New products

Retaining Clip for Clutch Release Push Rod Series 3 Defender TD5 with R380 Discovery 1 V8 with R380 For LT77 and Tdi/R380 See CC-FRC3327

Lucas R401 Voltage Regulator Series 1, 2 and Early 2A 1948-65.Screw-Type Connectors. For use with Dynamo, (Generator).Supersedes EE-217277, EE-2355...

Clevis Pin with Washer and Cotter Pin for Clutch Cross-Shaft Series 1-2a. For Series 1 to 2a, 1948-71. Supersedes CC-240191.

Bolt Kit for Series 2, 2a and 3, 1969 to 84, Right and Left Hand Mud Shield Splash Guards. Correct Fasteners for Doing Both Sides for LHD and RHD. ...

Fuel Tank Bolt Kit for S2-3 109" Stn Wgn up to Stuff B -1969. Note this kit does not include all parts required. This replaces the bolts, nuts, was...

Set of 3 Replacement Rubber Grommets for Series 2/2a 1958-66. Handbrake, Gear, & Transfer Lever. This Handbrake grommet does not fit Series 1 1...

Service Kit for Td5 Oil, Air, Fuel and Rotor Filters, Washer. Defender or Discovery TD5, 1999 to 2006.

Gasket for Clutch Master Cylinder Series 3, 90/110 OEM

Oil Seal for Clutch Cross-Shaft Series1 RHD and Series 2/2a Left- or Right-Hand Drive; 1948-71. For the Series 1 LHD Oil Seal, see CC-219988 (linke...

Cap for Clutch Release Pivot Pin for R380 TD5 & V8

Clip for Clutch Release 4 Cyl LT77/R380, D1-2.0Mpi

Push Rod for Clutch Slave Cylinder 4-Cylinder with LT77 Gearbox.For Defender, and Discovery 1 to 1994.

Clutch Hose Defender TD5, 90/110 V8, D1, RRC V8

Tailgate Antiluce Pins PAIR for Rear Tub Corner Plates Galvanized Kit.Includes Nylock Nuts and Washers.

Clutch Slave Push Rod for R380 Gearbox.For Defender 300Tdi or TD5 with Gearbox from SN 56A066908K.Discovery 2 with TD5 and R380 OEM.

Clutch Slave CylinderFor Stage 1 V8, LR 90/110 V8 and Defender V8 NAS, with LT77, LT85, and R380 Gearbox.Supersedes CC-UKC8677 and CC-UKC8677L, (No...

Push Rod for Clutch Slave Cylinder Tdi R380, OEM. For Defender up to Gearbox SN 56A0669086K; Earlier uses CC-FRC3417 (linked below left). After use...

Clutch Release Fork for LT77 and R380 4 Cylinder, OEMIncludes the little bits shown in the photo, which you should replace when replacing the clutc...

Tailgate Antiluce Pin for Rear Tub Corner Plates Galvanized OEMYou may need the nut, (it's metric), and washer; see BN-RYH500510 and BN-WA112081L.

Filler Plug for Swivel Housing Series 1-3. Also, for the Transfer Case Oil Level Plug Gearbox Suffix B on; 1/2" BSP.

Washer Flat #10 x 3/4" 18-8 Stainless Steel

Screw Fuel Pipe & Sender to Tank Series 1 3BAx1/2"

Complete Floor Bolt Kit for Series 1 1954-58 86/88/107/109"

Left Hand Anti-Burst Door Handle Assembly (no key barrel)Series 3 and early or military Defenders. For Lock Cylinders and Keys, see DP-RTC3022, or ...

Right Hand Anti-Burst Door Handle Assembly (no key barrel)Series 3 and early or military Defenders. For Lock Cylinders and Keys, see DP-RTC3022, or...

Series 2-3 Side Folding Step.Fits Series 2-3, 1958-84, Left or Right Hand, Front or 2nd Row Doors.For Rear Step, see AO-605934.

Floor Screws and Spire Nuts. Package of 10x FS-320045 and 10x FS-302532

TD5 Fuel Block Regulator Repair Kit for 2 or 3 Pipe Assembly. Note: Does Not include the Fuel Regulator, see EF-BFUELREG. For Complete Assemblies, ...

Bosch Fuel Pressure Regulator for TD5 Defender, Discovery 2.See EF-TD5REGKit for Gaskets and O-Rings required for full rebuild of the Regulator.

Valeo OEM Clutch Kit, Plate, Cover, and Bearing.For the 2.5L Naturally Aspirated Diesel, 2.5L Turbo Diesel, 200Tdi and 300Tdi in a Defender. 200Tdi...

Clutch Kit, Plate, Cover, and Bearing.For the 2.5L Naturally Aspirated Diesel, 2.5L Turbo Diesel, 200Tdi and 300Tdi in a Defender. 200Tdi or 300Tdi...

Complete Floor Bolt Kit 4 Cylinder Series 3 1971-84Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells, (...

Door Sill Rail Channel Left Hand Galvanized. Series 2-3 88/109R (Not 4-Door Station Wagon) Defender 90/110R (Not 4-Door Station Wagon)For Sill Rail...

Door Sill Rail Channel Right Hand Galvanized. Series 2-3 88/109R (Not 4-Door Station Wagon) Defender 90/110R (Not 4-Door Station Wagon)For Sill Rai...

Clutch Slave Cylinder 300Tdi from Gbx 56A, TD5to07, TRW

Clutch Slave for Tdi on R380 Gearbox, OEM TRW. For Defender, Discovery 1, and Range Rover Classic 1992-94. Notes: 300Tdi to Gearbox Serial Number 5...

Clutch Slave for Tdi on R380 Gearbox.For Defender, Discovery 1, and Range Rover Classic 1992-94.Notes: 300Tdi to Gearbox Serial Number 56A0669086K ...

Heavy-Duty Clutch Fork and Install Kit for LT77 and R380 4 Cylinder. Notes: Also includes the Flywheel Bushing. Fits Defender 4 Cylinder to 1998, R...

9.5" Clutch Plate for 1969-1984 (Full Synchro or 2a NADA)

Torsion Spring for Clutch Pedal.For Defender from VIN: LA939892, (1994) on.For the Nylon Bushings required, see CC-DCP3212L. For the Center Plastic...

Nylon Bushing for Clutch Pedal Spring.For Defender from VIN: LA939892 (1994) on.Two typically required.

Valeo OEM Heavy Duty Clutch Kit, Friction Plate, Cover/Pressure Plate, and Bearing.For 200Tdi and 300Tdi Defender, Discovery 1 and Range Rover Clas...

Heavy Duty Clutch Kit, Friction Plate, Cover/Pressure Plate, and Bearing for 200/300Tdi. Pilot or Flywheel Bushing is not included, see GT-LFB50005...

Clutch Friction Plate and Cover/Pressure Plate.For TD5 Defender, and TD5 Discovery 2.OEM Valeo Clutch Kit.Note: No Bearing. See CC-FTC5200. For Fly...

Clutch Kit, Friction Plate, Cover/Pressure Plate, and Bearing for TD5.Fits Defender or Discovery 2 with the TD5 Engine.Note: Flywheel Bushing is no...

Clutch Pedal Assist Kit Spring and BushingsDefender 1994onReplace the old clutch pedal spring kit to assit the pressing of the clutch pedal on Defe...

Clutch Pedal Pivot Bushing on the Clutch Pedal Spring, CC-EDP7510L (linked below).For Defender 1994 onwards.

Backing Plate for Slave Cylinder Mount S3, 90/110, 101FC