13358B RHS, up to Ax...

Slotted Drain Plug Tool for Series, Defender, and RRC.Uses a 19mm or 3/4" Socket or Wrench.For use on the Slotted Drain Plug, AF-235592.So much eas...

Rubber Seal and Aluminium Channel for Sliding Door Windows, Series 2-3.Used on Front and 2nd Row Doors, Side Sliding Window Panels, and Pick-Up Cab...

Wings to Breakfast Radiator Panel Stud Plate Kit For Series 2-3. Galvanized Plates with Stainless Steel Studs, Nuts and Washers.Includes 2x BP-MRC5...

Cover for High-Mount Brake LampDefender and Discovery LR Genuine

Woodruff Key for Crankshaft Timing Gear and Pulley.For Series 1 2.0L Diesel, Series and Defender 2.25L Gas and Diesel, 2.5L Gas and Naturally Aspir...

Front Crankshaft Pulley for 2.25L 3-Bearing EngineSeries 2a-3 1961-84Gas or Diesel, Single Belt.For Locker Washer see EP-247771 (linked below left)...

Front and Rear Shackles Kit for 109" Series 1-2a 1956-71 You get all 8 Shackle Plates and 12 Shackle Bolts and Nuts.

Coolant Hose Expansion Bleed Pipe Assembly with ValveFor 200/300Tdi, Defender and Discovery 1

Radiator and Intercooler Assembly with Frame For Defender 300Tdi Supersedes EC-ESR3683 SPECIAL ORDER: Please note this item is special order and th...

Delphi AP Brake Pad Set Front Fits Land Rover 110 (1983-86) and Land Rover 127 (1985-6)

Sealant Strip for Side Panel Sliding Window 90/110

Filler Strip Outer for Side Panel Sliding Window on Defenders up to 2001, (VIN: 1A621960).Covers the rivets in the sliding window frame.Length is a...

Polyurethane Bushings Set for Panhard Rod, Black.For Defender up to VIN: 2A626645, (2002), Range Rover Classic and Discovery 1.Equivalent to SS-ANR...

Bonnet Catch Assembly for Series 2-3. OEM. Not for 109 V8 For the Bonnet Striker Plate see BP-332400 (linked below).

Bonnet Striker Plate for Series 2-3.For the Bonnet Catch Assembly, see BP-332401.

Alternator A127 100Amp for 300Tdi with 49mm PulleyFits Defender from Engine 16L 25165, (1996/7), (or Upgrade for Earlier, Note the change in Pulley...

Mud Flaps for Range Rover Classic Front or Rear (No Bracket)

Rear Door Casing/Card Panel w/Wiper Cover BlackDefender to 2002Includes Fasteners

Ball Joint for Self-Levelling Suspension, Defender 110 and RRC

Fulcrum Bracket Fitting Kit (Bolts/Nuts)For the Fulcrum Bracket, (NRC3923), and SS-DA1129, SS-DA1129ADJ, SS-DA1129Ultra Bracket and Ball Joint Kits...

Fulcrum Bracket with High Articulation 45 Degree Top Link Ball Joint. For Defender, Discovery 1, and RRC. This exclusive ball joint offers 45° move...

Gasket for Fuel Pump Side Cover to Engine Block2.25L Engine, Series 2-3

Lucas Original Warning Lamp Assembly Green (Oil) for Series 2/2a Instrument Panel.Note: This does not include the bulb holder or bulb, only the out...

Lucas Original Warning Lamp Assembly Amber (Choke) for Series 2/2a Instrument Panel.Note: This does not include the bulb holder or bulb, only the o...

Lucas Original Warning Lamp Assembly Red (Charge) for Series 2/2a Instrument Panel.Note: This does not include the bulb holder or bulb, only the ou...

Complete Stainless Exhaust System for Series 1 86/88" 2.0L 1954-58 This kit fits: Series 1, SWB 86" or 88" all Gas or Diesel models 1954 to 1958. R...

Ignition Contact Points Fixed Red for Lucas 45D Distributor 1976-84Use this if you have Upgraded to the later 45D Distributor.

Zerostart Temro Lower Radiator Hose Heater 1-1/4" 375Watts.Fits Series 2 2a with original Rad Hoses, (note if car has later Radiator, the hoses wil...

Temro Freeze-Plug Block Heater 400w 120vFits 2.25L 5-Bearing Engine, 2.5L Naturally Aspirated Diesel, 2.5L Turbo Diesel, 200Tdi and 300Tdi.2.06" Di...

Temro Freeze-Plug Engine Heater 400W 120vFits Series 2-3 2.25L Gas or Diesel 3-Bearing Engines. Replaces the Frost/Freeze Core Plug EP-525428. 1-15...

Zerostart Temro Lower Radiator Hose Heater 1-1/2" 600Watts.Fits Late Series 2a and Series 3, (1968-84; or, if you replaced your radiator with the l...

Temro Thread-In Block Heater 125V 400WFor 2.25L 4 Cylinder Gas and Diesel, and 2.6L 6 Cylinder Gas. Series 2-3Fits in the Rear Threaded Core Plug H...

Gasket for Water Pump 300Tdi Defender 90/110